Liberty 636 User Manual

Liberty 636

Liberty 36v Folding Bike

User Manual

Thank you for your decision to buy this product.

Please use this product according to the instructions.

Please keep the instructions in a handy place.

Liberty 636 Folding Electric Bike

.

36 Volt/10 ah Li-ion

1

Introduction

Dear Customer,

Wow! You are excited! You have just received your brand new ebike. We, too, are excited because as designers and developers of our
bikes, we love to make you happy, and we believe your new ebike will give you lots of fun. I know you want to get this bike on the
road immediately, but please STOP!

Why? Well, first of all, you need to charge your batteries fully before using them. So, while your ebike is charging, take the time to
read this manual. We have worked hard to make it as readable as possible. This manual will help prevent injury and teach you how to
care for your new ebike.

It is the owner’s responsibility to carefully read all of the contents of this manual and to comply with all laws pertaining to the

operation of bicycles and/or electric bicycles in your local jurisdiction. If you have any questions, please consult with the laws web
page on www.iloveEbikes.com or consult your local department of motor vehicles for clarification.

These electric bikes are not classified as motor vehicles, however, to drive them on the roads various states have differing laws.

We have worked hard to provide you a quality, well-designed product without defects. That is our responsibility. You, too, have a

part to play. With proper care, maintenance and attention to bicycle safety rules, your ebike will give you years of enjoyment.

Please read the instructions carefully before using your ebike. Do not ride this bicycle until you have read and thoroughly

understand the owner’s manual. It contains information critical to your safety. If you have questions about the operation of this electric
bicycle, consult your authorized dealer. It is extremely important that you follow the safety guidelines contained in this manual in
order to ensure your maximum safety. If you loan your bike to anyone, make sure they also know how to operate it safely.

When using, the load should not be greater than the maximum capacity, and please pay attention to increase the braking distance

during rainy or snowy days.

This ebike can operate in the rain and snow, but it CANNOT be submerged in water. When the motor is submerged in water, it

may short circuit and fail, which is NOT covered by the warranty.

Please don't dismantle and repair the spare parts by yourself, but go to the local dealer.
Please take time to record the following information:

Recording Your Ebike Info

Serial
Number: _______________________________________________________

Model: ___________________636________________________________

Color: _______________________________________________________

Date of
Purchase: _______________________________________________________

Dealer’s Name: _______________________________________________________

Dealer’s Ph. #: _______________________________________________________

Dealer’s Email: _______________________________________________________

The serial number is stamped on the
motor.

.

2

Important Instructions

Safeguard your battery to insure continued high performance. It should be recharged after each use. The normal full-cycle battery

life, if it is continuously discharged and recharged, is between 300–1000 cycles (depending on which battery came with your bike)

after which the storage capacity of the battery will gradually decline.

CAUTION! Fully charge the batteries before the first use!

Failure to do this can result in decreased battery performance for the life of the bike. Fully charge the battery each time you use the

bike.

Battery performance is affected by the temperature and is generally better in warm temperatures. When the temperature is below
32º F (0º C), the battery current may decrease by a third. Consequently, the travel range on a full charge in cold environments is much
less, but will return to normal when the temperature is back to room temperature.

Frequent stopping and starting, riding uphill, traveling against a strong wind, starting from a standstill, riding on rough or muddy
roads, and carrying more than one person or heavy loads will consume extra battery power and shorten the range. A few tips to
prolong the battery life during these conditions is as follows:

Frequent braking – try to look ahead and coast rather than frequently stopping and starting.
Riding uphill or against a stiff wind – pedal to supplement the battery power.

When starting from a standstill, use the pedals to help bring you up to speed.
When the battery meter indicates the voltage is low, switch to manual power and avoid using the battery, so you don’t

shorten the battery life.

To prevent premature failure of your battery and for your warranty to remain in effect on your battery, YOU MUST CHARGE

AND DISCHARGE THE BATTERY AT LEAST ONCE PER MONTH.

Always turn off the motor and remove the key from the ignition before and during charging to

prevent serious damage to the controller and to the batteries!

This electric bicycle can be used in the rain, however, the motor and other electrical parts must not be submerged in water.
The controller, motor and other electrical devices may be short circuited causing damage, which is NOT covered by warranty, and
creating possible dangerous situations.

DO NOT use chargers or other components other than that which has been approved

and tested by this company. This company is not responsible for damages caused by the use of other
products not specifically designed and tested for use with this electric bike.

Battery chargers contain sensitive electronics. Improper use, dropping, or sudden jolts can damage the charger and its internal
electronics which is NOT covered by warranty. Do not leave the charger on for more than 10 hours!

Check all nuts, bolts, screws, and spokes to make sure they are tight before riding. If any screws, nuts, or bolts are loose, put some
thread lock on the threads and then tighten.

When riding down hill, you MUST have the key on even if you are NOT using the
throttle and even if the battery is not in the bike. The motor will generate enough
electricity to RUIN your controller which is NOT covered by warranty.

.

3

Table of Contents

...............................................................................................................Introduction 2

...............................................................................................Important Instructions 3

......................................................................................................Table of Contents 4

..................................................................................................................Assembly 5

.....................................................................................................Safety Precautions 7

.................................................................................General Operating Instructions 8

................................................................Battery Charging and Battery Precautions 9

................................................................................Specific Operating Instructions 10

.............................................................................................................Maintenance 11

........................................................................................................Troubleshooting 12

...................................................................................................................Warranty 13

.......................................................................................Federal Electric Bike Law 14

.

4

ASSEMBLY

Only minimal assembly is required for your new ebike. You will be required
to do the following:

Unfolding the Frame

The frame of your bike folds in the middle. The quick-release latch is
released and lifted up to allow the locking pin to release and unfold the bike.

Insert Upper Handlebar Stem

Your bike upper handlebar stem is inserted into the lower stem and is
tightened with the quick-release handle as in picture. You can snug up the
quick release with the hand nut opposite the handle to get the proper
tightness.

Unfold the Handlebars

Unfold the handlebars and lock into place.
The hinge has a quick-release that is released

Handle
Folding

and slid off the base and then needs to be slid
to one side to unlock the hinge.

Unfolding Frame

Tighten Handlebar

Loosen bolt

Adjusting the Seat

The seat is adjusted with the quick-release.
The tightness of the quick-release clamp can
be adjusted with the hand nut on the opposite

side of the handle.

Fastening Headlight

To fasten the headlight follow the steps
below:

1. Loosen the bolt that holds the front fender.

2. Slide front headlight bracket onto the bolt
that you removed. For best performance, turn
the nut so the hex head fits into the slot on
the headlight bracket.

3. We recommend you use threadlock on all
bolts and nuts to insure that they do not

vibrate loose during use.

4. Tighten hex head with a 10mm wrench to
make sure headlight is at the correct angle
for shining on the path ahead.

Seat Release

Tighten Headlight Bracket

.

5