Light Concept LC Show.LED 910 IP User Manual

9*10w 4in1 RGBA wireles P LED akku s ar

User manual

Pleasereadt

he

instr

u

ction

s ca

refully before use

2

TABLE OF CONTENTS

1.Saf

etyInstructions

..................................................................................................... 2

2. Technical Specifications

...........................................................................................4

3. How To Control The Unit

.......................................................................................5

4. Remind

......................................................................................................................10

statement

The product has well capability and intact packing when leave

factory. All of the user should comply with warning item and manual, any

misuse cause of the damages are not included in our guarantee, and

also can not be responsible for any malfunction & problem owing to

ignore the manual.

1.Saf

etyInstructions

Please keep this User Guide for future consultation. If you sell the unit to another

user, be sure that they also receive this instruction booklet.

Unpack and check carefully there is no transportation damage before using

the unit.

Before operating, ensure that the voltage and frequency of power

supply match the power requirements of the unit.

It’s important to ground the yellow/green conductor to earth in order

to avoid electric shock.

The unit is for indoor use only. Use only in a dry location.

The unit must be installed in a location with adequate ventilation, at

least 50cm from adjacent surfaces. Be sure that no ventilation slots are

blocked.

3

Disconnect main power before replacement or servicing.

Make sure there are no flammable materials close to the unit while operating as

it is fire hazard.

Use safety cable when fixes this unit. DO NOT handle the unit by taking its head

only, but always by taking its base.

Maximum ambient temperature is Ta: 40℃. DO NOT operate it where the

temperature is higher than this Unit surface temperature may reach up to 85℃.

DO NOT touch the housing bare-hand during its operation. Turn off the power

and allow about 15 minutes for the unit to cool down before replacing or serving.

In the event of serious operating problem, stop using the unit

immediately.Never try to repair the unit by yourself. Repairs carried out by

unskilled people can lead to damage or malfunction. Please contact the

nearest authorized technical assistance center. Always use the same type

spare parts.

DO NOT touch any wire during operation as high voltage might be causing

electric shock.

Warning:

Please set one light only as master when used Master-slave model in the same

channel.

DO NOT set any light as master when used DMX hold model.

To prevent or reduce the risk of electrical shock or fire, do not expose the unit to

rain or moisture.

DO NOT open the unit within five minutes after switching off.