Light Emotion P64LEDC User Manual

WWW.LIGHTEMOTION.COM.AU

P64LEDC

Controller for the P64LED and P64PLED

This manual contains important information about the safe installation and use of this product

Please read this instruction manual carefully before installing or operating

Please keep these instructions in a safe place for future reference

1 of 4 pages

Congratulations on the purchase of your P64LEDC by Light Emotion. LED Controller Panel can control the led
par can, led strobe and make colorful and dynamic light scenery effects.

CONTENTS

SECTION Page

WHAT IS INCLUDED, SAFETY INSTRUCTION 2
OPERATION 3

SPECIFICATIONS 4

Please note that as part of out ongoing commitment to continuous improvement and product
development, the specifications in this manual are subject to change without notice. Whilst every care has
been taken in the preparation of this manual we reserve the right to change specifications in the course of
product improvement.

WHAT IS INCLUDED:

CAUTION: Do not use sharp objects whilst unpacking this product

• 1x P64LEDC

• 1x12V DC power supply

• 1xWarranty Card & User Manual

Please note: Some of the items above may be fitted to the product by the manufacturer.

SAFETY INSTRUCTIONS:

Please read these instructions carefully. It includes important information about the installation usage
and maintenance of this product.

• Please keep this User Manual for future consultation. If you sell the unit to another user, be sure

that they also receive this instruction booklet.

• Always make sure that you are connecting to the proper voltage and that the line voltage you are

connecting to is not higher than that stated on the rear panel of the fixture.

• This product is intended for indoor use only! To prevent risk of fire or shock, do not expose

fixture to rain or moisture.

• Make sure there are no flammable materials close to the unit while operating.

• The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent

surface. Be sure that no ventilation slots are blocked.

• Always disconnect from power source before servicing or replacing fuse and be sure to replace

with same fuse source.

• Secure fixture to fastening device using a safety chain.

• Maximum ambient temperature is 40˚C. Do not operate fixture at temperatures higher than this.

2 of 4 pages