Light Emotion UVLED, UVLEDI, LED Strobe User Instructions

www.lightemotion.com.au

UVLED

5mm – 192 UV LEDs

UVLED1

1W – 48 UV LEDs

LED STROBE

5mm – 192 White LEDs

User’s instruction manual

This manual contains important information about the safe installation and use of this

product. Please read this instruction manual carefully before installing or operating

Please keep these instructions in a safe place for future reference

www.lightemotion.com.au

CONTENTS

SECTION Page

INTRODUCTION, UNPACKING 2
FEATURES, INSTALLATION 3
MAINTENANCE & PERIODIC CHECKS 4
CONNECTIONS AND CONTROLS 4
POWER, FUSE 4
DIP SWITCHES, STAND-ALONE 5
MASTER/SLAVE MODE, DMX MODE 6
DMX LEADS, DMX TERMINATORS 7
DMX CHANNEL INFORMATION 7
FAQ, SPECIFICATIONS 8

Please note that as part of our ongoing commitment to continuous
improvement and product development, the specifications in this manual are
subject to change without notice. Whilst every care has been taken in the
preparation of this manual we reserve the right to change specifications in the
course of product improvement.

INTRODUCTION

Congratulations on the purchase of your LED product by Lightemotion
We are confident that you will be satisfied with your purchase.
We have prepared this manual to assist you with the care and operation of
this item.
The lighting effect can be operated in following modes

- Audio activated

- Strobing mode

- Automatic mode

- Stand-alone

- Master/Slave

- DMX

UNPACKING

CAUTION: Do not use sharp objects whilst unpacking this product

Contents of the carton

- 1pc lighting effect

- 1pc Yoke (Hanging adaptor)

- 2pcs Thumbwheels

- 2pcs Rubber washers

- 1pc IEC power lead

Please note: Some of the items above may be fitted to the product by the
manufacturer

2/8

FEATURES

• Automatic mode

• Strobing mode

• Audio Activated with sensitivity control

• Master/Slave linkable

• DMX-512 controllable 3 channels

INSTALLATION

CAUTION:

For safe mounting read the following
instructions carefully:

• Use suitable hook clamps* for hanging
the lighting effect

• Use a safety wire* with a breaking
strain of more than double the lighting
effect

• Do not look directly into the light
source

• Make sure the lighting effect has
suitable ventilation as per the
instructions below

• This lighting effect is intended for
indoor use only

• To avoid electrical shock keep away
from rain and moisture

• Keep unit out of reach from children

NOTE:

Use washers* and spring washers* when attaching your hook clamp* to
the yoke

1. For installation of the hook clamps* and safety wire* please refer to Fig

3.

2. This lighting effect must be 0.5m away from any flammable materials or
any walls or ceilings.

3. Do not block or inhibit the air flow from the ventilation vents

Lightemotion have various hook clamps* and safety wires* suitable for your
lighting effect. Please contact your local dealer for more information
*Not included

3/8