Life Fitness M051-00K26-A261 User Manual

M051-00K26-A261

CAM

NORPRENE HOSE

HOSE CLAMP

FROM WAX CONTAINER

WAX MOTOR

COVER

3 PHILLIPS HEAD SCREW

TO WAX NOZZLE

Life Fitness 9100 Series Treadmills

How To...REMOVE AND REPLACE THE WAX PUMP NORPRENE HOSE

Tools Required: Phillips screwdriver, vise grips or clamp, hex key wrench set, socket and ratchet set

Step 1

Turn the power OFF at the switch and unplug
the unit at the electrical outlet.

Step 2

Separate the FRONT and REAR FRAME
ASSEMBLIES (See "How To...").

Step 3

LOCATE the WAX MOTOR on the user LEFT
side of frame chassis.

Step 4

With your fingers, remove the HOSE CLAMP
leading from the WAX CONTAINER and
temporarily seal off the HOSE to prevent
spillage while disconnecting it.

Step 5

Remove the SPRING CLAMP and
DISCONNECT the HOSE leading to the
SPRAY NOZZLE.

Step 6

Use a PHILLIPS HEAD SCREWDRIVER and
remove the 3 screws and remove the cover on
the wax pump.

Step 7

Remove the old NORPRENE HOSE and
discard. Reinstall the new NORPRENE HOSE.

Step 8

Reverse Steps 1 through 6 to return all parts to
their proper positions taking special note to
unkink the WAX CONTAINER HOSE prior to
rejoining the FRONT and REAR FRAME
ASSEMBLIES.

SPRING CLAMP

HOSE FITTING

NOTE: THIS IS NORMALLY AN OPPORTUNE TIME TO INSPECT THE WAX SPRAY NOZZLE.

BETWEEN THE BOTTOM OF THE FRAME AND THE STRIDING BELT. PRESS THE

SPRAY NOZZLE IN AND TWIST IT 1/4 TURN TO REMOVE. CLEAN OR REPLACE THE

SPRAY NOZZLE AS DEEMED NECESSARY AND COMPLETE GENERAL CLEANING OF THE UNIT.