Lightolier 2029, 2027 User Manual

w

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

his

fixtureisintendedforinstallationinaccordancewiththeNationalElectricalCodeandlocalregulations.
Toassurefull compliancewith localcodasandregulations,checkwith yourlocalelectricalinspectorbefora
installation.Topravantelectrical

Retaintheseinstructionsfor maintenancereference.

shock, turn off electricity at fuse box before proceeding.

INSTALLATION PROCEDURE FOR REFLECTOR TRIM 2027 AND 2029 SERIES

IN THE 2000P1, 20001C

1. FRAME-IN

See

Frame-In Kit Instruction Sheet for installation procedure.

2. ROTATE ROTO-CLIPS (Fig. A)

Rotate(3)Roto-Clipssothattheshot legs extend inwardly toward

the center opening.

NOTE: For Reflector Trims: 2005,2008,2010,2012, 2013,

201 3BK, 2013WH use longer legs.

3. TRIMINSTALLATION

A. Insert Socket Spring into slots of Reflector Trim. (Fig. B)

B. Push Reflector Trim straight up until it is tight against ceiling.

C. Lamp fixture with appropriate lamp. (see wattage label)

D. Vertical adjustment can be done by inserting a screwdriver

into slot in leg of l-amp/Yoke, and using the screwdriver as a
lever, tilt the entire Lamp /Yoke to the desired angle. (Fig. C)

E. Horizontal adjustment can be done by rotating Lamp/Yoke to

desired position.

NOTE: To

remove Reflector Trim turn Reflector Trim counter-

clockwise while pulling downward.

AND 2000AIC FRAME-IN KIT

Y

INSTRUCTIONSHEETNO.

IS:2027

R0894 Page1 of1

1-1 c>

FIG. C

H -icm I E R“ f:l:w?fusnl:i