LG WP-580N User Manual

INSTALLATION

Earth wire

Installation area

Set on flat and firm floor Incorect installation may course severe noise and break down.

Connecting the drain hose

• Connect the drain hose to the outlet of the plunger valve located at the back side of the washing machine.

Maintain more than 10 cm between the side of drain hose and the wall.

A carpet must not obstruct the ventilation openings.

• Push the clamp toward the body of the washing machine as shown in the figure.

INSTALLATION & HOW TO WASH

Connecting the earth wire and the power plugh

●

Install the earth wire to prevent short-circuit due to leaking current and electric shock.

●

It is attached at the back of the washer. Connect it to the metal water pipe. If the water pipe is made of plastic, it does not have the earth effect.

●

Never connect the earth wire to the gas pipe, lightning arrester. telephone connecter, etc.

●

Insert the power plug into the outlet.

●

Before connecting the power plug, check if the voltage setting of the washer matches the out let voltage.

✽ WARNING-THIS APPLIANCE MUST BE EARTHED.

Other earthing method

Earth wire

Gas pipe

Voltage Change (Only for Dual Voltage)

1. Unplug the power cord from the electric outle, Use screwdriver to remove back cover

2. Remove the bag covering the lead wire couplers.

3. To change the voltage setting from 220V to 110(127)V, disconnect the coupler marked "220V" and connect the coupler marked "110(127)V", to change the voltage setting from 110(127)V to 220V, disconnect the coupler marked "110(127)V" and connect the coupler marked "220V".

4. Cover the couplers with the bag and reattach the back cover.

5. Be sure to indicate the new voltage setting on the "Present Voltage" label for future reference.

Before washing

1.Check the washing instruction labels on the clothing to be washed.

2.Remove all objects from the pockets of the clothing.Objects left in the pockets may

 damage clothing or the washing machine (could cause the drain hose to clog).

3.After separating oiled or dyed clothing, wash.

4.For your convenience hang up the wash cover on the right or left side of the washing

 machine tub when not in use.

••••

4 5

Set the desired wash

time.

Wash Timer

When washing is

finished, locate the drain selector to "DRAIN" position and drain the water out.

Non-Pump Model Pump Model

Off

Drain SelectorDrain Selector

Interim spin rinse

Interim spin rinse prior to regular rinsing helps removing sudsy water from the laundry and improve rinsing efficiency. Also is helpful to water saving.

After washing.

Move the laundry into

the spin dryer basket.

Place the safety cover

horizontally on the laundry.

Set the desired spin

flow appropriately.

Spin Timer

After interim spin

rinse, move the laundry into the wash tub for rinsing.

HOW TO SPIN

Note for spinning

Put the laundry evenly into the spin

1. dryer basket.

2. Put the laundry down lightly. Place the safety cover horizontally

3. over the laundry.

4. Close the spin dryer cover.

If the spin dryer basket is off-balance and vibrates excessively, stop the

spinning, rearrange the clothes evenly, and then resume spinning.

6 7

Safety cover

●

After connecting the earth wire to the earth copper plate, bury it at least 75cm deep under the wet ground.

Earth wire

Earth copper plate

Washing

For Non Pump Model

Set the drain selector to "WASH RINSE" posi-

tion.

For Pump Model

Off

Drain Selector

●

75cm

Caution : Don't ro

Connect to the earthing-only outlet.

tate knob over on spot curve. ( )

Fill water till water level

mark"H".That is because clothes can absorb adequate amount of water and water will not

short.

● When installing it in an

area where earthing is not possible, purchase a short-circuit breaker

connect it to the outlet.

Put the appropriate amount of detergent and

the laundry into the wash tub. And add water to the desired water level which you want.

Short-circuit breaker

REFERENCE & AFTER FINISHING HOW TO WASH & HOW TO RINSE

TABLE 1. WEIGHT GUIDE FOR CLOTHES

Type of clothing Type of fabric Weight per piece

Under shirt Cotton 150g(53oz)

Handkerchief Cotton 50g(1.8oz)

Bath towel Cotton 300g(10.6oz)

Shirt Mixed fabric 200g(7.1oz)

Socks (1 pair) Mixed fabric 50g(1.8oz)

Pajama (shirt and pants) Cotton 500g(17.6oz)

Winter undershirt Cotton 600g(21.2oz)

Workclothes Mixed fabric 800g(28.2oz)

Blouse Mixed fabric 200g(7.1oz)

TABLE 2. GUIDE FOR WASHING

23..

Disconnect the power cord from the electrical outlet.

6. If washing and spinning must be operated together, starting washing and

TROUBLESHOOTING GUIDE

Before Requesting Service

Motor does not operate, Is the power cord firmly plugged in?

Spin dryer basket does Is there any clothing dropped between the basket and tub? not operate.

No draining

For Non-Pump Model

For Pump Model

Water level Amount of water Amount of detergent

H (Maximum Level)

Remove the laundry from the spin dryer basket and close the spin dryer cover.

If there is water in the wash tub, set the drain selector

to "DRAIN" (For Pump Model Only : and then put it back to )

Clean the washing machine.

For Pump Model Only

Ensure without fail the drain selector is turned to

spinning operation shall be done at the same time to cope with EMC requirement.

in order to drain it out.

Problem Checking point

Is the timer turned to a suitable point except "OFF" ?

Is the spin dryer cover closed? Is the laundry gathered to one side of the spin dryer basket? Is there lint stuck in the plunger valve? Is the end of the drain hose guide located at an exceed height? Is the drain pump operated?

L 34g

"OFF"

"OFF" Position after using