LG WDP5K User Manual

3828ER4001V

※ 본 도면은 PDF파일 관리로 전환하면서 신규 생성되는 도면임.

RELEASING THIS DRAWING WITHOUT PERMISSION LG Electronics SHOULD BE ACCUSED ACCORDING TO THE LAWS AND COMPANY RULES.

이 도면은 LG전자의 자산으로 불법 유출시 관계법과 회사규정에 의해 처벌됨.

2 1 0

WORK

나

SEC.

가

BRAND

KENMORE

나

MODEL

WDP4*

가

다

P/NO.

3282ER4001V

PRINTING DEGREE EXTERIER INTERIER

1 1

MATERIAL AND PRINTING DESCRIPTION

모조지 100g OFFSET 인쇄

LWP-277(8)*

<< 주기 >>

1. 재질, 인쇄방법, 인쇄도수, 외곽치수등은 작업표에 준한다.

2. 인쇄내용, 문자크기 및 형상, 선의 굵기 등은 설계에서 제시된 FILM에 준함.

3. 외곽치수는 절단후 치수임.

4. 양산전에 설계 한도를 득할 것.

5. 본 부품에 금지물질이 포함되지 않도록 하고, 상세내용은 LG(63)-A-5501-34를 만족할 것

<< NOTES >>

LG MODEL 명

SUFFIX

A**EECI

LANGUAGE

ENG/ SPN/ FRE

PAGE

REMARK

PEDESTAL

REV. NO.

기호

REVISION DESCRIPTION

변경 사항

P/NO. 다

1 5 0 1 5 0

강동우황지성11/11/29AWCR107257인쇄내용 변경

김 곤황지성12/05/25AWCR203030인쇄내용 변경

김 곤박중일14/08/25EAGE800320인쇄내용 변경

김 곤박중일14/09/16EAGE900308인쇄내용 변경

APPROVED

REF. NO.

시방 번호

년/월/일

DATE

PREPARED

시방자

승인자

1. Material, printing and exterier size are refer to work tables.

2. Printing, text size and line are based on LG design film.

3. Exterier size on the drawing is cutting line.

4. Before product controlled by criteria sample.

5. The part should not contain prohibited substances(Pb,Cd,Hg,Cr+6,PBB,PBDE)and details should comply with LG standard of LG(63)-A-5501-34

DR COMPLETED

도면 DR 완료

완료일 : 10.02.11

TRIG.

김희정

10.02.11

UNIT SCALE

REVIEWEDDESIGNED

LG 전자 (주)

LG Electronics Inc.

CHECKED APPROVEDMODELING

RELATED DWG.

조한기

10.02.11

PDF

ILLUSTRATOR

MANUAL,OWNER’S

T L E

DWG. No.

DRUM-

3828ER4001V

EXPORT

P/No. 3828ER4001V

ENGLISH

for washer/combo for dryer

for dryer for washer/combo

Lock nut

Adjustable feet Adjustable feet

Leg Extension

IMPORTANT: Read and follow these instructions.

NOTICE

The installer must have electrical and mechanical training and acceptable knowledge in the required work.

Safety is foremost---both your own and that of other people. Many important safety instructions are provided in this instruction and your appliance. Always read and observe all safety instructions.

Remove pedestal,installation hardware, and instructions from the shipping carton.

Position the washer/combo on top of the pedestal.

WARNING

Excessive Weight Hazard

Two or more people may be needed to install and move the appliance and pedestal assembly. Do not allow children to play on the drawer. Do not step on the handle.

A firm, solid floor is even more critical to a front-loading washer than to a top-loader. If your floor is wooden and /or frame construction, you may need to reinforce it. Front-loaders have substantially faster spin speed than top-loaders, causing greater vibration. If the floor is not solid, your washer will vibrate.

WASHER/COMBO INSTALLATION

Before installing the pedestal, remove foreign objects on the floor clean the floor. Dust, water, oil, detergent and so on could cause vibration due to bad contact of legs with floor.

After the washer is leveled, tighten the lock nuts up toward the base of the washer using the wrench. All four lock nuts should be tightened.

Level the pedestal on the clean place by adjusting the feet.

NOTE

If a drip pan must be used, take extra care to follow the instructions provided with the drip pan and make sure the leveling feet are adjusted for firm and even contact with the pan. Use of drip pans and failure to properly level the machine may result in increased vibration and noise during operation.

Included Accessories

NOTE

Do not extend the legs no more than necessary to level the washer. The more the legs are extended, the more the washer will vibrate.

NOTE

Because of the weight of the washer/combo, two or more people may be needed.

