LG WP-1350RP User Manual

SPECIFICATION

W

D

H

Power source ON SPECIFICATION LABEL

Water Level

Water Pressure Less than 100kPa (1kgf/cm2)

Dimension

Weight

How to read the manufactured month and year from the label stuck on the
back of the product.

EX) 4 0 1 T W 0 0 0 0 1

Month

Year (The last digit to year)

Main service part list : Refer to below listed part name when you need
service call.

Part name Remark

- WASH MOTOR

- SPIN MOTOR

- CYCLE TIMER ASSEMBLY

- CAPACITOR

- GEAR CASE ASM

H : 67 Litres, M : 58 Litres, L : 50 Litres, S : 43 Litres

850 X 530 X 1017 mm. (W x D x H)

For Non-Pump Model 40.5 kg

For Pump Model 41.1 kg

Serial No.

Product code

105 W (Output)
105 W (Output)
PLASTIC- S.D. BASKET

P/No. : 3828EY3040A

8

WASHING MACHINE

OWNER'S MANUAL

MODEL : WP-1250(Q,R)(S)(P)
WP-1270(Q,R)(S)(P)
WP-1280(Q,R)(S)(P)
WP-1350(Q,R)(S)(P)
WP-1380(Q,R)(S)(P)
WP-1100QS

Please read the operating instructions carefully
and throughly before installing and operating
your washing machine.
This washing machine is designed and manufactured
for household use only.

Specification

(Q,R) : Pulsator Type
(S) : See Through Cover Only
(P) : Pump Model Only

: 3828EY3040A

P/No.

CAUTION

CAUTION

Installation Area

Avoid area exposed to snow,
rain, or where humidity
is high. It may cause
electric shock.

Switch Area

Avoid watering on the
switch area.
It may cause
electric shock or fire.

Volatile Material

Do not use volatile material such as
Benzene, Gasoline, bug killer.
Do not leave strong alkaline substance
such as bleach inside
the tub. Damage on
plastic surface and
rubber parts may occur.

Installation

Install the washing machine on
a horizontal support.
Otherwise,
it may cause
vibration and noise.

Be sure to disconnect the power cord
from the electric outlet before starting
care and maintenance.

Be sure to earth the washer to prevent electric shock. To reduce
the risk of electric shock, do not install the washer in humid spaces.

Connecting the drain hose

Push the clamp toward the body of the washing machine as shown in
the figure.

For Non-Pump Model

Be sure to reroute the hose so that it is not kinked; kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is draineded smoothly by placing a base under the
machine or by applying other appropriate mean.

For Pump Model

L <= 1 m.

Heat

Avoid electric heater, candle light,
cigarette light, bug smoker,
etc. near the machine.
It may ignite or
deform
plastic part.

Hot water

Avoid using hot water

over 50°C. It may
deform plastic parts
or cause malfunction.

In Operation

Do not insert the hand inside the spin
dryer basket while the machine is in
operation (Do not let children climb on
the machine or climb into
the tub. Injury may occur.)
Do not drain the water out of the
wash tub while the spin dryer
basket is in operation.

motor could bedamaged.

Power Cord

If the power supply cord is damaged, it
must only be replaced by the
manufacture or its service agent or a
similarly qualified person in order to
avoid a hazard.

Electric Outlet

Avoid connecting several electric
devices to single outlet. It may cause
fire.

Otherwise the spin

L

FEATURES

Pulsator Table

WASHING

COVER

WATER SUPPLY

Use for WP-****Q(S)(P)

Use for WP-****R(S)(P)

WP-1100QS

1. Water Supply Inlet

Connect here with the inlet hose from the
water faucet to feed water to the tub.

2. Water Selector
Select "WASH" to supply water for

washing and rinsing and "SPIN" for spin
shower rinse.

3. Wash Timer

Select the desired time for washing or
rinsing.

4. Wash Program
Set the program to "Gentle","Normal",

"Strong" according to kind and
quantity of the laundry.

