Lightolier 6020T User Manual

I

●

READANDUNDERSTANDTfiESE lNSTRUCTfONSBEFOREINSTALLINGFIXTURE

Thisfixtureisintendedfor installation in accordance with the National Electrid Code and local regulations,

To assure full compliance with local codes and regulations, check with your local eiaclrical inspector before
installation. To prevent electrical shock, turn off eleciricdy at fuse box before proceeding.

Retainthese instructions for maintenancereference.

BASIC LYTESPAN TRACK LIGHTING SUPPLEMENT

FOR USE WITH BASIC LYTESPAN TRACK SYSTEMS ONLY

THIS INSTRUCTION SHEET TO BE INCLUDED WITH INSTRUCTION SHEETS:

6020,6046,6046,6049, 6062,6063,6065,6066, 6069

INSTRUCTIONS FOR SELECTING AND PREPARING TRACK CONNECTORS

TO FIT ALTERNATE TRACK DESIGNS

TRACK WITH ROUND CONDUCTORS

ROUND
CONDUCTOR

1

H

FIG.

FIG.

INSTRUCTION SHEET NO.

IS:6020T

1193

Page1of 1

✞

BASIC TRACK SECTION

Use DEAD END

CONDUCTORS. (Fig. 1 &2)

The CONNECTOR must have both SHROUDS in place (Fig. 4)
when used with track with ROUND CONDUCTORS. (Fig. 1 &2)

TRACK WITH “U” SHAPED CONDUCTORS

Use DEAD END shown in Fig. 7 for track with “U” SHAPED
CONDUCTORS. (Fig. 5 &6)

shown in Fig. 3 for track with ROUND

‘U’ SHAPED
CONDUCTOR

H

BASIC TRACK SECTION

FIG. 5

\

\

END

s

=-.

The CONNECTOR must have both SHROUDS cut off (Fig. 8) when
used with track with ‘U’ SHAPED CONDUCTORS. (Fig, 5 &6)

LI<51“1

T<> 1.1 E R“ i%iii,%uyxu:

H

(CutOffFlushwithWall)