Life Fitness SU50 User Manual

SEATED ROW SU50

ASSEMBLY INSTRUCTIONS

The Seated Row SU50 comes disassembled in two pieces. Follow the steps below to
assemble it.

TOOLS NEEDED

9/16”
socket wrench

1 hr

45 min

One person can accomplish this assembly in approximately ½ hour.

15 min

30 min

9/16”
box wrench

ASSEMBLY TIME

7/8” open end
wrench or
crescent wrench

UNPACKING AND PARTS

CAUTION: ASSEMBLING THE SEATED ROW SU50 REQUIRES THE ABILITY TO

MOVE HEAVY COMPONENTS. THE WEIGHT STACK SUBFRAME OF THE SU50 IS
LARGE AND HEAVY AND MAY CAUSE INJURY OR DEATH IF IT FALLS ON
SOMEONE. USE CAUTION WHEN ASSEMBLING THIS MACHINE.

1. Unpack the Weight Stack Subframe and the Seat Subframe from the crate. Stand
the Weight Stack Subframe up on its four feet. Stand the Seat Subframe up as shown in
Figure 1. Remove the cable and bolts pack.

M051-K50-A104 1

Seated Row SU50 Customer Assembly Instructions

Figure 1. Seated Row SU50.

1. Bolt holes on Seat
Subframe

2. Bolt holes on Weight
Stack Subframe

3. Cable Pulleys 4. Cable

½½½½½½

0123456

Figure 2. Configuration for bolts, end caps, washers and nuts.

2

Seated Row SU50 Customer Assembly Instructions

INCLUDED PARTS

Included parts are:

1. 3-3/4” Hex head bolts (4)

2. End caps (bolt covers) (8)

3. Flat washer (used to “shorten” bolt so end cap will fit on the nut) (4)

4. End cap washers (end caps snap onto them) (8)

5. 3/8” Locknut (4)

6. Cable (1)

7. Row handle (1)

8. Handle clip (1)

ASSEMBLING THE SU50

1. Line up the Weight Stack Subframe and the Seat Subframe sections. Line up the

boltholes in the two sections.

Figure 3. Lined up sections of the Seated Row SU50.

2. Insert the bolts with flat washers and end cap washers at the head. Slide the flat

head washers onto the four bolts and insert the bolts into the Seat Subframe section of
the SU50. The flat washers will “shorten” the bolt so that the end caps will fit onto the nut
end of the bolt. Figure 4 shows the inserted bolt from the Seat Subframe side of the
SU50.

3