OWNER’S MANUAL
BEDDING CLEANER
This manual contains important information and instructions for the safe use and maintenance of the bedding cleaner. Please read all of the information on page 3, 4, 5 for your safety. Please keep this manual in an easily accessible place for future reference.
VB-9000WH
VB-9000RF
www.lg.com
Table of contents
Important safety instructions ........................................................................ |
3~5 |
How to use .................................................................................................... |
6~14 |
Bedding Cleaner ............................................................................................................................. |
6 |
Sterilizer Station ............................................................................................................................. |
7 |
Using the Product ........................................................................................................................... |
8 |
When using sterilization station (Depending on Model) ................................................................... |
9 |
Effective cleaning methods according to the cleaning surfaces ................................................... |
10 |
How to Wash Inlet ......................................................................................................................... |
11 |
Emptying Dust bin ......................................................................................................................... |
12 |
Cleaning Dust bin ......................................................................................................................... |
13 |
Care of Dust Filter .......................................................................................................................... |
14 |
Troubleshooting Guide .................................................................................... |
15 |
2
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all instructions before using your vacuum cleaner to prevent the risk of fire, electrical shock, personal injury, or damage when using the vacuum cleaner. This guide does not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. This appliance complies with the following EC Directives :-2006/95/EC Low Voltage Directive -2004/108/EC EMC Directive.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “WARNING” or “CAUTION.” These words mean:
WARNING
CAUTION
WARNING
This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death.
This symbol will alert you to hazards or unsafe practices which could cause bodily injury or property damage.
1.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
2.Children should be supervised to ensure that they do not play with the appliance.
3.If the supply cord is damaged, it must be replaced by LG Electronics Service Agent in order to avoid a hazard.
4.This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
3
IMPORTANT SAFETY INSTRUCTIONS
WARNING
•Use it only on bedding items such as blankets, mattresses, pillows, or cloth sofas.
Do not use this appliance to suck in dust, cement, or any construction debris.
Do not use on leather upholstered surfaces.
It may cause fire and unrepairable product damage.
•This appliance is designed for normal indoor domestic use only. It is not to be used for any office or commercial application.
•No one other than a repair technician shall disassemble or modify the product.
It may cause fire or electrical shock.
•Do not spray combustible materials such as gasoline or solvents, or surfactants such as detergents or bathing goods, or drinks near the cleaner and it's sterilizer station.
It can cause an explosion or fire.
•Do not allow the power cord to be crushed, kinked or cut by heavy objects.
Using a damaged cord or plug could cause fire or electrical shock. When the power cord is damaged, it is dangerous, so please have the cord replaced by an authorised service center.
•Do not let liquid such as water enter the product, and do not use the unit to pick up liquids, sharp pointy objects, or hot embers.
It causes fire or electrical shock.
If water accidently enters the unit, immediately turn off the power switch of the main body, pull out the power plug, and contact LG Electronics Service Agent to avoid hazard.
•If the ELCB, GFCI is triggered when the power is turned on, immediately stop its use and call an Authorised Service Provider.
Failing to do so can cause electric shock.
•Do not insert pins or sharp pointy utensils into or around the machine or its sterilizer station.
There is a risk of electrical shock.
•Do not use the appliance if gas odors can be detected.
Unplug the unit and provide ventilation to avoid possible dangers.
There is a risk of fire or explosion.
•Always remove the power cord from the wall socket from the outlet and ensure that the unit is turned off before doing so.
Failing to do so can cause fire or electrical shock.
•Make sure that the unit is plugged into a wall socket over 10amp and not overloaded.
Overloading of any wall socket can cause fires and product malfunction.
•Do not use the appliance if the power cord or socket is in any way loose or damaged.
It can cause fire or electrical shock.
•Do not operate the appliance with the suction inlet or outlet which are blocked.
It causes deformation of main body or fire by overheating.
•Do not operate the cleaner while dust bin is taken out.
There is a risk of product damage or electrical shock injury.
•Do not place power cord and the product near heating devices.
It can cause deformation of main body, malfunction, or fire.
•Be careful that your fingers do not touch the pins when you pull out the plug from the mains outlet.
It can cause electrical shock.
•Do not allow children or pets to play with the product or use the product as a toy.
It can cause personal injury and damage to the unit.
•Do not handle the plug with wet hands.
It may cause electrical shock.
•Do not clean the inlet with water and use immediately after drying the components first.
It may cause electrical shock and malfunction.
•When you clean the exterior, make sure to pull out the power plug, and do not wash with harsh or abrasive solutions.
It can cause electrical shock and exterior damage.
•Do not place hands into the intake while the appliance is operating. Allow the unit to stop operating and disconnect from the wall socket to avoid any personal injury.
•Do not wash the exterior of inlet or bottom surface with water or detergent. Use only a damp cleaning cloth.
It may damage product or cause electrical shock.
•When the sterilization is in operation, do not attempt to look directly into the UV light.
It may harm your eyes or skin, and may cause skin ailment such as red spots. Should this occur, consult your local physician.
•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
•Do not use the product at a place subject to lots of industrial oil fumes or metal particulates.
Doing so can cause fire or product failure.
•Do not use the product at a place subject to leakage or probable leakage of combustible gases.
It may result in fire or explosion.
4
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
•Do not use this cleaner on anything other than rated voltage.
It may cause fire and unrepairable product damage.
•If the product is not in use for a long period of time, pull out the power plug.
•Static Electricity may be generated at main body during the cleaning.
Cleaner may malfunction due to electrostatic energy, so pull out the power cord and put it back in again.
•Big objects such as socks, stocking, tissues, etc., may block the inlet during the cleaning, so please remove them before starting the cleaning.
This appliance must be used to remove dust only.
•Do not place anything else on the sterilizer station other than this appliance.
Close proximity of magnets or other active electromechanical appliances to the sterilizer station can cause malfunction.
•Do not stop on one spot or use it on the same spot repeatedly for a long time.
The surface may be damaged by the friction and vibration.
•Do not touch the bottom surface with hand or foot while the appliance is in operation.
•Do not operate the appliance without the dust bin and its covers in place. Always ensure the dust bin is cleaned when it reaches its limit or beforehand.
If it is used continuously while dust bin is full, it will cause malfunction and overheating.
•To avoid the risk of fire or electric shock, always grip it from the plug when removing. And never pull on the power cord when removing it from the wall socket.
•If a foreign object is attached to the bottom surface of dust bin, remove it before using the product.
It could compromise the suction motor and cause malfunction and damage.
•Make sure to secure the bottom plate during the cleaning of bedding items. Do not use the appliance on a solid surface or flooring. Doing so could cause damage to both the surface and to the appliance.
•Do not store the appliance or the UV station in an outdoor environment.
•Never use the product for removing toxic gases.
The product may fail, and toxic gases are not removed.
•Use or place the unit on a level area and do not apply force to the unit.
Doing so can cause fire or product failure.
5
How to use
Bedding Cleaner
Handle
Touch Power Switch
Tank Separation Button |
Dust bin |
Cleaning Brush |
Wheel |
Outlet |
Bottom Plate |
Brush |
Vibration Plate |
Inlet |
|
6
How to use
Sterilizer Station
<Depending on Model>
Window |
|
Cord Storage Groove |
|
UV Lamp Status
Indicator Window
UV Lamp
7
How to use
Using the Product
1 |
2 |
beep~
3
beep~
Insert the power cord into |
Touch the power switch to |
When you want to stop the |
the power socket. |
operate an appliance. |
operation. |
|
|
|
•When the power cord is inserted into the power socket, the unit will emit a chime and default to the stand by operation.
•Pressing touch power switch sounds ‘beep,’ starts operation of the product, and lights the indicator.
•Pressing touch power switch again sounds ‘beep,’ stops operation
of the product, and turns off the indicator.
8
How to use
When using sterilization station (Depending on Model)
1 |
2 |
3 |
Sill |
Groove |
Gap
Protrusion
Place the product on the station in such a way that the front side of the product is placed first on the station to allow the gap on the vibration plate of the product to be inserted on the sill of the station.
Place the product on the station in such a way that the rear side of the product to allow the groove on the bottom of the product is caught on the protrusion of the station.
When the product is correctly placed on the sterilizer station, a blue indicator lights on the UV lamp status screen and the UV lamp starts operation for sterilization.
The indicator and the UV lamp are turned off 5 minutes after placing the product on the sterilizer station, and sterilization stops.
9
How to use
Effective cleaning methods according to the cleaning surfaces
Bed Mattress, Bed Cover |
Pillows, Cushions, etc. |
Thin cover |
1 |
2 |
3 |
|
|
|
|
|
|
Bedding: |
Pillows: Large cushion, |
Blankets: Thick cover, |
|||
Mattress, Bed Cover |
normal cushion, pillow |
thin cover, blanket |
|||
|
|
|
|
|
|
•Divide the surface to half, and apply a forward and backward motion to both sides separately.
• For smaller surfaces apply an |
• Apply an even backward |
even forward and backward |
and forward stroke motion. |
motion. |
|
Using tip
Unlike general handy type products, this product applies the correct weight onto the surface for the application it is designed for.
There is no need for additional downward hand pressure when using. Additional downward pressure can cause damage to bedding.
10