Lifesmart XXHT1153US User Manual

INFRARED QUARTZ HEATER

Customer number:

XXHT1153US

ATTACH YOUR RECEIPT HERE

Purchase Date ____________Serial Number (located on back of unit) __________________

Questions, problems, missing parts? Contact technical support department at 657-341-0362, 8:00 a.m. - 5 p.m., CST, Monday - Friday or visit us online at

www.lifesmartcomfort.com Please have your model and serial number ready

REV1-091317

TABLE OF CONTENTS

Package Contents ...............................................................3

Safety Information ..............................................................4

Frequently Asked Questions ......................................................6

Preparation .................................................................... 8

Troubleshooting ................................................................8

Control Panel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Remote Control ................................................................ 10

Operating Instructions .......................................................... 11

Care and Maintenance .......................................................... 13

Wall Mounting Instructions ...................................................... 14

One-Year Limited Warranty ...................................................... 15

Replacement Parts List ......................................................... 16

PACKAGE CONTENTS

PART DESCRIPTION QUANTITY

A Infrared Heater 1

B Remote Control 1

C Control Panel (preassembled to Infrared Heater (A)) 1

D Filter Cover 1

E Easy grab handle 1

F Heater mounting brackets (preassembled to Infrared Heater (A)) 2

G Unit Feet (preassembled to Infrared Heater (A)) 2

H Wall mounting bracket 1

I Wall screw and drywall anchor 6

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. When using electrical

appliances, basic precautions should always be followed to reduce the risk of ﬁre, electric shock, and injury to persons, including the following:

• This heater must be plugged into a 120 V, 15 amp (or more) circuit of its own. Do not plug anything else into the same circuit. If unsure if your home meets this speciﬁcation, consult a certiﬁed electrician prior to use. Risk of ﬁre, overheating, malfunction, property damage, injury, or even

death may result if not adhered to!

• Connect to a properly grounded, 3-prong outlet only. Do not connect the heater to extension cords, surge protectors, timers, direct breakers, or an outlet with other appliances connected to the same outlet. Risk of ﬁre, overheating, malfunction, property damage, injury, or even death may result

if not adhered to!

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles (certain models) or wheels to move this heater.

• Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 ft. (0.9 m) from the front of the heater and keep them away from the sides and rear of the heater.

• Extreme caution is necessary when any heater is used by or near children, invalids, pets, or when the heater is left operating unattended.

• Always unplug the heater when not in use.

• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Contact the manufacturer for resolution options.

• Do not use outdoors. Exposure to outdoor elements such as rain, snow, sun, wind, or extreme temperatures may cause the heater to become a safety hazard.

• This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations, nor any locations that use GFCI outlets.

• Never place the heater where it may fall into a bathtub or other water receptacles.

• Do not run the cord under carpet. Do not cover the cord with throw rugs, runners, or similar coverings. Arrange the cord away from trafﬁc areas and where it will not be tripped over.

• The heater must be plugged into a wall outlet that is a dedicated circuit with a minimum 15 amp rating on that individual circuit.

• To disconnect the heater, ﬁrst turn the power button to the OFF position and then remove the plug from the wall outlet.

• Do not allow foreign objects to enter or block any ventilation or exhaust opening as this may cause electric shock, ﬁre, or damage the heater.

• Allow at least 3 ft. of unobstructed space to the front and rear of the heater to allow for maximum heat, air, and ventilation ﬂow.

• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or ﬂammable liquids are used or stored, nor use ﬂammable solvents to clean the heater. Keep the heater dry at all times.

• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause ﬁre, electric shock, or injury to persons.

• Do not use abrasive solvents to clean the heater as it may cause damage to the ﬁnish or casing.

• To prevent a possible ﬁre, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where opening may become blocked.

• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).

SAVE THESE INSTRUCTIONS

SAFETY INFORMATION

Grounding Pin

Grounding Means

Child Lock Safety Feature

Press and hold the child lock button located on the control panel for 5 seconds or remote control for 3 seconds. Locking is conﬁrmed when a buzzer rings and the control panel displays “CL”. When locked, the control panel and remote control (if provided) will not function.

To unlock the control panel or remote (if provided), repeat this procedure. Unlocking is conﬁrmed when a buzzer rings and the lock indication disappears.

Tip-Over Safety Feature

This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the control panel or supplied remote control (if provided) on the heater.

Overheat Safety Feature

This heater is equipped with an overheat safety feature. When the internal components of the heater reach a certain temperature that could cause overheating or possible ﬁre, the heater will automatically shut off. If the unit has been overheated, you will need to unplug the unit from the wall and replug it in to use the heater again.

WARNING: This heater has a voltage rating of 120 volts. The cord has a three-blade, groundingtype plug. An adapter is available for connecting three-blade grounding-type plugs to two-slot receptacles. The grounding lug extending from

Metal Screw

Cover of Grounded

Outlet Box

the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG.

Grounding Pin

WARNING: It is normal for the power cord to feel warm to the touch. However, a loose ﬁt between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet. Contact a qualiﬁed electrician to inspect the original outlet for damage.

Speciﬁcations

Voltage Rating 120 V (60 Hz)

Power Consumption 1,000 W/1,500 W

Unit Size 12.2 in. (W) x 6.8 in. (D) x 18.1 in. (H)

Unit Weight 15.0 lbs.

+ 11 hidden pages