SELECTOR LEVER

OVER FLOW
FILTER

ROTATION

FILTER-C

TUB

PULSATOR

(See detail in Pulsator Table)

3 4 5

Wash ProgramWash Timer Spin Timer

Water Supply Selector

*For Pump
Model only*

DRAIN HOSE

SPIN DRYER
COVER

SAFETY
COVER-2

SPIN DRYER
BASKET

EARTH WIRE
(For models with
two prong plug)

SAFETY
COVER-1

POWER CORD

WASH

1

2

6

Off

Drain Selector

**For pump model only**

5. Drain Selector

For Non-Pump Model

Select "Wash Rinse" for washing and
rinsing and "Drain" to drain the water out
of the tub.

For Pump Model
Select "Wash Rinse" for washing and

rinsing and "Drain" to drain the water out
of Cabinet, and "Off" to turn off the drain pump.

6. Spin Timer

Select the desired time for spinning. The
maximum limit is 5 min. Don’t rotate the knob
more than prescribed limit.

2 3

INSTALLATION

●

Installation area

Set on flat and firm floor.

●

●

Incorrect installation may course
severe noise and break down.

Connecting the earth wire

●

Install the earth wire to prevent short-circuit due to leaking current and electric shock.

●

It is attached at the back of the washer.

●

Connect it to the metal water pipe.
If the water pipe is made of plastic,
it does not have the earth effect.

●

Do not connect the earth wire to the
gas pipe, lightning arrester. telephone
connecter, etc.

Warning-the appliance with two-pronged plug must be grounded.

Connecting the power plug

●

Insert the power plug into the outlet.

●

Before connecting the power plug, check if the voltage
setting of the washer matches the outlet voltage.

●

If AC outlet with ground terminal is used, grounding is not
needed. If not, never forget earthing (earthing method above).

●

The appliance must be positioned so that the plug is accessible.

Voltage Change (only for dual voltage)

This washer is assembled for 220V, but can be changed from
220V to 110V(or 127V).
Check your electrical source and follow the diagram below
to convert voltage.

Other earthing method

●

After connecting the earth
wire to the earth copper
plate, bury it at least 75cm
deep under the wet
ground.

Earth
wire

Earth copper plate

●

75cm

Connect to the
earthing-only outlet.

Maintain more than 10 cm. between
the side of drain hose and the wall.

A carpet must not obstruct the

●

ventilation openings.

Gas pipe

Earth
wire

● When installing it in an

area where earthing is
not possible, purchase a
short-circuit breaker

Earth
wire

connect it to the outlet.

Short-circuit breaker

INSTALLATION & HOW TO WASH

Before washing

1. Check the washing instruction labels on the clothing to be washed.

2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or break the washing machine (could cause the drain hose to clog).

3. After separating oiled or dyed clothing, wash.

4. For your convenience hang up the wash cover on the right or left side of the
washing machine tub when not in use.

How to wash

Set the drain selector

1

For Non-Pump Model

Set as "Wash Rinse"

position.

Drain Selector

Set the water selector

2

to "WASH"

Set the desired wash

6

time.

For Pump Model

Set as "Off"

position.

Off

Drain Selector

WASH

Water Selector

Wash Timer

Open water supply and

3

fill water in the wash tub
about halfway

to the desired
water level.

Put the appropriate amount

4

of detergent and the laundry
into the wash
tub. And add
water to the
desired water
level which
you want.

When washing is finished,

7

locate the drain selector to
"Drain" position and drain
the water out.

For Non-Pump Model

Drain Selector

For Pump Model

R

W

Off

Drain Selector

r

Select the wash

5

program to "Gentle",
"Normal" or
"Strong" according
to the kinds and
quantity of the laundry.
(Refer to Tabel 2)

Wash Program

Spinning in the spin

8

dryer basket.
Move the laundry into
the spin dryer basket.
Put the laundry down
lightly.
Place the safety cover
horizontally on the
laundry.
Set the
desired
spin time
with the
spin timer.

