LG WDP4B Owner's Manual

3828ER4001V

IMPORTANT: Read and follow these instructions.

1
2
3
4

1
2

1
2
3

NOTICE

Safety is foremost---both your own and that of other
people. Many important safety instructions are provided
in this instruction and your appliance. Always read and
observe all safety instructions.

The installer must have electrical and mechanical training and acceptable knowledge in the
required work.

WARNING

ENGLISH

Excessive Weight Hazard

Two or more people may be needed to install and
move the appliance and pedestal assembly.
Do not allow children to play on the drawer.
Do not step on the handle.

Level the pedestal on the clean place by adjusting
the feet.

Lock nut

NOTE

A firm, solid floor is even more critical to a front-loading
washer than to a top-loader. If your floor is wooden
and /or frame construction, you may need to reinforce
it. Front-loaders have substantially faster spin speed
than top-loaders, causing greater vibration. If the floor
is not solid, your washer will vibrate.

NOTE

If a drip pan must be used, take
extra care to follow the
instructions provided with the drip
pan and make sure the leveling
feet are adjusted for firm and even contact with the pan. Use
of drip pans and failure to properly level the machine may
result in increased vibration and noise during operation.

Included Accessories

eighteen

4 Holder

Tools Needed

11/16” or 17mm

Open End Wrench

4x20mm

Truss taptite Drawer Divied

Phillips

screwdriver

WASHER/COMBO INSTALLATION

Remove pedestal,installation hardware, and
instructions from the shipping carton.

Before installing the pedestal, remove foreign
objects on the floor clean the floor. Dust, water, oil,
detergent and so on could cause vibration due to
bad contact of legs with floor.

Adjustable feet Adjustable feet

NOTE

Do not extend the legs no more than necessary to
level the washer. The more the legs are extended, the
more the washer will vibrate.

Leg Extension

After the washer is leveled, tighten the lock nuts up



toward the base of the washer using the wrench. All
four lock nuts should be tightened.

Position the washer/combo on top of the pedestal.

NOTE

Because of the weight of the washer/combo, two or
more people may be needed.

NOTE

If the washer or combo was previously installed,
unplug it, disconnect the inlet hose (s)from the faucet
(s), disconnect the drain hose, and drain all hoses.

for washer/combo
for dryer

for dryer

for washer/combo

2

1
2
3
4
5
6

Level the washer/combo on the pedestal by

1
2
3
4
5

1
2
3
4
5
6
7

adjusting the feet.

Lock nut

Adjustable feet Adjustable feet

Make sure the holes on the pedestal align with the
holes in the appliance, then install 4 screws at each
corner to securely attach the appliance to the pedestal.

NOTE

If the screws are not installed properly, noise and
vibration may result.
For WASHER: 16 SCREWS
For DRYER: 8 SCREWS

Move the washer/combo to the desired place.

NOTE

The appliance and pedestal assembly must be placed
on a solid and level floor for proper operation. Adjust
the legs of the appliance and pedestal by turning with
a wrench. Then, adjust the lock nut toward the
pedestal while holding the pedestal leg using a
wrench.

Lock nut

Adjustable feet Adjustable feet

NOTE

Diagonal Check

When pushing down the edges of
the washing machine top plate
diagonally, the machine should not
move up and down at all.(Please
check both directions.) If the
machine rocks when pushing the
machine top plate diagonally, adjust
the feet again.

NOTE

To make sure that the washer is properly level, run the
washer with a test load: place approximately 6 pounds
of laundry in the machine. Then press POWER, press
RINSE+SPIN, and then press the START/PAUSE
button. See the following sections for additional
information on cycle selection and operation. Verify
that the washer does not rock or vibrate excessively
during the spin cycle. If the washer vibrates or shakes,
adjust the leveling feet until the washer is stable and
retest.

ENGLISH

3

DRYER INSTALLATION

1
2
3

1
2

1
2
3
4

1
2
3
4
5

Remove pedestal,installation hardware, and
instructions from the shipping carton.

Insert the T-clip of the 4 retainers into the dryer base
as shown. Press up on the back of the clip and pull
outward to lock into place.

ENGLISH

T-clip

Retainer

Position dryer on top of the pedestal.

NOTE

Because of the weight of the dryer, two or more people
may be needed.

NOTE

If dryer was previously installed, uninstall it as follows:

A. Uninstalling an electric dryer:

1) Unplug the power supply cord,

2) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.

Make sure the holes on the pedestal align with the
holes in the appliance, then install 2 screws at each
corner to securely attach the appliance to the
pedestal.

NOTE

If the screws are not installed properly, noise and
vibration may result.

Move the dryer to the desired place.

NOTE

The appliance and pedestal assembly must be placed
on a solid and level floor for proper operation. Adjust
the legs of the appliance and pedestal by turning with
a wrench. Then, adjust the lock unt toward the
pedestal while holding the pedestal leg using a
wrench.

B. Uninstalling a gas dryer:

1) Unplug power supply cord.

2) Turn off the gas supply.

3) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.

for washer/
combo
for dryer

for dryer

for washer/
combo

Lock
nut

Adjustable

feet

Higher

Adjustable

feet

4

Lower

Adjustable

feet

WARRANTY

LG Electronics Inc., Will repair or at its option replace, without charge, your product if it proves to be defective material
or workmanship under normal use during the warranty period set forth below, effective from the date of original consumer
purchase of the product. This limited warranty is good only to the original purchaser of the product and effective only
when used in the United states including Alaska, Hawail, and U.S. Territories; and Canada.

WARRANTY PERIOD:

1Year from the Date of Purchase.

THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT
LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE
EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS
WARRANTY PERIOD ABOVE. LG WILL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INDIRECT, OR
INCIDENTAL DAMAGES OF ANY KIND, INCLUDING LOST REVENUSE OR PROFITS, IN CONNECTION WITH THE
PRODUCT.
SOME STATES DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE
EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS
MAY NOT APPLY TO YOU.

HOW SERVICE IS HANDLED:

Call 1-800-243-0000 (USA) or 1-888-LGCANADA and choose the
appropriate prompt. Please have product type, model number, serial number,
and ZIP code ready.

THIS LIMITED WARRANTY DOES NOT APPLY TO:

1. Service trips to your home to deliver, pick up, and/or install the product, instruct, or replace house fuses or correct
wiring, or correction of unauthorized repairs; and

2. Damages or operating problems that result from misuse, abuse, operation outside environmental specifications or
contrary to the requirements or precautions in the Operating Guide, accident, vermin, fire, flood, improper installation,
acts of God, unauthorized modification or alteration, incorrect electrical current or voltage, or commercial use, or use
for other than intended purpose.

3. Therefore, the cost of repair or replacement of such a defective product shall be borne by the consumer.

ENGLISH

CUSTOMER INTER-ACTIVE CENTER NUMBERS:

Retain your Sales Receipt to prove date of purchase.

To Prove Warranty Coverage

To Obtain Nearest Authorized
Service Center or Sales Dealer,
or to Obtain Product,Customer,
or Service Assistance

A copy of your Sales Receipt must be submitted at the time warranty service
is provided.

Call 1-800-243-0000 or 1-888-LGCANADA and choose the appropriate prompt
from the menu, and have your product type, model number,
serial number, and ZIP Code; or visit our website at

http://www.lgservice.com

5