LG VTC3860RTV User Guide
13 |
13 |
12
16 |
17 |
14
15
20
18
19 |
21 |
|
22
24
23
25
--3--
3828Fi2009R
E
Information for your safety
Please read all the following information, which contains important instructions for the safety, the use and the maintenance of the appliance.
This appliance complies with the following EC Directives: -73/23/EEC, 93/68/EEC-Low Voltage Directive-89/336EEC -EMC Directive.
Never allow children to use the appliance unsupervised.
Do not use the appliance If the supply cord is damaged or faulty.
If the mains lead is damaged, it must be replaced by an approved LG Electronics Service Agent in order to avoid a hazard.
Always switch the vaccum before :
?changing the dust bag.
?changing or cleaning the filters.
If no dustbag is inserted, the cover cannot be closed. Please do not use force!
Do not vacuum flammable or explosive substances(liquids or gases).
Do not vacuum hot ash, embers etc. nor sharp objects.
Do not vacuum water or other liquids.
How to Use
Connecting the flexible hose
Push the end of the the flexible
hose(2) into the attachment point on the vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button(3) situated on the head, then pull upwards.
Assembling the tubes
(depending on model)
? Metal tube(4)
Fit together the two tubes by twisting slightly.
?Telescopic tube(5)
Push spring latch(6) forward. Pull out tube to required length.
Release spring latch to lock.
Using the cleaning head and Accessory
Nozzles (depending on model)
Fit the large cleaning head onto the end of
the tube.
?The 2 position head(7) is equipped with a pedal(8) which allows you to alter its posi- tion according to the type of floor to be cleaned.
Hard floor position(tiles, parquet floors...).
Press on the pedal to lower the brush.
Carpet or rug position. Press on the pedal to lift the brush up.
?Crevice Tool(9)
For vacuuming in those normally inaccess- ible places i.e. reaching cobwebs, or down the side of a sofa!
?Dusting brush(10)
For vacuuming picture frames furniture out- lines, books and other uneven objects.
?Upholstery Nozzle(11)
For vacuuming uphostery, mattresses, etc.
The thread collectors help to pick up the threads and fluff.
How to plug in and use
Pull out the supply cord to the desired length
and plug into the socket.
Press button (13) to start the vacuum cleaner. To stop it press the button (13) again.
Adjusting the power level
?If your appliance is equipped with an electronic variable power control(13), you can choose the power appropriated for the task. (depending on model)
?The flexible hose handle(14) has a manual air flow regulator(15) which allows you to briefly reduce the suction level.
Park-System(16)
For short breaks during vacuuming, for example to move a small piece of furniture or a rug, use the Park system to support the
head.
?Slide the hook attached to the large cleaning tool into the slot on the rear of the appliance.
Storage(17)
When you have switched off and unplugged the appliance, press on the handle (12) to automatically rewind the cord.
You can move or store your appliance in a vertical position by sliding the hook on the large cleaning head into the
underside of the appliance.
--4--
3828Fi2009R
Changing the dust bag
The dustbag needs changing when the cleaner is set to maximum power and the cleaner head is off the floor but the "bag full" indicator win- dow(18) is completely coloured red.
Even if the dustbag does not appear to be full at this stage, it should be changed.
It could be that a great deal of very fine dust has clogged up the pores of the dust bag.
? Turn off the appliance and unplug it.
? Open the cover by pressing the hook(19) and lifting it up until it snaps into place.
Your appliance is equipped with either a paper dust bag (20) or a fabric dust bag (22)(depending on model).
?Take hold of the dust bag by the handle and pull.Remove the bag and throw it
away.
?To refit a new bag push the cardboard support of a new bag into the bag mount (21)until it will go no further.
If your appliance is fitted with a fabric dust bag follow the same instructions
as above.
Empty it and replace it(22). Do not wash it. Note: as the appliance is fitted with a safety device which checks that the bag is in place you cannot close the lid if the bag is not fit-
ted correctly.
Cleaning the motor filter
The motor filter is situated inside the ance between the dust bag and the
Each time that you change the air outlet filter we advise the motor fil-
ter(23)and to clean it by tapping to remove the dirt and then replacing it in the vacuum cleaner.
Changing the air outlet filters
Depending on the model you have chosen your appliance is equipped with different types of filters : foam filter or electrostatic fil-
ter or anti-odour charcoal filter(24).
?To change these filters remove the cover of the filter compartment(25) situated at the rear of the appliance.
?The foam filter should be cleaned regularly by tapping it to remove the dirt.
?The electrostatic filter or anti-odor
charcoal filter should be changed regularly. (approximately every 6 bag changes)
E
What to do if your appliance
does not work?
Check that the appliance is correctly plugged in and that the electrical socket is working.
What to do when the suction
performance reduces?
?Stop the appliance and unplug it.
?Check that the tubes, flexible hose and cleaning tool are not blocked.
?Check that the dust bag is not full.Replace
if necessary.
?Check that the air outlet filter is not blocked. Replace if necessary.
--5--
3828Fi2009R
Loading...