LG V-WP188NT Owner’s Manual [ar]

Vacuum Cleaner

OWNER'S MANUAL

MODEL: V-WP148NT

V-WP168NT

V-WP188NT

Please read carefully and thoroughly the operating instructions and safety precautions before installing and operating your vacuum cleaner.

P/No.: 3828FV3003C

IMPORTANT SAFEGUARDS

When you use an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

WARNING: To reduce the risk of fire,electric shock,or injury:

1.Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.

2.Do not use outdoors or on wet surfaces.

3.Do not allow to be used as a toy. Close attention is necessary when used by or near children.

4.Use only as described in this manual. Use only manufacturer's recommended attachments.

5.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

6.Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.

7.Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

8.Do not handle plug or appliance with wet hands.

9.Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.

10.Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.

11.Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

12.Do not use without dust filter and/or clean filter in place.

13.Turn off all controls before unplugging.

14.Use extra care when cleaning on stairs.

15.Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.

-2-

TURN ON/OFF
• You can turn on/off the unit by pressing the
power switch on the top of handle.	Power Switch

							Fig.1 Turn On/Off
				TO USE FLOOR NOZZLE
• For cleaning the dust on floor, please use the
floor nozzle as following:
1.	Insert the telescopic pipe			into handgrip
	reelingly.						3
							3
2.	Insert floor nozzle		into telescopic pipe
	reelingly.
3.	Put the hose joint		into the socket			on unit.
4.	When you want to take the hose out, press						2
	button	and pull the hose joint			out.
							5 4
							6
	USE IT AS BLOWER						1
	USE IT AS BLOWER
• You can use the vacuum cleaner as a blower for
cleaning the place where the cleaning head							4
cannot reach.							4
cannot reach.							7
1.	Put the hose joint		into the blowing hole				7
1.	Put the hose joint		into the blowing hole
	until it is fastened.
2.	When take the hose out, pull the hose joint
	out.
							Fig.2 Use the Floor nozzle and use it as a blower
							-3-

DUST-FULL INDICATOR

•When red drogue appears in the window continuously, the dust room could be full or airway could be blocked. You have to deal with it immediately.

CAUTION

When red drogue appears in the window continuously, the motor will be burnt finally if the vacuum cleaner keeps working.

WARNING

When you hear a whistle or scream, it means the safety-air-inlet-valve operates. In this case, you should check as the above.

Dust-full indicator

Fig.3 Dust-full indicator

DUST BRUSH AND CREVICE TOOL

1.Dust brush : For cleaning small room such as chairs,sofa,curtain or describing surface. Insert it into handgrip reelingly.

2.Crevice tool : It is used for cleaning gap, corner etc. When use it, insert it into handgrip .

SUCTION ADJUSTING

•Adjust the suction power by slipping the adjusting button.

•The bigger the bear hole is, the lower suction power is. We suggest that you had better use lower suction power when clean curtain, jalousie or elaborate cloth.

Fig.4 To use dust brush and crevice tool and suction adjusting

-4-

TOOL STORAGE space

• The back of the dolly has a storage for the dusting brush and crevice nozzle. Place the attachments on the storage space for handy retrieval.

Fig. 5 Tool's storage

TO REMOVE DUST

When dust accumulation is excessive, please remove the dust by the following:

1.Turn off the machine and pull out the plug from wall outlet.

2.Remove the hose, and release the clamp by pulling the lower side of it on each side and take off the upper case .

3.Take the upper case and shake the cloth filter for about 20 times to remove the clogging dust from the filter . When fluff remains excessively on the filter, remove it by a brush.