Life Fitness SLR User Manual
Leg Raise
Owner’s Manual
2
Tools Required:
O
7mm Allen Wrench
O
17mm Wrench
O
Ratchet
O
3” Ratchet Extension
O
17mm Socket
O
7mm Hex Bit
Leg Raise
1. Assembly Instructions
Qty
1
1
4
16
8
1
1
10
2
1
6
2
Description
Bottom Brace
Left Upright
M10 x 135mm Bolt
Flat Washer
Nylock Nut
Right Upright
Back Pad
M10 x 25mm Bolt
Plate
Large Hole Plug
Small Hole Plug
Arm Pad
Part Number
7970701
7972501
3256221
3102514
3242002
7972601
7972901
3256202
7322301
7308701
3237403
78903XX
Item
1
2
3
4
5
6
7
8
9
10
11
12
1. Attach the BOTTOM BRACE (1) to the LEFT UPRIGHT (2) using two M10 x
135mm BOLTS (3), four FLAT WASHERS (4) and two NYLOCK NUTS (5).
Finger tighten the NUTS.
Attach the RIGHT UPRIGHT (6) to the BOTTOM BRACE (1) using two M10 x
135mm BOLTS (3), four FLAT WASHERS (4) and two NYLOCK NUTS (5).
Finger tighten the NUTS.
3
2. Position the BACK PAD (7) over the top of the UPRIGHTS (2 & 6) as
shown. Secure the top of the BACK PAD BRACKET (A) using two M10 x
25mm BOLTS (8) and PLATES (9).
Do not tighten the bolts at this time.
Secure the sides of the BACK PAD BRACKET (A) using four M10 x 25mm
BOLTS (8), FLAT WASHERS (4) and NYLOCK NUTS (5).
Tighten all UPRIGHT and BACK PAD BOLTS and NUTS securely.
3. Open the air valve in the center and rear of the BACK PAD (7). Using the
supplied air pump, inflate the BACK PAD to an overall height of 9”. Quickly
remove the air pump nozzle and close the air valve.
Insert LARGE HOLE PLUG (10) into the access hole in the rear of the
BACK PAD (7).
4. Insert SMALL HOLE PLUGS (11) into the access holes in the sides of the
UPRIGHTS (2 & 6).
5. Attach the RIGHT ARM PAD (12) using two M10 x 25mm BOLTS (8) and
FLAT WASHERS (4) as shown. Repeat to attach the LEFT ARM PAD (12).
Tighten the BOLTS securely.
4
Leg Raise
1. Assembly Instructions
Loading...