websitehttp:#www,lgservice.com
e-mail http:#www.lgeservice.com/techsup.html
ITI
E 'S
Please read the operating instructions and safety precautions
carefully and thoroughly before installing and operating your
room air conditioner.
I
LIAL
Por favor lea las, instrucciones de operaci6n y las precauciones
de seguridad cuidadosa y totalmente antes de instalar y operar
su acondicionador de aire de ventana.
EEL
U
IC,IONA
L
NE
ETARIO
MODELS,
10k Series:
i2k Series:
14k Series:
!8k Series:
24k Series:
MODELOS:
RI000,
R1203,
R1204,
R1404,
R1804,
R2403,
R2404,
MI000R, WG1000R
Mi203R, WG1203R
M1204R, WG1204R
M1404R, WG1404R
M1804R, WG1804R
M2403R, WG2403R
M2404R, WG2404R
FOR YOUR RECORDS
Wdte the model and sedal numbers here:
Model #
Serial #
You can find them on a _abel on the side of each unit
Dealer's Name
Date Purchased
m Staple your receipt to this page in the event you need it
to prove date of purchase or for warranty issues.
READ THIS MANUAL
inside you will find many helpful hin[s on how 1o use and
maintain your air conditioner properly, Just a little
preventive care on your part can save you a great deal of
time and money over the iife of your air conditioner,
You'll find many answers to common problems in the chart
of troubleshooting tips. If you review our char[ of
Troubleshooting Tips first, you may not need to call for
sewice at all.
PRECAUTION
- Contact the authorized service technician for repair
or maintenance of this unit.
• Contact the installer for installation of this unit.
• The. air conditioner is not intended for use by young
chitdren or invalids without supervision.
•Young children should be supervised to ensure that
they do not play with the air conditioner.
. When the power cord is to be replaced, replacement
work shall be performed by authorized personnel
only using onry genuine replacement parts.
• tnstagation work must be performed in accordance
with the National Electric Code by qualified and
authorized per_nnel only.
fety Pre utions
To prevent injury to the user or other people and property damage, the following instructions
must be followed.
[] Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness
is classified by the following indications.
m Meanings of symbols used in this manual are as shown below.
I Be sure not to do. "l
Be sure to follow the instruction.
WARNING
[] Installation
• No installation may cause fire and electric
shock accident.
• It may cause fire and electric shock,
• It may cause explosion or fire.
• It may cause failure and electric shock.
• Operation
. Otherwise, it will cause electric
shock or fire due to heat
generation or eJectric shock.
• It will cause electric shock or
fire due to heat generation,
• it will cause electric shock or
fire due to heat generation.
• It will cause electric shock or
fire due to heat generation.
. it wiJlcause electric shock or
fire.
• No grounding may cause
electric shock (See Instarlation
Manual).
• Otherwise it may cause fire
and electric shock accident,
• it may cause fire and electric
shock.
• it wirl cause electric shock.
• itwillcausefailureofmachine
or electricshock,
[] Installation
• it is not design_ to cool the
entire house.
• It may cause explosion, fire,
and burn.
•They aresharp andmay
causeinjury.
• it may cause injury.
Sharp
edges
• Itmaycausefailureof
applianceor accident.
, it may cause electric shock
and damage.
• If leaving appliance damaged,
there is concern of damage
due to the failing of product.
• Prevent accidental startup and
the possibility of injury.
•Thereisdangeroffireor
electricshock.
•Watermayentertheunitand
degradetheinsulation.Itmay
causeanelectricshock.
• Sincethefanrotatesathigh
speedduringoperation,it may
causeinjury.
°Operationwithoutfilterswill
causefailure.
°Thiscouldinjurethepetor
plant.
•Theappearanceoftheair
conditionermaydeteriorate,
changecolor,ordevelop
sudaceflaws.
°Itis anairconditioner,nota
precisionrefrigerationsystem.
, Itcontainscontainmentsand
willmakeyousick./ This could
damage your health.