4 5

Interim spin rinse

Interim spin rinse prior to regular rinsing helps removing sudsy water from the
laundry and improve rinsing efficiency. Also is helpful to water saving.

After washing.

1

Move the laundry into

the spin dryer basket.

Place the safety cover

horizontally on the
laundry.

Set the water

2

selector to "SPIN".

Set the desired

3

spin flow
appropriately.

SPIN

Water Selector

Spin Timer

After interim spin

4

rinse, move the
laundry into the
wash tub for rinsing.

Note for spinning

Put the laundry evenly into the spin

1.
dryer basket.

2. Put the laundry down lightly
Place the safety cover horizontally over the

3.
laundry, washing machine will be damage if the safety cover is not placed.

4. Close the spin dryer cover

5. Do not drain the water out of wash tub while the spin dryer basket is in operation.

If the spin dryer basket is off-balance and vibrates excessively, stop the

spinning, rearrange the clothes evenly, and then resume spinning.

CARE

Overflow filter & Rotation filter-C

1.

Take out the rotation filter-C by pulling in the direction shown.

2.

Turn the net over and rinse in water.

3. After cleaning, replace the rotation filter-C.

4. Pull the overflow filter forward from the wash tub in the direction of the arrow

5.

Use a brush or your hand to remove all of the lints whichs has adhered to

the overflow filter.

6.

Insert the over flow filter back into the wash tub.

1

2

3

4

5

6 7

.

6

REFERENCEHOW TO RINSE & HOW TO SPIN

TABLE 1. WEIGHT GUIDE FOR CLOTHES

Type of clothing Type of fabric Weight per piece

Under shirt Cotton 150g(53.0oz)

Handkerchief Cotton 50g( 1.8oz)

Bath towel Cotton 300g(10.6oz)

Shirt Mixed fabric 200g( 7.1oz)

Socks (1 pair) Mixed fabric 50g( 1.8oz)

Pajama (shirt and pants) Cotton 500g(17.6oz)

Winter undershirt Cotton 600g(21.2oz)

Workclothes Mixed fabric 800g(28.2oz)

Blouse Mixed fabric 200g( 7.1oz)

TABLE 2.

Synthetics,
Silk, Woolen,
Knits

Cotton,
Linen

Very soiled
cotton and
linen

TROUBLESHOOTING GUIDE

Before Requesting Service

Motor does not operate, Is the power cord firmly plugged in?

Spin dryer basket does Is there any clothing dropped between the basket and tub?
not operate.

No draining

For Non-Pump Model

For Pump Model

GUIDE FOR WASHING

Type of

fabric

Amount of laundry is based on dry laundry.
Detergent amount is based on a general synthetic detergent.
If washing and spinning mest be operated together, starting washing and spinning
operation shall be done at the same time to cope with EMC requirement.

Wash

Wash

Selector

Gentle

Normal

Strong

Problem Checking point

Water

time

min

min

min

Is the timer turned to a suitable point except "Off" ?

Is the spin dryer cover closed?
Is the laundry gathered to one side of the spin dryer basket?

Is there lint stuck in the plunger valve?
Is the end of the drain hose guide located at an exceed height?
Is the drain pump operated?

level

S
L
M
H
S
L
M
H
S
L
M
H

Amount of

laundry (Kg)

0.5 ~ 4.5 40 ~ 45

4.5 ~ 5.5

5.5 ~ 6.5

6.5 ~

0.5 ~ 4.5

4.5 ~ 5.5

5.5 ~ 6.5

6.5 ~

0.5 ~ 4.5

4.5 ~ 5.5

5.5 ~ 6.5

6.5 ~

Amount of

water (l)

43
50
58
67
43
50
58
67
43
50
58
67

Amount of

detergent (g)

48 ~ 52
56 ~ 60
65 ~ 70
40 ~ 45
48 ~ 52
56 ~ 60
65 ~ 70
40 ~ 45
48 ~ 52
56 ~ 60
65 ~ 70