Life 'n soul LNS-IE350 User Manual

Bluetooth Headset LnS-IE350 User manual

1.Notice Before Using

Thank you for purchasing the Bluetooth® Headset LnS-IE350 Please read this User Manual completely before you use the Headset.

LnS-IE350 is designed for listening high quality music wirelessly using the latest Bluetooth® wireless technology. LnS-IE350 can be

easily connected to a mobile phone for call conversation and music listening, it is also able to connect to the other Bluetooth®-

enabled devices like Notebook, iPod etc. IE350 is compliant with Bluetooth V3.0 specication, supports HSP, HFP, A2DP and AVRCP

proles. Please make sure your phone or other device supports these proles.

2. Specification

Bluetooth specication: V3.0

Operation frequency: 2.402-2.48GHz

Supported prole: HSP, HFP, A2DP,AVRCP

Operation range: Up to 10 meters

3.Package Contents List

Please inspect this package and refer to the package contents list below to verify all items were included:

1) SH802 Bluetooth® headset(1) 2) USB Charging Cable(1)

3) User's Manual(1) 4) Ear Cap (2x3 Sizes )

5) Ear t kits(2)

4. LnS-IE350 Bluetooth® Headset Overview

1. Ear Cap

2. Indicator

3. Volume Up/Previous

4. Volume Down/Next

5.Battery information

The device is equipped with an integrated lithium-polymer battery. The battery cannot be replaced. Do not attempt to remove the

battery from the device since it would damage the device. The full performance of a new battery is not achieved until after two

or three complete charging/discharging cycles. The battery can be charged and discharged several hundred times, but it loses its

capacity over time.

Disconnect the IE350 from the power supply as soon as the battery is fully charged, as overcharging would reduce the service life of

the battery. A charged battery will lose its capacity if it is not used on a regular basis.

Important: Ensure that the battery is fully charged if you do not use the device for a long period of time. To avoid complete

discharge of the battery, the IE350 should be charged at least every 3 months.

6.Charging the battery

The IE350 is operated with a rechargeable battery. Charge the battery completely before its rst use. Read the section "Battery

information" before starting the charging process.

1) Connect USB cable to a general USB power supplier. 2) Connect the charger to the correct outlet.

3) When the charger is connected to the headset, the red indicator light will turn on. Charging the battery fully may take up to 1

hour.

4) When the battery is fully charged, the red indicator light will turn blue. Disconnect the charger from the headset and the outlet.

The headset is ready to use.

NOTE:

- For rst time use, please charge the headset fully.

- The fully charged battery has power for up to 5 hours of talk-time and 4.5 hours music

playing time, and up to 300 hours of standby time. However, the talk and standby times may

vary when used with dierent mobile phones or other compatible Bluetooth® devices, usage

settings, usage styles, and environments. When the battery power is low, the headset will

Talk time: 5 hours

Play time: 4.5 hours

Standby time: 300hours

Charge time: 1 Hours

5. Answer

6. Power/Play

7. Microphone

remind you by voice prompt "Battery low" every 20 seconds, and the red indicator light will start to ash.

- For using the IE350 with iPhone, an additional battery meter ( ) will be activated and the

remaining battery capacity will display on your phone.

7. Pair to your Bluetooth® phone

Before you use your headset for the rst time, you must pair the unit with a Bluetooth® enabled

mobile phone. Pairing is a one-time process and required only for the rst connection with the

Mobile phone. The IE350 can be connected with two mobile phones simultaneously.

1)Keep the IE350 within 1 meter range of a Bluetooth®-ready Mobile phone.

2)Press and hold the Power/Play button for about 5 seconds, the indicator light will ash red and

blue intermittently, the device is now in pairing mode.

3)Find the Bluetooth® setting of your Mobile phone and start the search for Bluetooth® devices. (For further details, please read the

operating instructions of your Mobile phone).

4)From the list of devices found, select the "IE350 ".

5)If required, enter the PIN code "0000" and conrm the entry. Once the pairing process is successful, the SH802 will connect to the

Mobile phone automatically then switch to standby mode, seen when the indicator ashes blue every 5 seconds.

Note: 1)If pairing is not completed within 2 minutes, the headset will turn o. If this happens, please repeat the pairing steps.

2)The IE350 supports Multi-connection that allows for the simultaneous use of the IE350 with two mobile phones. After paring

successfully with 2 mobile phones, switch o the headset and switch on again, the headset will connect to both 2 mobile phones

automatically. Otherwise, you can connect the headset on the cellphone manually.

8.Turning headset on /off

Turn on your headset: Hold the Power/Play for 3 seocnds to turn on your headset. If your headset has completed the pairing

process successfully, when the headset is turned on, it will connect to the phone you last connected to automatically. Please ensure

your phone's Bluetooth® function is active.

Turn o the headset: Hold the power button for 3 seconds to turn o the headset. The Red indicator will ash red.

Note: To conserve power, if the headset is not connected to a device for approximately 10 minutes, the headset will turn o automatically.

9.Selecting the Voice prompt language

The IE350 supports voice prompt for the headset’s status announcement in 5 dierent languages (English, Chinese, Spanish,

French, German). At the standby state with connection, hold the Answer button to shift the languages one by one, then click the

Power/Play once to select the languages.

10. Wearing the headset

For the best sound performance and a secure, comfortable t, be sure

the ear buds rest gently in your ear and drape around the back of our

neck. Use the provided t kit to nd the ear tip that works best for you.

11.Using for music play

Play/Pause : Press Power/Play button to get the music to play or pause.

Next/Previous song: Press and hold the Next button to skip to the next song or chapter, press and

hold Previous button to go back previous song or chapter.

Increase/Decrease volume: Press Volume Up button to increase volume, press Volume Down button

to decrease volume.

Note: The IE350 supports A2DP prole that allows stereo music streaming from a Bluetooth phone. The music will pause

automatically while a call is dialed out/incoming, and resume when the call conversation has ended.

12. Using for phone call

Re-Dialing Last Number: At standby status, double press the Answer button, the last number you dialed will be re-dialed.

Note: Re-dialing the last number is available only for the rst device if two Mobile phones are connected. The connection sequence

can be determined by reconnecting manually.

Answering a call: Press Answer once to answer the incoming call.

Reject an incoming call: Press and hold Answer for 2 seconds to reject the incoming call.

Transferring a call: Press and hold Volume Up for 2 seconds to transfer the call between the phone and headset.

Ending a call: Press the Answer once to end a call.