Life Fitness M051-00K32-A086 User Manual

Life Fitness LCD Entertainment System

How To Program TV Consoles

Special service tools required: none

Description: Procedures for programming a.)
EZ consoles (on this page) and b.) TV consoles
with remote control units (on page 2).

Kit Contents: Programming device and cable
(see illustration). A 9-volt battery (not
supplied) is required to reprogram the TV
console.

Procedure: In both procedures, the TV
console stays mounted and the power and
coax cables stay plugged in (see illustration).

To program the TV on EZ console products:

1. Remove the EZ console cable from the
black 8-pin connector on the back of
the console.

2. Plug the C-SAFE cord into that 8-pin
connector.

3. Place the 9-volt battery in the
programmer.

4. Plug the other end of the C-SAFE cord
into the programmer.

5. The programmer will give this
feedback that the updating procedure
is taking place:

a. The green LED will glow

steadily.

b. The yellow LED will then glow

steadily.

c. The yellow LED will then begin

flashing.

d. The console software has been

updated when the green LED
begins flashing slowly.

6. Unplug the C-SAFE cord from the
programmer.

7. Unplug the C-SAFE cord from the
console.

8. Reconnect the EZ console cable.

9. Verify that the console’s software
version matches the software version on the programmer. If the console version
number is still lower, repeat the procedure.

Programmer

Battery Compartment Cover

9-volt Battery

C-SAFE Cord

Tto programmer

Coax

Cable

Black 8-Pin C-SAFE Connector

(for in-console control)

Power

Cable

do not useD

9-volt Battery
Connector

C-SAFE Connector

Tto console

1

M051-00K32-A086

Life Fitness LCD Entertainment System

How To Program TV Consoles - continued

To program TVs with remote control consoles:

1. Leave the remote control cable plugged in.

2. Plug the C-SAFE cord into the black 8-pin
connector on the back of the console.

3. Place the 9-volt battery in the programmer.

4. Plug the other end of the C-SAFE cord into
the programmer.

5. The programmer will give this feedback that
the updating procedure is taking place:

a. The green LED will glow steadily.
b. The yellow LED will then glow

steadily.

c. The yellow LED will then begin

flashing.

d. The console software has been

updated when the green LED begins

Black 8-pin C-SAFE connector

flashing slowly.

6. Unplug the C-SAFE cord from the programmer.

7. Unplug the C-SAFE cord from the console.

8. Verify that the console’s software version matches the software version on the
programmer. If the console version number is still lower, repeat the procedure.

Coax

Cable

Tan 10-Pin Connector

(for remote control)

Power

Cable

2

M051-00K32-A086