LG VR5901L, VMVR5902LVM Owner's Manual
OWNER’S MANUAL
CLEANING ROBOT
VR5901LVM
VR5902LVM
Before using, please carefully read the Safety Precautions pages to allow for
safe operation of the product. After reading the operation manual, please keep
it in an easily accessible location.
*M : Ultra microfiber mop (option)
www.lg.com
FEATURES
Images of the ceiling and floor are obtained from the sensors of the upper and
lower cameras, and through this, the location of Roboking will be confirmed,
therefore, elaborate cleaning can be accomplished for every part of the
room.
As the height of the Roboking is low (90mm), even the underside of a framed
bed or furniture can be cleaned.
The use of the ultra microfiber mop accessory allows finer dust to be collected. (option)
The Roboking also has voice confirmation and instruction that can be easily
understood by the user.
The Roboking has two auto cleaning modes that can be selected by the user.
*Spatial expantion mode, zigzag mode
As the noise levels are at a quiet 60dB, cleaning can be performed at night.
*Less than 60dB
Camera sensor
(upper, lower section)
Please, check
the dust bin
CONTENTS
Safety Precautions
Included with Product
Parts Descriptions
Button Functions
Display Status Information
Before You Start
Overview
1
BEFORE USING
2
HOW TO USE
3
CARE AND MAINTENANCE
28~30
31
How to Install the Home Station
How to Turn the Power Supply On and Off.
How to Start and Stop Cleaning
How to Charge the Battery
Cleaning Modes
Auxiliary Cleaning Modes
Timer Cleaning
Mop Cleaning
(option)
Cleaning the Dust Bin
Cleaning the Dust Bin Filter
Cleaning the Brush
Cleaning the Sensor/Charging Terminal
Cleaning the Side Brush
Cleaning the Ultra Microfiber Mop
(option)
4
ADDITIONAL INFORMATION
5
REFERENCE ITEMS
2~4
5
6~7
8~9
10
11
12
13
14
15
16~17
18
19
20
21
22
23
24
25
26
27
Troubleshooting
Before You Call for Service
Product Specifications
Open Source Software Notice
32
33
2
SAFETY PRECAUTIONS
The purpose of the safety precautions described below is for the user to use the product safely and correctly
to prevent any unexpected risk of injury or damage.
Basic safety precautions
After reading this manual, please keep it in an easily accessible location.
This is the safety alert symbol. This symbol alerts you to potential hazards that can result in property damage and/or serious bodily harm or death.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
WARNING
WARNING
CAUTION
For your safety, do not remove the battery
from the Roboking. If you need to replace the
battery of the Roboking, take it to the nearest
authorized LG Electronics service center or
dealer for assistance.
Make sure the power cord of the home station is not crushed under a heavy object or
damaged by contact with sharp objects.
Never use the Roboking with a battery and/or home station from any
other product than the Roboking.
Failure to follow this warning can cause
electric shock, fire or product failure. If the
power cord is broken, do not plug it in. Take
the product to an LG Electronics Authorised
service repairer.
Do not use the Roboking when
candles or fragile objects are placed
on the floor.
Doing so can cause fire or product failure.
Failure to follow this warning can cause fire
or product failure.
Doing so can cause fire or product failure.
Do not place the home station and
the Roboking near a heating device.
Always use a dedicated outlet.
Doing so can cause product deformation,
fire, or product failure.
If multiple appliances are connected to an
outlet simultaneously, they can generate
enough heat to cause a fire.
Do not force the power plug to bend.
Do not use the power plug when it
has been damaged or loosened.
When pulling out the power plug, always
pull it out by grabbing the plug, not the
cord. When pulling out the power plug, do
not to touch the prongs with your fingers.
Doing so can cause fire or product failure.
Doing so can cause an electric
shock.
3
SAFETY PRECAUTIONS
Do not touch the power plug with
wet hands.
Do not allow children or pets to play
with or rest upon the Roboking at any
time. Do not use the Roboking while
an object is hanging from it.
Doing so can cause electric shock.
Doing so can cause injury or product damage.
Do not operate the Roboking in a room
where a child is sleeping.
Doing so can cause injury or product damage.