NOTE

If the washer or combo was previously installed, unplug it, disconnect the inlet hose (s)from the faucet (s), disconnect the drain hose, and drain all hoses.

NOTE

4 Holder

eighteen 4x20mm

Truss taptite Drawer Divied

Tools Needed

11/16” or 17mm

Open End Wrench

Phillips

screwdriver

ENGLISH

Make sure the holes on the pedestal align with the holes in the appliance, then install 4 screws at each corner to securely attach the appliance to the pedestal.

Level the washer/combo on the pedestal by adjusting the feet.

Lock nut

Adjustable feet Adjustable feet

Move the washer/combo to the desired place.

Diagonal Check

When pushing down the edges of the washing machine top plate diagonally, the machine should not move up and down at all.(Please check both directions.) If the machine rocks when pushing the machine top plate diagonally, adjust the feet again.

NOTE

To make sure that the washer is properly level, run the washer with a test load: place approximately 6 pounds of laundry in the machine. Then press POWER, press RINSE+SPIN, and then press the START/PAUSE button. See the following sections for additional information on cycle selection and operation. Verify that the washer does not rock or vibrate excessively during the spin cycle. If the washer vibrates or shakes, adjust the leveling feet until the washer is stable and retest.

NOTE

If the screws are not installed properly, noise and vibration may result. For WASHER: 16 SCREWS For DRYER: 8 SCREWS

NOTE

The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock nut toward the pedestal while holding the pedestal leg using a wrench.

NOTE

Lock nut

Adjustable feet Adjustable feet

ENGLISH

Because of the weight of the dryer, two or more people may be needed.

NOTE

Remove pedestal,installation hardware, and instructions from the shipping carton.

Make sure the holes on the pedestal align with the holes in the appliance, then install 2 screws at each corner to securely attach the appliance to the pedestal.

DRYER INSTALLATION

Position dryer on top of the pedestal.

Insert the T-clip of the 4 retainers into the dryer base as shown. Press up on the back of the clip and pull outward to lock into place.

for washer/ combo for dryer

for dryer

for washer/ combo

If dryer was previously installed, uninstall it as follows:

NOTE

A. Uninstalling an electric dryer:

1) Unplug the power supply cord,

2) Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.

B. Uninstalling a gas dryer:

1) Unplug power supply cord.

2) Turn off the gas supply.

3) Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.

Lock nut

Adjustable

feet

Adjustable

feet

Adjustable

feet

Higher

Lower

Move the dryer to the desired place.

The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock unt toward the pedestal while holding the pedestal leg using a wrench.

NOTE

If the screws are not installed properly, noise and vibration may result.

NOTE

T-clip

Retainer

ENGLISH

LG Electronics Inc., Will repair or at its option replace, without charge, your product if it proves to be defective material or workmanship under normal use during the warranty period set forth below, effective from the date of original consumer purchase of the product. This limited warranty is good only to the original purchaser of the product and effective only when used in the United states including Alaska, Hawail, and U.S. Territories; and Canada.

WARRANTY PERIOD:

1Year from the Date of Purchase.

Call 1-800-243-0000 (USA) or 1-888-LGCANADA and choose the appropriate prompt. Please have product type, model number, serial number, and ZIP code ready.

HOW SERVICE IS HANDLED:

THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. LG WILL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INDIRECT, OR INCIDENTAL DAMAGES OF ANY KIND, INCLUDING LOST REVENUSE OR PROFITS, IN CONNECTION WITH THE PRODUCT. SOME STATES DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

THIS LIMITED WARRANTY DOES NOT APPLY TO:

1. Service trips to your home to deliver, pick up, and/or install the product, instruct, or replace house fuses or correct wiring, or correction of unauthorized repairs; and

2. Damages or operating problems that result from misuse, abuse, operation outside environmental specifications or contrary to the requirements or precautions in the Operating Guide, accident, vermin, fire, flood, improper installation, acts of God, unauthorized modification or alteration, incorrect electrical current or voltage, or commercial use, or use for other than intended purpose.

3. Therefore, the cost of repair or replacement of such a defective product shall be borne by the consumer.

CUSTOMER INTER-ACTIVE CENTER NUMBERS:

To Prove Warranty Coverage

To Obtain Nearest Authorized Service Center or Sales Dealer, or to Obtain Product,Customer, or Service Assistance

Retain your Sales Receipt to prove date of purchase.

A copy of your Sales Receipt must be submitted at the time warranty service is provided.

Call 1-800-243-0000 or 1-888-LGCANADA and choose the appropriate prompt from the menu, and have your product type, model number, serial number, and ZIP Code; or visit our website at

http://www.lgservice.com

WARRANTY

+ 11 hidden pages