LG Motorsports G5 User Manual

LG G5 Chassis Brace

Gen 5 Camaro

“THE MOST POWERFUL HEADERS ON THE PLANET”

Brought to you by LG Motorsports

972-429-1963

Thank you for purchasing LG Motorsports products for your Gen 5 Camaro.

Parts Inventory:

1. Driver side rear subframe brace

2. Passenger side rear subframe brace

3. Driver side mid bar

4. Passenger side mid bar

5. Front X brace

6. two small single, nut plates

7. two double, nut plates

8. (4) 12 x 1.75mm ny-lock nuts

9. (6) 12 x 1.75 mm x 60mm long bolts

10. (7) 12 x 1.75 mm x 45mm long bolts

11. (2) 16 x 2.0 mm x 80mm long bolts

12. (12) 10 x 1.5mm x 45mm long bolts

13. (2) tube frame nut inserts

14. (2) 16mm Washers

15. (17) 12mm Washers

16. (12) 10mm Washers

Instructions:

Support

Start by supporting the car on a lift, or 4 jack stands on a level surface about two
or more feet off of the ground. Disconnect negative battery cable before any work
begins. Try to support the car from the suspension arms as we will need access to the
chassis.

You will need to remove the center tunnel brace that spans the center tunnel. Set
this and the bolts aside. You will reuse the brace but not the bolts for the install.

Figure 1: Center tunnel brace removal.

Install:

To begin the install start at the rear of the car mocking up one side of your chassis
brace to familiarize yourself with the bolt locations that you will be using. We will be
using all factory hole and nut locations on the car so no drilling is required into your car
for this install.

Figure 2: Rear subframe mockup

First we will need to install the four supplied nut plates into the chassis. The two
small single nut plate pieces will go on the outside part of the frame and hold in the one
single bolt location outside of the fuel tanks.