LG WP-1460RWN Instruction manual

9

READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE USE.

Follow all instructions in this manual to minimize the risk of fire, electric shock
and to prevent property damage, personal injury or loss of life.

Do not install in areas exposed to snow,
rain or to the weather.

Install the washing machine on a horizantal
support. Otherwise it may cause vibration
and noise.

Spin Motor

After continuous using spinning program
3 times, please stop spinning more than
1 hour. Otherwise the spin motor clude be
damaged of fired.

Do not put your hand into the spin dryer
basket while the machine is in operation.

Do not drain the water out of the wash tub
while the spin dryer basket is in operation.
Otherwise the spin motor colud be damaged.

If during spining, opening the lid dose not
stop the spin dryer basket within about 15 sec.,
immediately unplug and contact service.

This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by person responsible for their safety,
Children should be supervised to ensure that they do not play with the appliance.

Do not damage, bend, distort or place
any heavy objects on its.

If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person.

Wipe off dirt or dust on the contacts of the
power plug. It may cause fire.

Do not touch a power plug with a wet hand.
It may cause electric shock.

Unplug the supply cord when not using
the washing machine for a long time.

kesosene, Insecticide.

Do not allow children to play on, with, or inside the washing machine.
Do not step on the washing machine or place any heavy objects on it.
Do not wash, rinse or spin dry the waterproof sheets and clothes.

Connect the washing machine to a grounded outlet in accordance with all local codes and ordinances.

Disconnect the power supply before cleaning or performing maintenance. Unplug the power cord by

grasping the plug with dry hands. Never grasp the cord.

The units should not be repaired, disassembled or modified by any person except the

authorized technicians.

Install the earth wire to prevent short-circuit due to leaking current and electric shock.
It is attached at the back of the washer. Connect it to the metal water pipe.
If the water pipe is made of plastic, it does not have the earth effect.
Do not connect the earth wire to the gas pipe, lightning arrester, telephone connecter, etc..

*Warning - the appliance with two pronged plug must be grounded.

Insert the power plug into the outlet.
Before connecting the power plug, check if the voltage setting of the washer matches the outlet voltage.
If AC outlet with ground terminal is used, grounding is not needed. if not, never forget earthing.
The appliance must be positioned so that the plug is accessible.

This washer is assembled for 220V, but can be changedfrom 220V to 110V ( or 127V).
Check your electrical source and follow the diagram below to convert voltage.

1.Look for a care label on your clothes. This will tell you about the fabric content of your garment
and how it should be washed.

2.Check all pockets to make sure that they are empty. Objects left in the pockets can damage both
your washer and your clothes. (could be cause the drain hose to clogg).

3.Sort clothes into loads that can be washed with the same wash cycle.

4.For you convenience hang up the wash cover on the right or left side of the washing machine tub
when not in use.

After connecting the earth wire
to the earth copper plate, bury
it at least 70cm deep under
the wet ground.

Connecting to the When installing it in an area
earthing-only outlet.

where earthing is not possible,
purchase a short-circuit
breaker connect it to the outlet.

Connecting the drain hose

Connect the drain hose to the outlet of the plunger valve located at the back side.
Push the clamp toward the body of the washing machine as shown in the figure.

For Non-Pump Model

Be sure to reroute the hose so that it is not kinked, kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is drained smoothly by placing a base under the
machine or by applying other appropriate mean.

For Pump Model

L <= 1 m.