Part No:
60-883-95R
Safety, Health, & Independence
LifeCall 7000
User Guide
Help at the Press of a Button
www.lifecall.ca
FCC NOTICES
FCC PART 15 INFORMATION TO THE USER
Changes or modifications not expressly approved by GE Security can void the user’s authority to operate the equipment.
FCC PART 15 CLASS B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the affected equipment and the panel receiver to separate outlets, on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
ACTA PART 68
This equipment complies with Part 68 of the FCC Rules. Located on this equipment is a label that contains, among other information, the FCC registration number and the ringer
equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company.
FCC Part 68 Registration No. B4Z-USA-46042-AL-T
The REN is used to determine the maximum number of devices that may be connected to your telephone line. Excessive RENs on a telephone line may result in devices not ringing
in response to an incoming call. In most areas, the sum of all device RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the
format US: AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements as adopted by
ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to connect to a modular jack that is also compliant. See the Installation Instructions
for details.
Alarm dialing equipment must be able to seize the telephone line and place a call in an emergency situation. It must be able to do this even if other equipment (telephone, answering
system, computer modem, etc.) already has the telephone line in use. To do so, alarm-dialing equipment must be connected to a properly installed RJ31X jack that is electrically in series
and ahead of all other equipment attached to the same telephone line. Proper installation is depicted in the following diagram. If you have any questions concerning these instructions,
consult your local telephone company or a qualified installer about installing an RJ31X jack and alarm dialing equipment for you.
If this equipment causes harm to the telephone network, the telephone company may temporarily disconnect your service. If possible, you will be notified in advance. When advance
notice is not practical, you will be notified as soon as possible. You will also be advised of your right to file a complaint with the FCC.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. You will be given advance notice
in order to maintain uninterrupted service.
If you experience trouble with this equipment, please contact the company that installed the equipment for service and/or repair information. The telephone company may ask you
to disconnect this equipment from the network until the problem has been corrected or you are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.
Patent Information
One or more of the following patents may cover this product and the use of this product: 4,864,636, 5,805,063, 5,872,512, 5,942,981, 5,686,896, 5,686,855, and 4,855,713. Except
as expressly provided herein, the purchase of this product shall not constitute a license or otherwise provide a right to practice a method covered by any of the identified patents. GE
Security hereby grants the purchaser of this product a limited non-exclusive license to practice the methods patented in the identified patents solely with products manufactured,
sold or licensed by GE Security. This license grant does not extend to the use of unlicensed
third party products with this product.
2
Contents
System Components 4
The Control Panel
Your Personal Help Button
Optional Components
Setting up the System
Finding a Place for the Panel
Plugging in the Phone Line
Powering up the System
Signaling for Help
Signaling for Help With Your Personal Help Button
Signaling for Help With Your Panel CALL Button
After You’ve Signaled for Help
The Master Access Code 6
Adjusting the Speaker Volume
Using The LifeCall 7000 Check-in Feature
Using Your LifeCall 7000 System Like a Speaker Phone
Using Medication Reminders (optional feature)
Acknowledging Medication Reminders
Home and Away
4
6
7
7
8
9
Testing Your System
Testing Your Sensors
Troubleshooting
References
Medication Reminders
10
11
12
System Components
LifeCall 7000 is an emergency response system made up of the control panel and a personal help button.
The help button activates the emergency reporting system and is worn on the wrist like a watch, as a
pendant or on a belt. LifeCall 7000 is programmed to call VOXCOM’s Emergency Response Centre who will
contact a relative or the proper authorities when there is an emergency. It can also be controlled from a
location other than your home through a telephone.
Figure 1. The Front of Your LifeCall 7000 Panel
The Control Panel
The control panel reports emergencies through the phone line
when your personal help button or the CALL button on the panel is
pressed.
Your Personal Help Button
Your Water Resistant Personal Help Button is a
wireless device worn on the wrist, as a pendant
or on a belt. The help button can also be
mounted on a wall.
Help Button
Figure 2. Your Help Button
Optional Components
Check with your installer about adding smoke alarms to detect and alert you to smoke.
Setting up the System
Call Butto
n
Speaker
Volume Contr
Powe
r
Home/Awa
Butto
n
Status Butto
ol
y
n
Setting up your LifeCall 7000 system involves the following simple steps:
1. Finding a place for the panel.
2. Plugging in the phone line.
3. Powering up the system.
4