Installation instructions
for refrigerator-freezers, built-in flush
with decor frame
GB
7082 568-00
EK/EKB/EG 4006
6
EK/EKB/EG
* Depending on model and options
Installation instructions
Keep the installation instructions in a safe place and pass
them on to the next owner of your appliance where
applicable.
The operating instructions apply to several models. Differences may therefore occur.
You additionally require the following tool for installation:
crosstip and Torx® screwdriver, 10, 15, 25, 30
Changing over door hinges
Fig. A1: The door hinges can be changed from one side to
the other if need be. Otherwise continue from "Installation
information", fig. B.
W Fig. A1: Lift off cover parts 1, 2 and 3 in a forward
direction.
W Unscrew decor frame 4. Using a screwdriver, lift out
cover plate 5 and hinge pin 6.
W Open the door to an angle of about 45°, then tilt forwards
until the hinge 7 is completely free and lift off.
- If the appliance has a freezer compartment, now change
the compartment door. (see "Changing the compartment
door")
W Transfer the hinge 8 to the other side (screw in through
the second and fourth holes from the outside, using short
metric screws).
- Transfer the hinge pin 9 to the other side.
W Remove the plastic cover bl from the door mounting
and insert on the other side making sure it fits precisely.
Look out for the locking piston.
W Rotate the hinge 7 by 180° and transfer to the other side.
Knock the hinge in from the side!
W Replace the door on the hinge pin 9 at the bottom, guide
it across the hinge 7 at the top and insert hinge pin 6.
W Important - Replace the cover plate 5!
W Screw down decor frame 4. Mount decor panel
(if any, see below). Fit handle (occlude any holes used
with stoppers).
W Rotate cover parts through 180° and re-attach them to
the other side, 1, 2 and 3.
Changing the compartment door*
W Fig. A2: At the hinge 1 fold away the cover.
Unscrew the hinge 1 and remove the compartment door
with the hinge.
W Unscrew the closure 2.
W Close the holes with the plugs 3.
W Rotate the door and closure by 180° and replace on the
other side: Insert the compartment door at the top, put
the hinge 1 in place at the bottom, screw down again
and close the cover.
A2
3
3
2
1
T
orx
15
R
Torx 15
R
Loading...