LG V-WP168NT Owner's Manual

Vacuum Cleaner
OWNER'S MANUAL
Please read carefully and thoroughly the operating instructions and safety precautions before installing and operating your vacuum cleaner.
MODEL: V-WP148NT
V-WP168NT V-WP188NT
V-WP2600NT
P/No.: 3828FV3003E
-2-
IMPORTANT SAFEGUARDS
When you use an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
WARNING: To reduce the risk of fire,electric shock,or injury:
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
4. Use only as described in this manual. Use only manufacturer's recommended attachments.
5. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
12. Do not use without dust filter and/or clean filter in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they
may be present.
• You can turn on/off the unit by pressing the
power switch on the top of handle.
• For cleaning the dust on floor, please use the
floor nozzle as following:
1. Insert the telescopic pipe
into handgrip
reelingly.
2. Insert floor nozzle
into telescopic pipe
reelingly.
3. Put the hose joint
into the socket on unit.
4. When you want to take the hose out, press button and pull the hose joint out.
• You can use the vacuum cleaner as a blower for
cleaning the place where the cleaning head cannot reach.
1. Put the hose joint
into the blowing hole
until it is fastened.
2. When take the hose out, pull the hose joint out.
-3-
TURN ON/OFF
TO USE FLOOR NOZZLE
USE IT AS BLOWER
Fig.1 Turn On/Off
Fig.2 Use the Floor nozzle and use it as a blower
Power Switch
3
2
45
1
4 7
6
-4-
DUST-FULL INDICATOR
DUST BRUSH AND CREVICE TOOL
When red drogue appears in the window
continuously, the dust room could be full or airway could be blocked. You have to deal with it immediately.
1. Dust brush :
For cleaning small room such as chairs,sofa,curtain or describing surface. Insert it into handgrip reelingly.
2. Crevice tool : It is used for cleaning gap, corner etc. When use it, insert it into handgrip
.
Adjust the suction power by slipping the
adjusting button.
The bigger the bear hole is, the lower suction
power is. We suggest that you had better use lower suction power when clean curtain, jalousie or elaborate cloth.
CAUTION
When red drogue appears in the window continuously, the motor will be burnt finally if the vacuum cleaner keeps working.
WARNING
When you hear a whistle or scream, it means the safety-air-inlet-valve operates. In this case, you should check as the above.
Dust-full indicator
Fig.3 Dust-full indicator
Fig.4 To use dust brush and crevice tool and
suction adjusting
SUCTION ADJUSTING
10
3
8
9
TOOL STORAGE space
The back of the dolly has a storage for the
dusting brush and crevice nozzle. Place the attachments on the storage space for handy retrieval.
TO REMOVE DUST
When dust accumulation is excessive, please remove the dust by the following:
1. Turn off the machine and pull out the plug from wall outlet.
2. Remove the hose, and release the clamp
by pulling the lower side of it on each side and take off
the upper case .
3. Take the upper case
and shake the cloth filter for about 20 times to remove the clogging dust
from the filter . When fluff remains excessively on the filter, remove it by a brush.
4. Take off the filter and dispose of the dust in the tank .
5. Change the filter to the tank, and set the upper case on the tank.
Fig. 5 Tool's storage
CAUTION
Do not shake it up and down.
Fig. 6 To remove dust
-5-
14
12
11
11
12
13
14
14
-6-
HANG THE POWER CORD
Refer to Fig.7, wind the power cord and hang
it on the hanger .
STORAGE
Hose, telescopic pipe and floor nozzle can be
stored in an assembled condition to the cleaner. This combination allows you a neat and tidy storage.
Coil the hose around the telescopic pipe
to make it compact and stable and rest the telescopic pipe on the pipe rest as shown in Fig. 8.
16
15
Fig.7 Hang the power cord
Fig.8 Storage
18
17
Loading...
+ 12 hidden pages