About the Controls on the Air Conditioner
The controls will look like one,of the following.
Off
M_ _ High
Off
Med Fan
Low Fan
High Cool
Med Cool
Low Cool
J
5
_ 4 i 6
Thermostat
- Turns air conditioner off.
oMed speed fan operation without
_oling.
oLow speed fan operation without
cooling.
- Cooling with high speed fan
operation.
- Cooling with reed speed fan
operation.
- Cooling with low speed fan
operation
#
S
F I
Fan _ Cool
o
For Normal Cooling
1.
Turn the Operation Knob to the High Cool
from the Low Cool setting.
,
Set the Thermostat control to the desired
temperature mark ._ (the mid-point is a
good starting position). If the room
temperature is not satisfactory after a
reasonable time, adjust the control to a
cooler or warmer se_ing, as appropriate.
• For Maximum Cooling
1. Turn the Operation Knob to the High Cool
setting.
2, Set the Thermostat control to the largest -_
temperature mark.
• For Quieter Operation
i, Turn the Operation Knob to the Low Cool
setting.
2. Set the Thermostat control as needed.
This automatically controls the temperature of
the indoor air.
Turn the knob so that: arrow points to the larger
marks for greater cooling. Point the arrow to
the smaller marks for more moderate cooling.
(i.e. the higher number the greater cooling)
CAUTION: When, the air conditioner has been perform_ its cooling
operation and is turned off or _t to the fan position, wait at least 3 minutes
before re_tting to the c_iling o_ration again.
• Auto Swing (Optional)
On : Air swing is operated while Operation
knob is set to the Cool position.
Off : Stops the operation of air swing.
Auto Swing
o0 l loo
Controls(1OkSeries)
FAN SPEED
• Everytirne you push this button it is set as follows_
{High(F3) -_Low(F1)-* Med(F2) =.,High(F3)._},
ON/OFF TIMER
• Everyti_ you push this button, timer isset as follows |
(1Hour.. Hours _.3H_rs .. 4Hours .. 5Hours .. 6Hours -_
7Hours_.8_urs ...9Hours-, 10Hours_.11Hours.. 12Hours.,.Cancel)
, The Setting Temperature will _ raised by 2°F(1%) 30min.
later and by 2_F(I °C)after another 30 rnin,
Remote controfler
PRECAUTiO'N: The RemoteController wilt notfunction pro_rty if strong light strikes the
sensorwindowof the air co_itio_r or ifthere ate obstacles betw_n the RemoteController
andthe air conditioner,
REMOCON SIGNAL RECEIVER
ENERGY SAVER
Ifthe switch is set to "On", the fan stopswhen the
compressor sto_ c_ir O.
Approximaielyevery3 minutes the fan wil]turnon and
checkthe roomair to determineif coo_ingis need,
, To turn the airconditioner ON, pushthe butt_
Toturnthe airconditioner OFF, push the button wain,
, ThisbuUontakes prbfity over any other buttons.
• Whenyou first turn it on, the aircond_bner ison the
Highc_l modeand the temp.at 72°F(22°C)
TEMPERATURE SETTING
* Thisb_on can automaticallycontro_the temperature
d the room. Thetemperature can _ _t wi_in a range
d _°F to 86°F by Y_F(16°Cto 30'C by 1"C)
S_ectthe lowernumber1orlowertemperatureof the room,
t
, Everytirne you push thisbutton, it will toggle
between COOL FAN and DRY,
•To turnthe air cooditic_qerON,push the bu_on.Toturn the air conditionerOFF, push the button again.
•This button tak_ prior_y over any other buttons,
•When you fi_t turn it on, the air conditio_r ison the High cool mode andthe temp. at72°F_°C).
TEMPERATURE SETTING
• This button can auto_ticaIly contro_the temperature of the roorn.
The temperature can be set within arange of _°F to _°F by 1"F,(16°C to 30% by 1°C}
Select the Uowernurn_r for lower temperature of the room.