Do not insert any part of the body, such as
a hand or foot, below the brush or wheels
of the Roboking while in use.
Doing so can cause injury or product damage.
Do not spray or place inflammable
materials, surfactants, or drinking water in the vicinity of the Roboking.
Doing so can cause fire or product failure.
*
Inflammable materials: gasoline, thinner, etc.
*
Surfactant: detergent, articles for bath, etc.
Turn the power supply off immediately if
any abnormal sound, odor, or smoke is
generated from the Roboking.
Failure to do so can cause fire or product
failure.
Do not operate the Roboking on narrow and high furniture such as a wardrobe, refrigerator, desk, table, etc.
Doing so can cause injury , product failure or
damage which is not covered by the warranty.
Do not leave Children or pets near
the Roboking unsupervised.
Doing so can cause injury or product damage.
Do not expose the Roboking to
cold temperatures (less than -5°C)
for a long period of time.
Cleaning will not proceed smoothly
on carpets with tassels or carpets
thicker than 10 mm.
Use the Roboking indoors only.
The Roboking may bump into furniture such as chair legs, table legs,
thin and long furniture, etc. while
operating.
Doing so can cause product failure.
It may be more convenient to
arrange them before using the
product.
Using it outdoors can cause product failure and irreparable damage
to the unit.
For a quicker and cleaner performance,
place the chairs on top of the table.
The dust collected in the dust bin
can trigger allergies and may contain
harmful insects.
Frequently empty the dust bin and
maintain its cleanliness.
Do not drop the Roboking or subject it to strong impacts.
Doing so can cause injury or product failure
not covered by the warranty.
WARNING
CAUTION
4
SAFETY PRECAUTIONS
In rare cases, the Roboking’s brush
can damage the carpet. If this happens, immediately stop the cleaning
operation.
When a carpet has long tassels, the
tassels can be damaged.
Do not allow the Roboking to sweep
up liquids, blades, thumb tacks,
kindling, etc.
These items can cause product
failure.
Do not let the main frame and charging terminal of the home station come
into contact with metallic objects.
Doing so can cause product failure.
Do not put sharp objects into the
opening of the Roboking’s supersonic sensor.
Doing so can cause product failure.
Do not put water, detergent, etc.
into the Roboking.
Doing so can cause product failure. Do not
put any water or detergent on the Roboking.
If liquids get inside of the Roboking, turn off
the power supply and contact an LG Electronics sales agent or customer care center.
Do not use the Roboking when the
dust bin is completely filled up.
Doing so can cause product failure.
If the floor is wet or has wet spots,
wipe them up before using the
Roboking.
Do not use the Roboking
on a wet surface.
Failure to do so can cause product
failure.
Check the following items before use:
• Remove fragile or unnecessary objects from the room to be cleaned. For example, remove
expensive ceramics and valuables from the floor.
• Do not use this product in the room where a child is sleeping alone. The child can be hurt.
• Confirm whether the battery has sufficient power, and if it is low, recharge it.
• Empty the dust bin after if fills up.
• Close the doors of any room that you do not want the Roboking to enter.
During cleaning, the Roboking may enter another room and continue cleaning.
• Remove any moisture from the floor before cleaning.
• Remove any cables or long strings from the floor.
•
Remove cables, strips, towels, socks, etc. from the floor so they will not get caught by the brush.
• Cleaning will not proceed smoothly on carpets with tassels or carpets thicker than 8 mm
(0.315 in). It may be more convenient to remove or rearrange the position of these rugs or
carpets before using the product.
Please note, this product is not intended for use in any workshop, commercial office, garage or outdoor
environment. It is for normal Domestic internal home use only.
Tip
CAUTION
When the robot cleaner is operating,
it may hit Chair,desk and table legs or
other narrow pieces of furniture.
For quicker and better cleaning, place the
dining chairs on top of the dining table.
5
INCLUDED WITH PRODUCT
▶ Figures can be different from actual objects.
Dust bin filter (spare)
Brush for cleaning Filter
/ Sensor
Mop plate
(option)
Ultra microfiber mop
(2 pieces)
Dry cell for remote controller
(2 units of AAA size)
Quick guide
Operation manual
Remote controller Home station
Roboking
03
02
01
Installing Home sta tion/Checking pow er and battery
Start cleaning
Checking S tate indi cation l amp/batt ery leve l
State indication lamps
Check battery level
Spatial expansion cleaning
Zigzag cleaning
Quick Guide
Cleaning Robot
This guide briefly describes how to use the Roboking. Fo r more detail, please refer
to the user manual.
Tip
Tip
Manual cleaning
Spot cleaning
OWNER’S MANUAL
CLEANING ROBOT
VR5901LVM
VR5902LVM
Bef o re u s i ng, pl eas e c ar eful ly re ad the Saf et y P rec aut ion s p a ges t o a l low f or
sa fe o p er a ti on of t he pr odu ct . A ft er r e adi ng th e ope ra tio n manu al , p lea se k ee p
it in an e as i ly ac ce ssib le lo cat io n.
*M : Ult ra m i cr ofibe r mop ( o pt ion )
www.lg.com
6
PARTS DESCRIPTION - Roboking
▶ Figures can be different from actual objects.
Plan view
Manipulation button
Dust bin cover button
Dust bin cover
State indication lamp
Upper camera sensor
Detecting sensor of home station &
receiving sensor of remote controller
Ultrasonic sensor
Obstacle detecting sensor window
Ventilation port
Cliff detection sensor
Charging terminal
Brush
Side brush
Wheel
Lower camera sensor
Mop plate fixing hook
Battery
Power switch
Front view
Rear view
Bottom view
7
PART DESCRIPTION – HOME STATION / DUST BIN
▶ Figures can be different from actual objects.
Home station
Dust bin
Power lamp
Charging terminal
Reset button
Sponge filter
HEPA filter
Dust bin handle
Dust bin cover
Suction port cover
Dust bin cover opening button
Power cord fixing groove
8
BUTTON FUNCTIONS – Roboking
•
Use the TIMER button to start cleaning after a set amount of time has elapsed.
• The timer can be set from 1 to 12 hours.
•
The timer button only works when the Roboking is attached to the home station.
Always attach Roboking to the home station when setting the timer function
TIMER
HOMING
START/STOP
•
Press the START/STOP button to turn the Roboking on/off or start/stop cleaning.
• Press the START/STOP button while the Roboking is on and it will automatically
start cleaning.
• If the START/STOP button is pressed during automatic cleaning, the Roboking
will stop cleaning.
• Press and hold the START/STOP button for approximately two seconds to turn
off the Roboking.
• This puts the Roboking into the Stand By mode
•
If the button is pressed while in the timer mode, the timer setting will be canceled.
•
Press the HOMING button to move the Roboking to the home station for battery charging.
• When cleaning is complete or the battery is low, the device will automatically
move to the home station to charge the battery even without pressing the
HOMING button.
• If the home station become obstructed, the Roboking may not be able to nd
it's signal and return to it.
9
BUTTON FUNCTIONS – REMOTE CONTROL
Cell by Cell cleaning
The Roboking will clean using the
spatial expansion style.
Zigzag cleaning
Cleaning will be performed
by the Roboking in the zigzag traveling fashion.
• The Roboking’s power supply cannot be turned on with the remote control.
• To turn on the power supply, use START/STOP button on the top of Roboking.
• In order to do spot cleaning, timer cleaning, zigzag cleaning, and spatial expansion cleaning, you
must first stop the operation of the Roboking.
• If the main power switch on the underside of the Roboking is turned off, the remote will not function, and the battery cannot be charged.
• If the main switch on the underside of the Roboking is in the off position, the Status display will
flash and sound when the unit is manually placed onto the home station, to indicate that the
main switch is off.
Tip
Start
Directional button
Spot
The Roboking will start cleaning
The Roboking will move as
desired by the user: to front,
rear, left, and right sides for
cleaning.
Cleaning will concentrate within a
space of about 1 m (3.28 ft).
Charging
Stop
Timer
The Roboking will move to the
home station for charging.
If the Roboking is in operation it
will be stopped. If it has been
set for timer cleaning, the timer
will be canceled.
The timer can be set from 1-12
hours in advance.
Loading...