LG VTCB564SD Owner's Manual

--3--

If you

Information for your safety

Please read all the following information, which contains important instructions for the safety, use and maintenance of the appliance.

This appliance complies with the following EC Directives: -73/23/EEC, 93/68/EEC-Low Voltage Directive-89/336EEC -EMC Directive.

Never allow children to use the appliance

unsupervised.

Do not use the appliance if the supply cord is damaged or faulty.

If the main lead is damaged, it must be replaced by an approved LG Electronics Service Agent in order to avoid a hazard.

Always switch the vacuum cleaner off before :

?changing the dust bag.

?changing or cleaning the filters.

If no dustbag is inserted, the cover cannot be closed. Please do not use force!

Do not vacuum flammable or explosive

substances(liquids or gases).

Do not vacuum hot ash, embers etc.

sharp objects.

Do not vacuum water or other liquids.

How to Use

Connecting the flexible hose

Push the end of the head(1) on the flexible hose(2) into the attachment point on the vacuum cleaner.

To remove the flexible hose from the vacuum cleaner, press on the button(3) situated on the head, then pull upwards.

Assembling the tubes

(depending on model)

? Plastic (34) or metal (35) tube.

Fit together the two tubes by twisting slightly.

?Telescopic tube(4)

Push spring latch(5) forward. Pull out tube to required length.

Release spring latch to lock. ?Elbow tube(28)

The elbow tube is for uses such as cleaning under the sofa, table and bed easily.

Fit the elbow tube onto the end of the

telescopic tube and the grip handle.

pull the latch(29), the elbow tube can be bent.

If you stretch the elbow tube, it is returned

to its position.

Using the cleaning head and Accessory

Nozzles (depending on model)

Fit the large cleaning head onto the end of the tube.

?The 2-position head(6) is equipped with a pedal(7) which allows you to alter its

position according to the type of floor to be cleaned.

Hard floor position(tiles, parquet floors...). Press on the pedal to lower the brush.

Carpet or rug position. Press on the pedal to lift the brush up.

? Hard Floor Nozzle(30)

Efficient cleaning of hard floors (wood, linoleum, etc.)

? Turbine brush nozzle(31)

Air adjustment(32)

Slide the air control lever to the right for long pile carpet and to the left for short pile carpet.

Cleaning turbine brush nozzle(33)

Press the button on the rear side of the

nozzle to separate the air cover.

Use the dusting brush & crevice tool to vacuum clean the brush and fan.

?Crevice Tool(8)

For vacuuming in those normally inaccess- ible places i.e. reaching cobwebs, or down the side of a sofa!

?Dusting brush(9)

For vacuuming picture frames, furniture outlines, books and other uneven objects.

How to plug in and use

Pull out the supply cord to the desired length and plug into the socket.

Press button (12) to start the vacuum cleaner. To stop it press the button (12) again.

Adjusting the power level

(depending on model)

?The flexible hose handle(13) has a manual air flow regulator(14) which allows you to briefly reduce the suction level.

?Electronic power control(15)

Suction capacity increases smoothly up to MAX.

--4--

away.

and pull.

Remove the bag

? Take hold of the dust bag by the handle and throw it

(25).(depending on model)

filter(24) or

?Electronic power control(26) OFF:Power off MIN:Low power MAX:Full power

Park-System(16)

For short breaks during vacuuming, for example to move a small piece of furniture

or a rug, use the Park system to support the flexible hose and cleaning head.

?Slide the hook attached to the large cleaning tool into the slot on the rear of the appliance.

Storage(17)

When you have switched off and unplugged the appliance, press the button (11) to automatically rewind the cord.

You can move or store your appliance in a vertical position by sliding the hook on the large cleaning head into the clip on the underside of the appliance.

Changing the dust bag

The dustbag needs changing when the cleaner is set to maximum power and the cleaner head is off the floor but the "bag full" indicator window(18) is completely coloured red.

Even if the dustbag does not appear to be full at this stage, it should be changed, as very fine dust can clog up the pores of the dust bag.

?	Turn off the appliance and unplug it.
?	Open the cover by pressing the hook(19)
	and lifting it up until it snaps into place.

Your appliance is equipped with either a paper dust bag (20) or a fabric dust bag

Cleaning the motor filter

The motor filter is situated inside the appliance between the dust bag and the motor. Each time that you change the air outlet filter we advise you to remove the

motor filter(22) and to clean it by tapping to remove the dirt and then replacing it in the vacuum cleaner.

Changing the air outlet filters

Depending on the model you have chosen your appliance is equipped with different types of filters : foam filter or electrostatic

anti-odour charcoal filter or washable HEPA filter(27).

?To change these filters remove the cover of the filter compartment(23) situated at the rear of the appliance.

?The foam filter should be cleaned

regularly by tapping it to remove the dirt.

? The electrostatic filter or anti-odor

charcoal filter should be changed regularly. (approximately every 6 bag changes)

?Wash the washable HEPA filter with water at least once a year.

What to do if your appliance

does not work?

Check that the appliance is correctly plugged in and that the electrical socket is working.

?To refit a new bag push the cardboard support of a new bag into the bag mount

(21)until it will go no further.

If your appliance is fitted with a fabric dust bag follow the same instructions as above.

Empry it and replace it(25). Do not wash it. Note: as the appliance is fitted with a safety device which checks that the bag is in place you cannot close the lid if the bag is not

fitted correctly.

What to do when the suction

performance reduces?

?Stop the appliance and unplug it.

