
E-MVGAMAM-M Technical Specifications
E-MVGAMAM-M Technical Specifications
Micro VGA with Stereo Audio Cable Assembly
Rev. 140120
The E-MVGAMAM-M cable is designed to be used in
tabletop, podium, and presentation system applications. A
very flexible UL listed cable to permit sharp bends and
constant movement, this product is ideal to interface mobile
content users with laptops to the video infrastructure. The
audio lead is purposefully longer at 22 inches for the source
side, this is especially helpful when the audio jack is on the
opposite side of the video jack.
The cable is a miniature coaxial cable design; the attenuation on 32 AWG coaxial cables is such that we
only warrant 1920x1200 WUXGA to 25 feet. Care must be exercised if using this product to interface to
passive wall plates and panel junctions as the loss budget could be exceeded by the combination of
passive plates and cable attenuation issues. It is recommended the primary use be to patch a source to a
display interface, extension device, or active switch. This product is not permitted to be run in a
concealed location (in-wall) per the NEC® unless it is in conduit.
The Micro sized molding on the VGA connectors is
substantially smaller than a standard molded VGA connector.
The molding measures 1.09 inches from front of molding to
back of strain relief. A standard VGA mold can measure 2.0
inches from front to back. The micro cable is only 0.200” in
diameter.
Key Features:
• Smaller low profile molding
• VGA with stereo audio
• Long audio lead on source side
• Tabletop and podium applications
• Flexible cable
• Convenient cable lengths
Key Applications:
• Conference Room
• Classroom
• Podium/Presentation
11675 Ridgeline Dr. Toll-Free: 800-530-8998
Colorado Springs, CO 80921 Fax: 719-260-0075

E-MVGAMAM-M Technical Specifications
Technical Specifications
I/O Connections
VGA Male DE series 15 pin High Density connector
Analog Audio 3.5 mm TRS plug
VGA + 3.5mm Supported Video and Audio
VGA Maximum Supported Video Resolution Up to 1920x1200@75Hz up to 25 feet
Analog Audio Support Up to 48 kHz sampling rate
VESA Full EDID ID/DDC Plug and Play with pin 9 connected
Cable Construction
VGA Connector Material Molded PVC
VGA Connector Dimensions 33x14x28mm
Analog Audio Connector Material Molded PVC
Analog Audio Connector Dimensions 10.3mm diameter, 36.75mm length with strain relief included
Jacket Material Flexible PVC
Cable Construction Copper, 32 AWG RGB coaxial and 30 AWG sync and ID-Bit
Overall Cable Size 5.0mm diamete
Shielding Dual foil and tinned copper braid serve shields
Minimum Bend Radius 50mm
Maximum Tensile Load 10Kg
Available Cable Lengths 3, 6, 12, 15, 25 feet
Environmental Requirements
Operating Temperature 0° to +50° C (+32° to +122° F)
Operating Humidity 20% to 85%, Non-condensing
Storage Temperature -30° to +50° C (-22° to +122° F)
Storage Humidity 20% to 85%, Non-condensing
Power and Regulatory
Regulatory AWM 20276 80°C 30V VW-1, RoHS
Liberty Wire & Cable specifications are subject to change without notice. Contact an account representative for current product specifications. Liberty Wire & Cable continuously
strives to ensure product specifications are accurate and complete. All physical specifications are nominal.
Part Numbers
Part Numbers Cable Length Description
E-MVGAMAM-M-3 3 feet (0.91M) Micro Molded VGA cable with stereo audio 3 feet long
E-MVGAMAM-M-6 6 feet (1.83m) Micro Molded VGA cable with stereo audio 6 feet long
E-MVGAMAM-M-12 12 feet (3.66m) Micro Molded VGA cable with stereo audio 12 feet long
E-MVGAMAM-M-15 15 feet (4.57m) Micro Molded VGA cable with stereo audio 15 feet long
E-MVGAMAM-M-25 25 feet (6.35m) Micro Molded VGA cable with stereo audio 25 feet long
11675 Ridgeline Dr. Toll-Free: 800-530-8998
Colorado Springs, CO 80921 Fax: 719-260-0075