lifeSMART LS-EF450 Owners Installation And User Manual

OWNERS INSTALLATION AND USER GUIDE

LIFESMART INFRARED FIREPLACE WALL HEATER

Model: LS-EF450

Safety Notice

Please read this entire Installation and Operating Manual BEFORE installing and using your new Infrared
Heater. Failure to fully understand and follow instructions may result in property damage, bodily injury, or
even death.

Unexpected mishaps may occur if the Infrared Heater in not used properly. For everyone’s safety , follo w
ALL Installation and Operating Directions.

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND
KEEP SAFE FOR FUTURE REFERENCE.

READ AND SAVE THESE INSTRUCTIONS

Important Safety Instructions

When using electrical appliances, basic precautions should always be followed to reduce the risk
of fire, electric shock and injury to person, including the following:

CAUTION- High temperature, keep electrical cords, drapery, and other furnishings at least 3 feet (0.9m) from

the front of the heater and away from the side and rear.

 Read all instructions before using heater.
 This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials,

such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and
keep them away from the sides and rear.

 Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left

operating unattended.

 Unplug power cord before servicing or moving the heater. Always unplug heater when not in use.
 Do not operate any heater with a damaged cord or after the heater malfunctions, has been dropped or damaged in

any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or
repair.

 Do not use outdoors.
 This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater

where it may fall into a bathtub or other water container.

 Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from

traffic area and where it will not be tripped over.

 To disconnect heater, turn controls to off, then remove plug from outlet.
 Connect to properly grounded outlets only.
 Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an

electric shock or fire or damage the heater. Do not block or tamper with the heater in any manner while it is in
operation.

 A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable

liquids are used or stored.

 Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause

fire, electrical shock, or injury to persons.

 Avoid the use of extension cords because the extension cord may overheat and cause a risk of fire.
 This heater includes an overheat protection system that shuts off the heater when parts of the heater are getting

excessively hot. If the heater shuts off, immediately turn the heater OFF and inspect for any objects, on or adjacent to
the heater, which may cause high temperatures. DO NOT OPERATE THE HEATER UNTIL IT IS RESET. To reset the
heater, turn it OFF, unplug it from the electrical outlet, and wait five to ten minutes for the unit to cool down before
plugging it back in and turning the heater on.

 Make certain that the power source conforms to the electrical requirements of the heater.
 A heater has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous locations such as

flammable, explosive, chemical-laden or wet atmosphere. This heater is intended for use in general use only.

 This appliance is not intended for use by persons (including children) with reduced physical, sensory or learning

disabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.

 Children should be supervised to ensure that they do not play with the appliance.

WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF POWERING DOWN THE

HEATER WHEN SERVICING OR MOVING. ALWAYS UNPLUG THE POWER CORD AS WELL.

Technical Specifications

· Supply: 110-120V~ 60Hz · Rated power: 1500W · Lighting: 40W E12 SES Clear Candle Bulb

Getting Started

· Remove the heater from the box.

· Remove any packaging materials from the product.

· Place the packaging inside the box and either store or dispose of safely.

Included In the Box:

·(Qty 1) Heater (with glass fireplace cover)·(Qty 1) Remote Cont rol·(Qty 1) Instruction Manual

Mounting Hardware Pack: (Qty 1) Long Mounting Bracket·(Qty 1) Short Mounting Bracket
(Qty 6) Long Screws

·(Qty 2) Short Screws·(Qty 6) Plastic Wall Plugs

Precautions To Consider Before Mounting

・

2 People will be required to complete the mounting process.

・

Keep all packaging until you have checked and counted all the parts and the contents of the mounting hardware.

・

The mounting hardware pack contains small items that should be kept away from young children.

・

We suggest that after opening the mounting hardware pack, you place all the contents into a container, to reduce the

risk of losing small pieces.

・

Do not plug in or power up the heater until it is secure to the wall and the instructions are read fully.

・

Please choose a mounting location wisely, prior to starting. A power outlet must be within the cord’s reach.

・

The long mounting bracket must be secured horizontally, and the power cable routed to the bottom right of the heater.

・

Please observe the recommended heights and dimensions for mounting the heater. This appliance is designed to be

mounted to a wall at a minimum height of 2 feet from the floor, and a minimum 3 feet from the ceiling (for optimum
heat ventilation).

・

Note that the long mounting bracket will be “hooked” to the heater towards the top, rear edge of the heater, and not

the center. Consider this when mounting the bracket.

・

Take necessary precautions to avoid cutting or damaging any cables or power cords.

・

While drilling holes for the plugs, be cautious of electrical lines, metals, or items beyond the walls.

・

Be sure that the wall you choose to mount on is solid, and will support the heater’s approximate weight (30lbs).

・

Make sure that the heater is safely out of the way while you are installing mounting hardware, as it may become a

tripping hazard if left in the open.

・

Please be cautious if you are set on mounting the heater low to the floor, as it may become a safety hazard to

children and pets!

Items Needed: