LG WDP4, LWP-277 Service Manual
SERVICE MANUAL
PEDESTAL
For washer, dryer, and combo
LG 27"
CAUTION : READ THIS MANUAL CAREFULLY TO DIAGNOSE
CORRECTLY BEFORE SERVICING THE UNIT.
MODEL : WDP4* / LWP-277*
1
PEDESTAL KIT
INTRODUCTION
The pedestal accessory includes:
• Drawer divider (1) • Wrench
• Screws (18) † • Retainers (4)††
• Floor Pads (4)
Tools Needed for Installation:
• Phillips-head screwdriver
• Wrench (supplied)
† Dryer installation only uses 8 screws
†† For dryer only
To ensure safe and secure installation, please
thoroughly follow the instructions below.
WARNING
• Incorrect installation can cause serious
accidents.
• The appliances are heavy. Two or more
people are required when installing the
pedestal. There is a risk of serious back injury
or other injuries.
• Do not allow children to play in or on the
drawer. There is a risk of suffocation or injury.
• Do not step on the handle. There is a risk of
serious injury.
• If appliances are already installed,
disconnect them from all power, water, or
gas lines and from draining or venting
connections. Failure to do so can result in
electrical shock, fire, explosion, or death.
• Wear gloves during installation.
2
PEDESTAL KIT
PEDESTAL INSTALLATION – WASHER
For dryer
Tighten all 4
locknuts securely
Make sure the leveling feet of the appliance
1
are fully retracted.
Once the leveling feet of the washer are fully
retracted, tighten all locknuts securely.
NOTE: The appliance and pedestal assembly
must be placed on a solid, sturdy, level floor for
proper operation.
For washer/combo
Position the appliance on top of the pedestal.
2
The washer feet will fi t into the outermost
corner positions and the dryer feet will fi t into
the innermost positions as shown.
Make sure the back feet are in the correct
3 4
positions.
The washer feet will fi t into the outermost
corner positions and the dryer feet will fi t into
the innermost positions as shown.
Make sure the holes on the pedestal align with
the holes in the appliance, then install 4 screws
at each corner to securely attach the appliance
to the pedestal.
NOTE: If the screws are not installed properly,
noise and vibration may result.
Move the appliance to the desired location.
3
Loading...