Light Emotion DMX36 User Instruction Manual

www.lightemotion.com.au

DMX36

Basic controller for RGBWAUV HEX 6-in-1 LED Fixtures

User’s instruction manual

This manual contains important information about the safe installation and use of this product

Please read this instruction manual carefully before installing or operating

Please keep these instructions in a safe place for future reference

V1.01

Introduction

Thank you for the purchase of your DMX36 basic LED DMX controller by Light Emotion. We are confident you

will be satisfied with your purchase and enjoy many years of use from this Professional Light Emotion product.

Please read these instructions carefully to ensure the product is well look after and used correctly to avoid any

potential problems.

Please note that as part of our ongoing commitment to continuous improvement and product development, the

specifications in this manual are subject to change without notice. Whilst every care has been taken in the

preparation of this manual we reserve the right to change specifications in the course of product improvement.

What is in the box:

- 1 x DMX36 controller

- 1 x 12VDC power supply

- This user manual

1. Safety Instructions:

Please read these instructions carefully. It includes important information about the installation usage and

maintenance of this product.

- Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also

receive this instruction booklet.

- Always make sure that you are connecting to the proper voltage and that the line voltage you are connecting to is

not higher than that stated on the sticker of the fixture.

- This product is intended for indoor use only. To prevent risk of fire or shock, do not expose fixture to rain or

moisture.

- Always disconnect from power source before servicing.

- Maximum ambient temperature is 40˚C. Do not operate fixture at temperatures higher than this.

- In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself.

Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized

technical assistance centre.

- Make sure power cord is never crimped or damaged.

- Never disconnect power cord by pulling or tugging on the cord.

- Never carry the fixture directly from the cord or power supply.

- To avoid risk of electrical shock, keep away from rain and moisture.

2. Features

This product is designed as entertainment lighting controller and is only intended to be used as such for

entertainment and production applications. Due to our ongoing commitment to constantly reviewing and improving

products, features and specifications are subject to change without prior notice.

1

It will control any 6-in-1 RGBWAUVLED fixture that has a DMX profile with the six colours running over 6

channels where each channel represents a colour – red, green, blue, white, amber and UV. Each fixture needs to be

in DMX mode, and set 6 channels apart.

3. Operation

On the rear of the product, there are connections for DMX out and power in. Connect the power supply

to the power in, connect DMX out to the DMX cable going to lighting fixture(s).

A.

Set the status of the fixture which is to be controlled:

1) All the fixtures must be in DMX mode

2) The DMX address of the first fixture must be set to 001,the second fixture must be set to 007,the

third fixture must be set to 013,the fourth fixture must be set to 019,the fifth fixture must be set to

025,the sixth fixture must be set to 031.

3) The fixture must be in the 6 channels mode, the LED lighting protocol must be R-G-B-W-A-UV

or R-G-B-A-W-UV.

B .Select the fixture which is to be controlled by HEX LED controller:

The HEX LED controller can control 6 LED fixtures at most with individual control. Note

additional fixtures can be added but they repeat as light 1,2,3, etc – for example the 7

have to be on address 001 and treated as a second number 1 light.

th

light would

2