Lightolier 302MRIC9X User Manual

Rev : 02
3 3/4" (95mm) aperture Lytecaster
Low Voltage MR16 12V Recessed Downlight
302MRIC9X
MR16 IC Frame-In-Kit
Complete fixture consists of Reflector Trim & Frame-in Kit. Select each separately
POWER PACK CUT-OUT
REFLECTOR TRIM
Trim specification sheets.
Features Accessories
Mounting Frame: 20ga. galvanized steel. Four slots are positioned 90º Mounting Bars Extenders : 1964
apart to simplify alignment. 20" (508mm) long. Set of 2 Insulated ceiling Housing: .018" galvanized steel. CSA certified for direct contact with thermal insulation. Internal thermal cut-out insures against overheating due to incorrect lamping. To lock mounting bars in place after installation. Set of 12. Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend to 27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail eliminates the need of additional nailing. Attaches to wood joist or T-bar without need of Polyvinyl Air Vapour Barrier ; to comply with provincial legislation. For all accessories. non Air-Seal frame-In-Kits. Mounting Bars Locking Clip: (1) locks mounting bars in place. Additional clips are sold separately (0098 set of 12) Socket : Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon 250º leads to junction box. Transformer: Magnetic 50VA, 120 volts primary, nominal 12 volts secondary, class "H". (integral thermal protector) Lightolier Controls dimming system. Low voltage fixtures may produce audible Junction Box: 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel . CSA/UL certified for maximum of 4 No. 12 ga. 90º C through branch circuit conductors. Integral cable clamp permit attachment of non metallic Loomex without need of additional connectors. Pry-out knock-outs accept BX cable. Easy access from both sides with snap-on covers. Damp or Wet location rated depending on trim used. Lamp cover: Aluminum heat deflector for 50W MR16 / 37W MR16 IR or ES/ESD16 dichroic lamps.
Mounting Bar Locking Clips : 0098
Vapor Barrier Extender : VBE300
Dimming
Dimming controls: use only dimmers specifically designed for use with
transformers, like Lightolier Onset, Sunrise series LV or VA dimmers, or any
noise. Attention should be given for noise sensitive applications.
Labels : CSA , UL
WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN, MATERIALS AND FINISH, IN ANY WAY
THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.
Lightolier CFI, 3015 Louis Amos Lachine, (Quebec) H8T 1C4
Loading...