?Check that the tubes, flexible hose and cleaning tool are not blocked.

?Check that the dust bag is not full.Replace

if necessary.

?Check that the air outlet filter is not blocked. Replace if necessary.

--5--

Biztonsagi

informacio

Kerjuk,

hogy

gondosan

olvassa

keszulek

biztonsagos

hasznalatara

karbantartasara

vonatkozo

alabbi

informaciokat.

a keszulek

az alabbi

Europai

Unios

Iranyelveknek

felel

meg:

73/23/EEC,

93/68EEC

Alacsony

Feszultsegi

Iranyelv,

89/336EEC

EMC.

A keszuleket

gyermek kizarolag

felugyelet

mellett hasznalhatja.

hasznalja

keszuleket,

csatlakozozsinor

serult

vagy hibas.

kockazatok

elkerulese

erdekeben

serult

csatlakozozsinort

kizarolag

az LG

Electronics hivatalos

markaszervizenek

kepviseloje

cserelheti

ki.

Mindig kapcsolja ki a keszuleket,

mielott:

kiuriti

a portartalyt;

tisztitja vagy csereli

a szuroket.

Ha a keszulekben

nincs porzsak,

a fedelet

nem lehet lecsukni. Kerjuk,

ne probalja

erovel

lezarni

a fedelet!

hasznalja

keszuleket

gyulekony

vagy

robbanasveszelyes

anyagok

felszivasara

(folyadekok

vagy gazok).

hasznalja

keszuleket

forro

hamu,

parazs,

stb.

tovabba

eles

targyak

felszivasara.

Ne hasznalja

a keszuleket

viz

vagy egyeb

folyadek

felszivasara.

A keszulek

hasznalata

A flexibilis cso

csatlakoztatasa

Nyomja a flexibilis

cso

(2) fejenek

veget

(1)

keszuleken

talalhato

csatlakoztatasi

pontba.

A flexibilis cso

eltavolitasahoz

nyomja meg

a fej

oldalan

talalhato

gombot (3),

majd

huzza

felfele

a fejet.

Csovek

osszeszerelese

(az adott modelltol

fugg)

?Muanyag

(34) vagy fem-

(35) cso.

Enyhe csavarassal

illessze ossze

a ket

csovet.

Teleszkopos

cso (4)

Nyomja a rugos

reteszt elore(5).

Huzza

ki a csovet

a kivant

hosszusagura.

Engedje vissza a rugos

reteszt.

Konyokcso

(28)

konyokcso

hasznalataval

egyszeruen

tisztithatok

az ulogarniturak,

asztal

es agy

alatti teruletek.

Csatlakoztassa

a konyokcsovet

a flexibilis

cso

vegehez

a nyelhez.

rugos

retesz

(29)

meghuzasara

konyokcso

meghajlik.

A konyokcso	eredeti allapotanak visszaallitasahoz
huzza ki azt ujra.


A tisztitofej es			kiegeszito			szivofejek
hasznalata		(modelltol		fuggoen)
Illessze a nagy szivofejet					a cso	vegere.
? A 2-allasu		tisztitofejen(6)				egy pedal		(7)
helyezkedik el, melynek segitsegevel								On a
porszivozni		kivant		feluletnek		megfeleloen
allithatja	be a szivofejet.
Koburkolat,			parketta-allas				A	kefe
leeresztesehez			nyomja meg a pedalt.
Szonyeg vagy szonyegpadlo-allas
Nyomja a pedalt			a masik allasba,				ekkor a
kefe felemelkedik.
? Kemeny	padlo		szivofej		(30)
Kemeny		burkolatu		feluletek			hatekony
tisztitasahoz		(fa, linoleum			stb.)

?Legturbinas kefe (31)

Aramlas-erosseg allitasa(32)


	Hosszu		szalu		szonyegek		tisztitasahoz
	csusztassa			a	levegoaramlas-szabalyozo
	gombot jobbra, rovid szalu						szonyegekhez
	pedig balra.
	A turbinas			kefe tisztitasa(33)
	A	beomlonyilas				takarolapjanak
	levetelehez				nyomja meg a				szivofej
	hatoldalan			levo	gombot.
	A	resszivo		fej	segitsegevel			porszivozza
	ki	a kefet es a ventilatort.
?	Resszivo		fej(8)
	Az olyan		nehezen megkozelitheto						helyek
	tisztitasara			alkalmas,			mint		pl. az
	ulogarnitura			oldala vagy a szuk				sarkokban
	talalhato		pokhalok.
?	Portalanito			kefe(9)
	A portalanito			kefe kepkeretek,				butorvazak,
	konyvek		es	egyeb		egyenetlen feluletek
	porszivozasara				alkalmas.
Csatlakoztatas					a halozati
aramforrasba					es	hasznalat
Huzza ki			a	csatlakozozsinort					a kivant
hosszusagra,				es dugja be a csatlakozodugot
a halozati			aramforrasba.

Nyomja meg a bekapcsologombot (12). A keszulek kikapcsolasahoz ugyanezt a gombot (12) kell megnyomni.

Szivaserosseg			beallitasa
(modelltol fuggoen)
?	A szivaserosseget		a flexibilis		cso	fogojan
	(13)	talalhato	manualis	szivaserosseg-
	allito	szeleppel (14)		lehet	rovid	ideig
	csokkenteni.
?	Elektromos teljesitmenyszabalyozas
	(15)
	A szivaserosseg		a 'MAX' jelzes		fele	haladva

--6--

+ 14 hidden pages