Libiao Robotics LBAP-102LU-900 Instruction Manual

ZheJiang Libiao Robotics Co.,Ltd.

LBAP-102LU-900 Wireless Communication

Device

Instruction Manual

V1.0

2018.7

Note: The picture of this manual is for reference only.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.

Catalogo

1. Product Introduction .……………………………………..1

1.1 Product series…………………………………………………………………..………….....1

1.2 Product Usage…………………………………………………………………………….… 1

1.3 Product Features ……………………………………………………………………...……1

1.4 Electrical Specification…………………………………………………….……………….. 1

1.5 Electrical Parameter…………………………………………………………………..……...2

2. Product Structure and Composition……………………..2

2.1 Product Appearance Structure and Size …………………………………………………..….3

2.2 Panel Wiring Instructions ……………………………………………………………..….3

3. Product Usage Setting Instructions……………………....4

3.1 Reset……………………………………………………………………………..…………..4

3.2 Wired communication interface Instructions…………………………………..…………….5

3.3 Antenna Connection ……………………………………………………...………………5

3.4 Device IP Settings instructions……...……………………………………………...…………5

4. Minimum System Topology……………………...………..7