LG Electronics USA PF80AJE Users Manual

SAFETY INSTRUCTIONS

Remove the plug from the outlet

before cleaning the product.

- Otherwise, this may result in electric shock.

Others

WARNING

When you go out, place the projector

out of reach of animals, and remove the power plug from the wall outlet.

- Using a damaged power cord may result in short circuit or fire.

Do not use the projector near high-

precision electronic devices or those that transmit weak radio signal.

- This may affect the operation of the product, causing an accident.

Only a qualified technician can

disassemble or modify the projector. For diagnosis, adjustment, or repair, contact your seller or our service center.

This may result in fire or electric

shock.

Do not stare directly into lens when in

operation, eye damage can occure. No user serviceable parts inside unit.

High voltage parts can cause shock

and even electrocution. Proper ventilation required, do not

block airflow around unit. Doing so can cause injury and internal overheating. To prevent damage to lamp, unit must

remain plugged in for approximately 3 minutes after power down to allow for proper cool down (not applicable on LED models).

Do not touch the lens; doing so can

result in burns or damage to lens.

Lens and unit may be HOT during

and immediately after use. Use caution when handling unit, allowing for proper cool down. Only use a grounded electrical outlet.

Do not insert anything into or cover

up the exhaust vents.

This may result in fire or electric shock.

Follow all maintenance guidelines

for optimal use; service only at an authorized service center. Lamp contains mercury and as such

must be disposed of according to local, state and federal laws (not applicable on LED models).

CAUTION

Do not mix new batteries with old

ones.

Burst or leaking batteries may result

in damage or injury.

Be sure to unplug if the projector is not

to be used for a long

- Accumulated dust may result in fire or electric shock tion, or poor insulation.

Only use the specified type of battery.

Burst or leaking batteries may result in

damage or injury.

Do not charge the battery using any

devices other than the one provided with the product.

This may result in damage to the

battery or fire.

period

due to overheating, igni-

Dispose of used batteries properly.

This may result in explosion or fire. The correct method of disposal may vary depending on your country or region. Dispose of the battery pack as instructed.

Do not throw or disassemble the battery.

- This may result in fire or explosion due to damage to the battery.

Store batteries away from metallic

objects, such as keys and paper clips.

Excess current may cause a rapid increase in temperature, resulting in fire or burns.

Do not store the batteries near any

heat source, such as a heater.

- This may result in fire or damage to

the product. Do not store batteries at temperatures

higher than 60 °C or in high humidity.

- This may result in explosion or fire.

Keep the batteries and remote out of

reach of children.

- This will prevent personal injury or

damage to the product. Make sure that the battery is installed

correctly.

- This prevent explosion or fire.

The battery contains lithium-ion, so it

must be handled with care.

- This may result in explosion or fire.

Make sure you use the same type of

batteries for replacement. Incorrect battery replacement may

cause fire.

SAFETY INSTRUCTIONS

Risk Group 2

CAUTION: Hazardous optical radiation may be emitted from this product. Do not stare into the lens at the operating lamp. It may be harmful to your eyes.

SAFETY INSTRUCTIONS

FCC NOTICE

Federal Communications Commission (FCC) Statement

You are cautioned that changes or

modications not expressly approved

by the part responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving

antenna.

- Increase the separation between the

equipment and receiver.

- Connect the equipment into an outlet

on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced

radio/projector technician for help.

This device complies with Part 15 of the

FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful

interference, and

2) This device must accept any interference received, including interference that may cause undesired operation of the device of the device.

FCC Caution

Any changes or modications not

expressly approved by the party responsible for compliance could void the user's authority to operate this equipment and for indoor use only, use outdoors or in other modes not covered by this manual may violate the FCC regulation and violate the user authority to use the product.

Specially, within the 5.15-5.25 GHz

band, U-NII device is restricted to indoor operations to reduce any potential for harmful interference to co-channel MSS operations.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and

operated with minimum distance 20 cm (7.8 inches) between the radiator

and your body. End users must follow

the specic operating instructions for

satisfying RF exposure compliance.

SAFETY INSTRUCTIONS

IC (CANADA)

Industry Canada Statement:

This device complies with RSS-210 of

the Industry Canada Rules. Operation is subject to the following two conditions:

1) this device may not cause

interference and

2) this device must accept any interference, including interference that may cause undesired operation of the device.

Avis d’Industrie Canada :

Cet appareil est conforme à la norme

CNR-210 des règlements d’Industrie

Canada. Son fonctionnement est sujet aux deux conditions suivantes :

1) Cet appareil ne doit pas provoquer

d’interférences et

2) Cet appareil doit accepter toutes les interférences, y compris celles pouvant entraîner son dysfonctionnement.

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.

NOTE: THE MANUFACTURER IS NOT

RESPONSIBLE FOR ANY RADIO OR Projector INTERFERENCE CAUSED

BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Avis d’Industrie Canada sur l’exposition aux rayonnements

Cet appareil est conforme aux limites d’exposition aux rayonnements d’Industrie Canada pour un environnement non contrôlé.

REMARQUE : LE FABRICANT

N’EST PAS RESPONSABLE DES INTERFÉRENCES

RADIOÉLECTRIQUES CAUSÉES

PAR DES MODIFICATIONS NON AUTORISÉES APPORTÉES À CET APPAREIL. DE TELLES MODIFICATIONS POURRAIT ANNULER L’AUTORISATION ACCORDÉE À L’UTILISATEUR DE FAIRE FONCTIONNER L’APPAREIL.

+ 8 hidden pages