LG Electronics USA VC100 Users Manual
User Manual
LG-VC100
Ver. 1.0
2014. 06. 05
- 1 -
LIMITED WARRANTY STATEMENT
1. WHAT THIS WARRANTY COVERS:
LG offers you a limited warranty that the enclosed subscriber unit and its enclosed accessories will be
free from defects in material and workmanship, according to the following terms and conditions:
(1) The limited warranty for the product extends for ONE (1) year beginning on the data of purchase
of the product.
(2) The limited warranty extends on to the original purchaser of the product and is not assignable or
transferable to any subsequent purchaser/end user.
(3) This warranty is good only to the original purchaser of the product during the warranty period as
long as it is in the U.S., including Alaska, Hawaii, U.S. Territories and Canada.
(4) The external housing and cosmetic parts shall not be covered under these limited warranty terms.
(5) Upon request from LG, the consumer must provide information to reasonably prove the date of
purchase.
(6) The customer shall bear the cost of shipping the product to the Customer Service Department of
LG. LG shall bear the cost of shipping the product back to the consumer after the completion of
service under this limited warranty.
2. WHAT THIS WARRANTY DOES NOT COVER:
(1) Defects or damages resulting from use of the product in other than its normal and customary
manner.
(2) Defects or damages from abnormal use, abnormal conditions, improper storage, exposure to
moisture or dampness, unauthorized modifications, unauthorized connections, unauthorized repair,
misuse, neglect, abuse, accident, alteration, improper installation, or other acts which are not the
fault of LG, including damage caused by shipping blown fuses spills of food or liquid.
(3) Breakage or damage to antennas unless caused directly by defects in material or workmanship.
(4) That the Customer Service Department at LG was net notified by consumer of the alleged defect
or malfunction of the product during the applicable limited warranty period.
(5) Products which have had the serial number removed or made illegible.
(6) The limited warranty is in lieu of all other warranties, express or implied either in fact or by
operations law, statutory or otherwise, including, but limited to any implied warranty of
marketability or fitness for a particular use.
(7) Damage resulting from use of non-LG approved accessories.
(8) All plastic surfaces and all other externally exposed parts that are scratched or damaged due to
normal customer use.
(9) Products operated outside published maximum ratings.
- 2 -
(10) Products used or obtained in a rental program.
(11) Consumables (such as fuses).
3. STATE LAW RIGHTS:
No other express warranty is applicable to this product. THE DURATION OF ANY IMPLIED
WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MARKETABILITY, IS LIMITED
TO THE DURATION OF THE EXPRESS WARRANTY HEREIN. LG INFOCOMM INC. SHALL
NOT BE LIABLE FOR THE LOSS OF THE USE OF THE PRODUCT, INCONVENIENCE, LOSS
OR ANY OTHER DAMAGES, DIRECT OR CONSEQUENTIAL, RISING OUT OF THE USE OF,
OR INABILITY TO USE, THIS PRODUCT OR FOR ANY BREACH OF ANY EXPRESS OR
IMPLIED WARRANTY, INCLUDING THE IMPLIED WARRANTY OF MARKETABILITY
APPLICABLE TO THIS PRODUCT. Some states do not allow the exclusive of imitation of incidental
or consequential damages or limitations on how long an implied warranty lasts; so these limitations or
exclusions may not apply to you. This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.
4. HOW TO GET WARRANTY SERVICE:
To obtain warranty service, please call the following telephone number from anywhere in the
continental United States:
LG Infocomm Inc.
201 James Record Road Huntsville, AL 35824
Tel. 1-800-793-8896 Fax. 1-800-448-4026
www.lgeservice.com
DO NOT RETURN YOUR PRODUCT TO THE ABOVE ADDRESS. Please call or write for the
location of the LG Electronics, Inc authorized service center nearest you and for the procedures for
obtaining warranty claims.
- 3 -
SUBJECT
CDMA Standard
Designator
Description
Basic air interface
TIA/EIA-95A
TSB-74
ANSI J-STD-008
TIA/EIA-IS2000
CDMA Dual-Mode Air Interface
14.4kbps radio link protocol and inter-band
operations
IS-95 adapted for PCS frequency band
CDMA2000 1xRTT Air Interface
Network
TIA/EIA/IS-634
TIA/EIA/IS/651
TIA/EIA/IS-41-C
TIA/EIA/IS-124
MAS-BS
PCSC-RS
Intersystem operations
Nom-signaling data comm.
Service
TIA/EIA/IS-96-B
TIA/EIA/IS-637
TIA/EIA/IS-657
IS-801
Speech CODEC
Short message service
Packet data
Position Determination Service (gpsOne)
Performance
TIA/EIA/IS-97
TIA/EIA/IS-98
ANSI J-STD-018
ANSI J-STD-019
TIA/EIA/IS-125
Cellular base station
Cellular mobile station
PCS personal station
PCS base station
Speech CODEC
The LGVC100 has been designed to operate on the latest digital mobile communication
technology, Code Division Multiple Access (CDMA). The LGVC100 support 72poly Audio, etc.
This device operates in one of tri band Quad mode - 800Mhz CDMA, 1900Mhz PCS, 1500Mhz
GPS.