FAN SPEED
•Eve_irne youpushthisbuttonit issetasfol_ows_{High(F3)-_Lew(F1)_Med(F2)-*High(F3).,},
-STOPPING OPERATION Uo®
• Everytimeyou push this button, when the air conditioner [so_rating, timer is set asfollows.
(1Hour-,.2Hours _3Hours_ 4Hours-. 5Houm-. 6Hours_ 7Hours _ 8Hours _gHours_
lOHours---11Hours--.12Hou_ -*Cancel)
• TheSetting Temperaturewill be raisedby _F(I°C) 30rain laterand by 2°F(I°C) after another 30 rnin,
-STARTING OPERATION
• Everytimeyou push this button, whenthe air conditioner is not operating,tier isset asfollow
(1Hour---2Hours -,.3Houm-_4Hours-* 5Hour--,, 6Hours ---7Hours--.8Hours--.9Hours--.
lOHours ---11Hours,_12Hours--.Cancel)
ENERGY SAVER
. If the switch is set to "On", the fan sto_ when thecompressor stops _oling.
Approximatelyevery 3 minutesthe fan will turn on and checkthe roomair to determineif c_]ing is n_ded,
MODE
• Everytime you push this button, it will t_gle _tween C_L, FAN and DRY.
The controls will look like one of the following.
Controls(12k~24k Series)
_ O_
o o o
POWER BUTTON
....J
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button t_es priority over any other buttons.
_:_J OPERATION MODE SELECTION BUTTON
Everytime you push this button, it wil! toggle COOL, FAN and DRY.
ON/OFF TIMER BUTTON
Everytime you push this button, timer is set as follows.(1 Hour-) 2Hours -) 3Hours -) 4Hours -)
5Hours -) 6Hours -) 7Hours -) 8Hours -) 9Hours -) 10Hours -) 11Hours -) 12Hours -) Cancel)
_l FAN SPEED SELECTOR
Everytime you push this bu_on, itis set as follows. (Hi[ F3 ] -) Low[ F L] e Med[ F2 ] e Hi[ _:3 ]-..)
ROOM TEMPERATURE SETTING BU_ON
This button _n automatically control the temperature of the r_m. The temperature can be set
within a range of 60_ to 86_ by 1°F.
Select the lower number for lower temperature of the room.
AUTO SWING
-_-:_This button can automaticaliy _ntrol the air flow direction.
ENERGY SAVER
:._I The fan stops when the compressor stops cooiing,
Approximately every 3 munutesthe fan will turn onand check the room air to determine if c®ling is need_.
REMOCON SIGNAL RECEIVER
CAUTION: When the air conditioner has been perfo_ its cooling operation and is
turn_ off or set to the fan position, wait at least 3 minutes before resetting to the cooling
operation again.
Additional controls and important information.
How to insert Batteries
Removethe_ver fromthe backof theremote
_ntroller.
inserttwo batteries
. Be surethatthe (+) and (-) directions ayecorr_t,
. Be sureth_ _th batteriesare new.
Re-attachthecover,
The ventilation lever must be in the CLOSE position in order to maintain the best cooling _nditions.
When fresh air isinecessary in the room, set the ventilation lever to the OPEN position.
The damper is opened and room air is drawn out.
Before using the ventilation feature,
position the lever, as shown. First, pull down
part _, to horizontal line with pad :%
. Donot userechargeablebatteries.Such
batteriesdiffer from standarddrycells in
shape,dimensions,and performance.
•Removethe b_eries fromthe remote
controllerifthe air _nditioner is not
goingto be usedfor_ extended length
oftime.
Air Direction
The direction of air can be controlled wherever you want to
cool by adjusting the horizontal louver and the vertical
louver.
° HORIZONTAL AIR-DIRECTION CONTROL
To control horizontal direction of air flow, set to the ON
position the air-swing switch and the air flow wi!t be swept
horizontally by the automatic air-swing system.
If you want to stop the air flow from moving, switch off the
air swing switch at the desired position of the vane
• VERTICAL AIR-DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal louver.