Light Engineered Displays DLC Series User Manual

Page 1
A Division of: Light Engineered Displays, Inc. 109 Portwatch Way Wilmington, N.C. 28412 Phone: (800) 251-2512 Fax: (800) 251-9878 Internet: www.ledinc.com Email: sales@ledinc.com
Models
DLC-50 - Roll of Cable 50’ DLC-100 - Roll of Cable 100’
General Description
The DLC Series water leak detection cable consists of 1/4” diameter, 4 wire, insulated bundle. It is available in two pre-packaged lengths of 50’ and 100’. The cable assembly has factory installed connectors making it easy to connect consecutive sections to achieve the desired length. The DLC cable is very strong and can be pulled into place with­out the risk of damage. The orange color makes it easy to locate in difficult-to-see areas. The special insulation allows the
WATER LEAK
DETECTION CABLE
DLC
SERIES
cable to produce accurate distance readings, regardless of conductivity of the fluid. Even distilled water will produce an alarm. This special coating, when combined with AquaALERT’s traditional AC supervision, virtually eliminates galvanic corrosion (electrolysis).
Routing
For the cable to be effective, it must come in contact with the leaking water. Route the cable around -or adjacent to- the likely source of potential leakage. Use the cable as a barrier between the source of a leak and the protected area. Make sure to maintain at least six feet from any HVAC downdraft. Water droplets from the cooling coils as well as moisture from the humidifiers can cause false alarms. When there are many sources for potential leakage, consider arranging the cable in a “serpentine” pattern. Starting at the DLS annunciator, wind the cable back and forth, spacing each run 5’ to 10’ apart, ending on the other side of the room.
Installing the Cable
Keep the cable rolled-up until ready to install. Do NOT allow the cable to become kinked as it is pulled into place. Secure the cable to the floor using self-stick cable clamps every five feet. Add sections of cable as required for total length. Use a cable on each side of the con­nectors, leaving a little slack for future service. Install the EOL device at the end of the last section.
Page 2
DLC
SERIES
WATER LEAK
DETECTION CABLE
Clamp or J-Clip
Overhead Piping
Tye-Wrap with Sitck-On
NOT RECOMMENDED
Butyl Mastic to Floor
NOT RECOMMENDED
Tye-Wrap to Floor Pedestal
NOT RECOMMENDED
Under HVAC Downdraft
Loading...