* TSB –74: Protocol between an IS-95A system and ANSI J-STD-008
- 4 -
Introduction
Highlights
Congratulations! Your new mobile device will change your way of communicating and is a
compact, lightweight personal communication system with added features for the person on the
go. Our advanced digital mobile communication technology allows you to do the followings
1) Main Chipset : QSC6055, Memory(Memory (Flash+RAM 1Gb/512Mb)
2) CMX 5.0 compliant (72 Poly)
3) GPS(gpsOne)
Important Information
This user’s guide provides important information on the use and operation of the device.
Please read all the information carefully prior to using the device for the best performance and
to prevent any anticipated damage to or misuse of the device. Any unapproved change or
modification will void your warranty.
Check Accessories
Your wearable device comes with standard accessory of a one-slot desktop charger. Please
make sure that this accessory is included.
- 6 -
Before You Start
Safety Instructions
WARNING! To reduce the electric shock, do not expose your device in high humidity areas,
such as the bathroom, swimming pool.
IMPORTANT! Please read the SAFETY AND GENERAL INFORMATION on page 68 prior to
using your device.
FCC RF Exposure Information
WARNING! Read this information before operating the device.
In August 1996 the Federal Communications (FCC) of the United States with its action in Report
and Order FCC 96-326 adopted an updated safety standard for human exposure to radio
frequency (RF) electromagnetic energy emitted by FCC regulated transmitters. Those
guidelines are consistent with the safety standard previously set by both U.S. and international
standards bodies. The design of this product complies with the FCC guidelines and these
international standards.
CAUTION
Use only the supplied or and approved antenna. Use of unauthorized antennas, modifications
could impair call quality, damage the device or result in violation of FCC regulations. Do not use
the device with the damaged antenna. If the damaged antenna comes into contact with the skin,
a minor burn may result. Please contact your local dealer for replacement of the antenna.
Body-worn Operation
This device was tested for typical bodyworn(Wrist) operations with the back of the device kept 0
inches (0cm) between the user’ s body(Wrist) and the back of the device.
And this device was tested for typical Next-to-Mouth(Face) operations with the front of the
device kept 0.39 inches (1cm) between the user’ s mouth(Face) and the front of the device.
To comply with FCC/IC RF exposure requirements, a minimum separation distance of 0.39
inches (1cm) must be maintained between the user’ s mouth(Face) and the front of the device.
Any accessories containing metallic components may not be used.
Specific Absorption Rate (SAR) values
Your product is a radio transmitter and receiver. It is designed and manufactured not to exceed
the emission limits for exposure to Radio Frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. The standards include a substantial
- 7 -
safety margin designed to assure the safety of all persons, regardless of age and health.
2.30
The exposure standard for wireless mobile phones employs a unit of measurement known as
the Specific Absorption Rate, or SAR. In the United States and Canada,
the SAR limit for wrist watch used by the public is 1.6 watts/kg (W/kg) averaged over one gram
of tissue or 4.0 watts/kg (W/kg) averaged over ten gram of tissue.
Tests for SAR are conducted using standard operating positions specified by the FCC with the
product transmitting at its highest certified power level in all tested frequency bands.
Although SAR is determined at the highest certified power level, the actual SAR level of the
product during operation can be well below the maximum value.
Because the product is designed to operate at multiple power levels and to use only the power
required to reach the network, in general, the closer you are to a wireless base station antenna,
the lower the power output.
The highest SAR value for this model product when tested for use at Next-to-Mouth(Face) is
0.76 W/kg(1g) and for body-worn(Wrist) is 2.18 W/kg(10g).
While there may be differences between SAR levels of various phones and at various positions,
they all meet the government requirement for safe exposure.
The FCC has granted an Equipment Authorization for this model product with all reported SAR
levels evaluated as in compliance with the FCC RF emission guidelines.
SAR information on this model product is on file with the FCC and can be found under the
Display Grant section of http://transition.fcc.gov/oet/ea/fccid/ after searching on FCC ID
ZNFVC100.
Additional information on Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Association (CTIA) website at http://www.ctia.org/.
* Product meets current FCC & IC Radio Frequency Exposure Guidelines
FCC Part 15.19 Statement
This device and its accessories comply with part 15 of FCC rules. Operation is subject to the
following two conditions: (1) This device and its accessories may not cause harmful interference,
and (2) this device and its accessories must accept any interference received, including
interference that cause undesired operation.
FCC Part 15.21 Statement
Change or Modifications that are not expressly
approved by the manufacturer could void the user’ s authority to operate the equipment.
- 8 -
FCC Part 15.105 Statement
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference with radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference or television reception, which can be determined by turning the
equipment off and on, you can try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution For Battery Use
Do not disassemble.
Do not short-circuit.
Do not exposure to high temperature : 60 (140 )
Do not incinerate.
Caring for Battery Use
Must be recycled or disposed of properly
Consumer Recycling Information and Logo
Wireless…The New Recyclable
Your wireless device can be recycled. Recycling your wireless device reduces the amount of
waste disposed in landfills and allows recycled materials to be incorporated into new products.
- 9 -
Loading...