Light Emotion P645QUADO User Instruction Manual
WWW.LIGHTEMOTION.COM.AU
P645QUADO
User’s instruction manual
This manual contains important information about the safe installation and use of this product
Please read this instruction manual carefully before installing or operating
Please keep these instructions in a safe place for future reference
www.lightemotion.com.au
2
Congratulations on the purchase of your P645QAUDO by Light Emotion. We are
confident that you will be satisfied with your purchase. We have prepared this manual to
assist you with the care and operation of this item. This product uses 15 4in1 5W LEDs to
produce vivid colours that the user can control in many ways. The unit incorporates new
lens technology which produces a narrower, more concentrated beam allowing fewer
LEDs to be used to give a brighter effect. The unit features thermal cut-out, so it will shut
down if its interior temperature reaches 85 degrees C – this will prevent damage to the
product in the event of a problem.
Please note that as part of out ongoing commitment to continuous improvement and
product development, the specifications in this manual are subject to change without
notice. Whilst every care has been taken in the preparation of this manual we reserve the
right to change specifications in the course of product improvement.
CONTENTS
SECTION Page
WHAT IS INCLUDED, SAFETY INSTRUCIONTS 2
INSTALLATION 3
MAINTENANCE
, POWER, DMX
LEAD, DMX TERMINATOR, OPERATION 4
SPECIFICATIONS
7
Please note that as part of out ongoing commitment to continuous improvement and
product development, the specifications in this manual are subject to change without
notice. Whilst every care has been taken in the preparation of this manual we reserve the
right to change specifications in the course of product improvement.
WHAT IS INCLUDED:
CAUTION: Do not use sharp objects whilst unpacking this product
• 1 x P645QUADO
• 1 x Warranty card
• 1 x User manual
• 1 x 5 Meter power cable with normal Australian plug,
• 1 x 1 Meter DMX adaptor cable with female IP plug and male XLR plug,
• 1 x Female DMX end cap
• 1 x Male DMX end cap
• 1 x Female power end cap
• Do not include IR remote controller P645QUADOR.
Please note: Some of the items above may be fitted to the product by the manufacturer.
SAFETY INSTRUCTIONS:
Please read these instructions carefully. It includes important information about the
installation usage and maintenance of this product.
•
Please keep this User Manual for future consultation. If you sell the unit to
another user, be sure that they also receive this instruction booklet.
3
•
Always make sure that you are connecting to the proper voltage and that the line
voltage you are connecting to is not higher than that stated on the rear panel of the
fixture.
•
This is an IP65 rated outdoor fixture. To prevent damage to the waterproof seal,
do not pull the product apart yourself. Refer to qualified person.
•
Make sure there are no flammable materials close to the unit while operating.
•
The unit must be installed in a location with adequate ventilation, at least 50cm
from adjacent surface. Be sure that no ventilation slots are blocked.
•
Always disconnect from power source before servicing or replacing fuse and be
sure to replace with same fuse source.
•
Secure fixture to fastening device using a safety chain. Never carry the fixture
solely by its head. Use its carrying handles.
•
In the event of serious operating problem, stop using the unit immediately. Never
try to repair the unit by yourself. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical
assistance center. Always use the same type spare parts.
•
Never connect the device to a dimmer pack.
•
Make sure power cord is never crimped or damaged.
•
Never disconnect power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source while it is on.
INSTALLATION:
CAUTION: For safe mounting, read the following
instructions carefully:
•
Use suitable hook clamps for hanging the lighting
effect.
•
Use a safety wire with a breaking strain of more than
double the lighting effect.
•
Do not look directly into the light source.
•
Make sure the lighting effect has suitable ventilation as
per the instructions below.
•
This lighting effect is intended for indoor use only to
avoid electrical shock keep away from rain and
moisture.
•
Keep unit out of reach from children.
NOTE: Use washers and spring washers when attaching your hook clamp to the yoke.
1. For installation of the hook clamps and safety wire.
2. This lighting effect must be 0.5m away from any flammable materials or any walls or
ceilings.
3. Do not block or inhibit the air flow from the ventilation vents.
Loading...