Congratulations on your purchase. You
have selected a quality product. The instructions for use are a part of the product.
They contain important information about
the safety, use and disposal of the product.
Before using the product, please learn
about all the safety information and usage instructions. Only use the product as
described and for the specified applications. If you lend the product to someone
else, please also give all the instructions.
Intended use
This product is intended for the wireless
transmission of the doorbell signal. The
product is not intended for commercial
use.
Receiver: Indoor use only
Transmitter: Outdoor use (IPX4)
DOCUMENTATION WHEN PASSING
THIS PRODUCT ON TO OTHERS.
Failure to observe the following warnings
may result in death or serious
injuries.
DANGER TO LIFE AND RISK
OF ACCIDENTS FOR INFANTS
AND CHILDREN! Never leave
children unsupervised with the packaging material. There is always a
risk of suffocation if children play
with the packaging material. Children
frequently underestimate the dangers.
Always keep children away from the
packaging material. This product is
not a toy.
This product is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the product by a
person responsible for their safety.
Children should be supervised to ensure they do not play with the product.
Changes or modifications to this
product not expressly approved by
the party responsible for compliance
could void the user‘s authority to
operate the product.
Note: This product has been tested
and complies with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in a residential installation. This
product generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
interference will not occur in a particular installation. If this product
causes harmful interference to radio
or television reception, which can be
determined by turning the product
off and on, the user is encouraged
to try and correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the product into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experi-
enced radio / TV technician for
help.
This product complies with part
15 of the FCC Rules. Operation is
subject to the following two conditions:
nal packaging or in safe place and
away from metal objects that may
short-circuit them.
Exercise care in handling batteries
in order to prevent shorting with
conducting materials, such as rings,
coins, bracelets, and keys. The battery or the conductor can overheat
and cause burns, leakage, fire, or
explosion.
Clean the battery contacts and also
those of the product prior to battery
installation. Keep the contacts clean.
Remove batteries from the product
that will not be used for an extended
period of time (months or longer).
Remove discharged batteries from
product promptly to avoid possible
damage from leakage.
ton / coin cell batteries. If a new
or used lithium button / coin cell
battery is swallowed or enters the
body, it can cause severe internal
burns and can lead to death in as
little as 2 hours. Always completely
secure the battery compartment. If
the battery compartment does not
close securely, stop using the product, remove the batteries, and keep
it away from children. If you think
batteries might have been swallowed or placed inside any part
of the body, seek immediate
medical attention.
teries properly. Keep them away
from children. Even used cells
may cause injury.
SAVE THESE
INSTRUCTIONS
Assembly
Note: Remove all packaging materials
from the product.
Note: You will need a screwdriver and
a drill to assemble the product.
Note: Only use the screws and dowels
supplied for the assembly of the product.
Mount the receiver (see Fig. D).
Mount the transmitter (see Fig. E).