<![endif]>ENGLISH
<![if ! IE]><![endif]>FRANÇAIS
|
IMPORTANT: Read and follow these instructions. |
NOTICE |
The installer must have electrical and mechanical training and acceptable knowledge in the |
required work. |
Safety is foremost---both your own and that of other people. Many important safety instructions are provided in this instruction and your appliance. Always read and observe all safety instructions.
WARNING
Excessive Weight Hazard
Two or more people may be needed to install and move the appliance and pedestal assembly.
Do not allow children to play on the drawer. Do not step on the handle.
NOTE
A firm, solid floor is even more critical to a front-loading washer than to a top-loader. If your floor is wooden and /or frame construction, you may need to reinforce it. Front-loaders have substantially faster spin speed than top-loaders, causing greater vibration. If the floor is not solid, your washer will vibrate.
NOTE
If a drip pan must be used, take extra care to follow the instructions provided with the drip pan and make sure the leveling feet are adjusted for firm and even contact with the pan. Use of drip pans and failure to properly level the machine may result in increased vibration and noise during operation.
Level the pedestal on the clean place by adjusting the feet.
Lock nut
Adjustable feet |
Adjustable feet |
NOTE
Do not extend the legs no more than necessary to level the washer. The more the legs are extended, the more the washer will vibrate.
Leg Extension
After the washer is leveled, tighten the lock nuts up toward the base of the washer using the wrench. All four lock nuts should be tightened.
Position the washer/combo on top of the pedestal.
WASHER/COMBO INSTALLATION
Remove pedestal,installation hardware, and instructions from the shipping carton.
Before installing the pedestal, remove foreign objects on the floor clean the floor. Dust, water, oil, detergent and so on could cause vibration due to bad contact of legs with floor.
NOTE
Because of the weight of the washer/combo, two or more people may be needed.
NOTE
If the washer or combo was previously installed, unplug it, disconnect the inlet hose (s)from the faucet (s), disconnect the drain hose, and drain all hoses.
for washer/combo for dryer
for dryer
for washer/combo
2
Level the washer/combo on the pedestal by adjusting the feet.
Lock nut
Adjustable feet |
|
|
Adjustable feet |
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Remove the paper from the four pedestal brackets.
Attach the double-faced tape of the bracket to the washer/combo as shown so the bent parts of the brackets align with the edge and can be attached to the pedestal with screws.
NOTE
Attach the lower side first.
Be sure to press the adhesive parts of the brackets firmly to the appliance.
NOTE
Level the washer/combo before attaching the bracket. Rub this part about 10 times for better attachment.
If this part is not attached, heavy vibration and noise may result.
Install the eight (8)screws (supplied)to attach the brackets to the pedestal.
<![endif]>ENGLISH
3
Move the washer/combo to the desired place.
NOTE
The |
placed |
on |
|
the |
with |
a |
|
wrench |
|
<![endif]>ENGLISH
Lock nut
Adjustable feet |
Adjustable feet |
NOTE
Diagonal Check
When pushing down the edges of the washing machine top plate diagonally, the machine should not move up and down at all.(Please check both directions.) If the machine rocks when pushing the machine top plate diagonally, adjust the feet again.
NOTE
To make sure that the washer is properly level, run the washer with a test load: place approximately 6 pounds of laundry in the machine. Then press POWER, press
RINSE+SPIN, and then press the START/PAUSE button. See the following sections for additional information on cycle selection and operation. Verify that the washer does not rock or vibrate excessively during the spin cycle. If the washer vibrates or shakes, adjust the leveling feet until the washer is stable and retest.
DRYER INSTALLATION
Remove pedestal,installation hardware, and instructions from the shipping carton.
Position dryer on top of the pedestal.
NOTE
Because of the weight of the dryer, two or more people may be needed.
REMARQUE
If dryer was previously installed, uninstall it as follows:
A.Uninstalling an electric dryer:
1)Unplug the power supply cord,
2)Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.
B.Uninstalling a gas dryer:
1)Unplug power supply cord.
2)Turn off the gas supply.
3)Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.
for washer/ combo
for dryer
for dryer
for washer/ combo
Remove the paper from the four pedestal brackets.
4
Attach the double-faced tape of the bracket to the dryer as shown so the bent parts of the brackets align with the edge and can be attached to the pedestal with screws.
NOTE
Attach the lower side first.
Be sure to press the adhesive parts of the brackets firmly to the appliance.
NOTE
Level the washer/combo before attaching the bracket. Rub this part about 10 times for better attachment.
If this part is not attached, heavy vibration and noise may result.
Install the eight (8)screws(supplied)to attach the brackets to the pedestal.
Move the dryer to the desired place.
NOTE
The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock unt toward the pedestal while holding the pedestal leg using a wrench.
<![if ! IE]><![endif]>ENGLISH
|
Lock |
|
nut |
|
Adjustable |
|
feet |
Higher |
Lower |
Adjustable |
Adjustable |
feet |
feet |
5
<![endif]>ENGLISH
WARRANTY
LG Electronics Inc., Will repair or at its option replace, without charge, your product if it proves to be defective material or workmanship under normal use during the warranty period set forth below, effective from the date of original consumer purchase of the product. This limited warranty is good only to the original purchaser of the product and effective only when used in the United states including Alaska, Hawail, and U.S. Territories; and Canada.
WARRANTY PERIOD: |
HOW SERVICE IS HANDLED: |
Call 1-800-243-0000 (USA) or 1-888-LGCANADA and choose the
1Year from the Date of Purchase. appropriate prompt. Please have product type, model number, serial number, and ZIP code ready.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. LG WILL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INDIRECT, OR INCIDENTAL DAMAGES OF ANY KIND, INCLUDING LOST REVENUSE OR PROFITS, IN CONNECTION WITH THE PRODUCT.
SOME STATES DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.
THIS LIMITED WARRANTY DOES NOT APPLY TO:
1.Service trips to your home to deliver, pick up, and/or install the product, instruct, or replace house fuses or correct wiring, or correction of unauthorized repairs; and
2.Damages or operating problems that result from misuse, abuse, operation outside environmental specifications or contrary to the requirements or precautions in the Operating Guide, accident, vermin, fire, flood, improper installation, acts of God, unauthorized modification or alteration, incorrect electrical current or voltage, or commercial use, or use for other than intended purpose.
3.Therefore, the cost of repair or replacement of such a defective product shall be borne by the consumer.
CUSTOMER INTER-ACTIVE CENTER NUMBERS:
|
Retain your Sales Receipt to prove date of purchase. |
|
To Prove Warranty Coverage |
A copy of your Sales Receipt must be submitted at the time warranty service |
|
|
is provided. |
|
|
|
|
To Obtain Nearest Authorized |
Call 1-800-243-0000 or 1-888-LGCANADA and choose the appropriate prompt |
|
from the menu, and have your product type, model number, |
||
Service Center or Sales Dealer, |
||
serial number, and ZIP Code; or visit our website at |
||
or to Obtain Product,Customer, |
||
|
||
or Service Assistance |
http://www.lgservice.com |
|
|
|
6