LG Electronics USA SA565JP User Manual

Interactive Function

69

(For SA565 only)

Interactive Function

To Connect the Interactive Pen to the PC

'N% $ % " ‚ • 'N% 6‰(+ ) $ ( )’N Š and a PC USB port.

Connect the interactive dongle to the projector's INTERACTIVE port.

Pairing

#CAUTION

Up to two pens can be used at the same time.

Pairing is not available when one of the paired pens is in use.( ` ! | 9 " 67 "

You must install the WizTeach program in the CD provided with the accessories on your PC before using the Annotation Software .

( " G7 # # # power mode. Press any button to return the pen to normal mode.

Use the remote control within the specified range (see "Operating Range with ( | œŠ … " ! "" # 9 device outside the coverage area or if there are obstacles within the coverage area.

… " ! "" 9 such as a microwave oven and wireless LAN operate in the same frequency band ‰= J 35ƒŠ " ""

Make sure not to block the image when using the interactive pen.

70 Interactive Function

(For SA565 only)

Using The Interactive Pen

Interactive Pen and Button

Front	Back

Function/ Button

Description

Power Button Turns the interactive pen on/off.

	Used for pairing.
	Functions the same as a right mouse button.
	Functions the same as a left mouse button.

USB charging port Charges the product using the charging cable.

Eyelet for strap Connects the strap to the interactive pen.

		LED		Shows the battery status.
		Indicators		Shows the pen status.
		Firmware upgrade		' 9 "#
		port		maintenance.
		Pen tip		… # ! # 9 9 |

Interactive Function

71

(For SA565 only)

Using the Interactive Pen Button

Function			Description
Left Mouse Click	Press the	button or push the Pen tip.
Right Mouse Click	Press the	button.
	Go to Interactive and set Pairing Mode to Fixed. Then,
Enter Fixed mode	press and hold the		button more than three seconds within
	ten seconds.
Enter Open mode	Press both the pen's		button and button simultaneously
	for 3 seconds.
Wake Up	Press any one of the		button, button, or button.
	Or, push the pen tip.

Make sure that the interactive pen is not pointing toward the screen when entering each mode.

#CAUTION

If there are foreign objects or dust on the lens at the tip of the interactive pen, gently wipe with a cotton swab.

Foreign objects or dust on the lens surface may cause malfunction of the interactive pen.

72 Interactive Function

(For SA565 only)

To Charge the Interactive Pen

To charge the battery, connect the interactive pen to the PC with the charging cable. (Check that the PC is turned on before connection.)

The battery light stays on during charging and will turn off when charging is complete.

When charging is complete, disconnect the charging cable in order to use it. Alternatively, use the interactive pen while connected by the charging cable if charging is not complete.

Warning message (low battery)

- When the battery voltage is 3.6 V or lower, the low battery warning message is displayed. The interactive pen will

# ; 67 " message is displayed.

- The interactive pen may not work when the battery level is 3.4 V or lower.

When you use the pen for the first time, charge the battery for at least 3 hours.9 =7 when it is continuously used, or four weeks in standby mode.

#ZDUQLQJ

Do not replace or repair the battery yourself.

To charge the interactive pen, use the charging cable provided to connect the pen to USB port of the PC.

Interactive Function

73

(For SA565 only)

Description of LED Interactive Pen Indicators

			OHG#4		OHG#5
Pen Operation		LED Indicators
		(LED 1)			(LED 2)
Charging battery	The green light is on				-
Battery charging		#OHG#7			-
required	#4	#
Open Mode				The green light quickly
- Searching a projector		-
				z #
to connect
` ! /				9 9 z
- Searching a projector		-		# !
to connect				second.
Attempting to pair		-		9 9 z
				quickly.
Enter Open mode, or		-		9 9 # z
pairing is complete				three times.
Pairing failed		-		9 # z
				"
The pen is connected to		-		9 9 z
the projector				three seconds.
When the pen is pointing		-		9 z 9
the projector screen				quickly.
Entering low power	9 z			9 z
mode	once.			once.

) 6 ) = of the interactive pen.

74 Interactive Function

(For SA565 only)

To Replace the Pen tip

‡ # # 9 #

Open	Close
Turn the pen tip to the right to	Turn the pen tip to the left to
remove it from the interactive	install it onto the interactive
pen, as shown in the figure	pen, as shown in the figure
below.	below.

How to Use the Strap

Use the strap to prevent dropping the interactive pen. Use the pen safely so as not to cause injury or damage to nearby objects.

#CAUTION

Be sure to wear the strap on your wrist when using the interactive pen.Store the interactive pen in the hard case.

Interactive Function

75

(For SA565 only)

Operating Range with Interactive Pen

( 9 # ; # ƒ <@= "" * =?J7 ""You can use two Interactive pens at the same time.

Actual operating range may slightly differ from the diagram.

If the projector screen darkens due to the surrounding environment, the operating range of the interactive pen may be affected.

Operating range

Angle Distance

7 „

9 m

Angle

=7 „ 7m

J? „ 5m

Angle

Distance

Distance

Screen

76 Interactive Function

(For SA565 only)

To Use the Interactive Pen Functions

Make sure that the Computer/Laptop screen is displayed on the projector screen.

237,21

				,QWHUDFWLYH 6LQJOH 3HQ
		ؒ	/DQJXDJH	&KDQQHO $XWR
		ؒ	6HW ,'
				ؒ 6HW &KDQQHO
		ؒ 3-7 PRGH
				3HQ 6HWWLQJ
		ؒ	.H\6WRQH
				ؒ 3DLULQJ 0RGH 2SHQ
		ؒ	%ODQN ,PDJH
		ؒ $XWR 3RZHU
				&ORVH
		ؒ	,QWHUDFWLYH

4#Press the MENU button.

5#Select OPTION using the and&{

6#Select Interactive using the , , and &{

-To return to the previous screen, press the button.

7#Select which item you want using the, , and buttons, and press&{

0##After the settings have been changed, press the Close button to close the window.

The interactive function settings are as follows:

Item	Description
Interactive	There are four function modes: Off/Single, Pen/Double, or Pen/Multi
	Touch.
	Off: Disables the interactive pen function.
	Single Pen: Use one interactive pen.
	Double Pen: Use two interactive pens at the same time.
	(It is recommended to install the WizTeach program
	provided on your PC prior to use.)
	Multi Touch: Use various functions, such as zoom in, zoom out,
	or rotation, with two interactive pens.
	(Supported in Windows 7 only)
channel	You can select a channel in Auto or Manual mode.
	Auto: A channel is automatically selected.
	Manual: Select a channel manually.
Set Channel	$ " ! " " => ‰7 * =8Š
Pairing Mode	N 9 " & ` !
	Open mode: Follow the on-screen instructions to set the interactive
	pen to Open mode.(While the interactive pen is pointing at a screen,
	the pen can be used with any projector.)
	` ! " 0 ` # *
	` ! " (The interactive pen can be used only with a
	paired projector.)
	* ' 67 ‚