LG V-3310D Owner’s Manual

CONTENTS
SAFETY PRECAUTIONS ..........................................................................................................................	3
SERVICING PRECAUTIONS.....................................................................................................................	4
SPECIFICATIONS......................................................................................................................................	4
FEATURES ................................................................................................................................................	4
CONTROL LOCATION ............................................................................................................... ...............	5
CONTROL PANEL.....................................................................................................................................	5
VACUUM POWER ADJUSTMENT............................................................................................................	5
DISASSEMBLY INSTRUCTIONS.......................................................................................................	... 6~7
TROUBLE SHOOTING GUIDE ......................................................................................................... ..	8~10
BLOCK DIAGRAM.............................................................................................................................	11~12
SCHEMATIC DIAGRAM ....................................................................................................................	11~12
PRINTED CIRCUIT BOARD ..............................................................................................................	11~12
EXPLODED VIEW / REPLACEMENT PARTS LIST .........................................................................	13~18
APPENDIX ....................................................................................................................... ..................	19~22
1. THE TYPE OF POWER CORD & PARTS NUMBER ........................................................................	19
2. COLOR & PARTS NUMBER .......................................................................................................	20~21
3. MOTOR & P.C.B ASS'Y PARTS NUMBER .......................................................................................	22

-2-

SAFETY PRECAUTIONS

BEFORE OPERATING THIS VACUUM CLEANER, READ THIS SERVICE MANUAL THOROUGHLY, AND OBSERVE EACH POINT CAREFULLY.

1. Change the paper bag or clean the cloth bag in case the indicator moves toward red.

1)If the dust bag is full, intake power will be reduced.

2)When the dust bag is full of dust, pull out the dust bag from the inside of body base.

2.Filter

1)The filter is composed of a clean filter, a exhaust filter and a paper bag or a cloth bag.

2)Never use the vacuum cleaner without filters. It may harm to the motor.

3)When the cloth bag, the clean filter and the exhaust filter are soiled, wash the filter with neutral cleanser.

NOTE : Re-use of the cloth bag, clean filter and exhaust filter.

?Never wash the filter in a washing machine or in a dishwasher.

?Never use hot water for washing the filter.

?Re-use the filter after drying it completely in the shade. ?Do not dry near fire or direct sun ray.

3. Dust indicator

Dust indicator shows you red color when the filter is full of dust.

Then, change the paper bag with new one or clean the cloth bag.

4. Avoid suction such materials as :

1)Liquid or wet dust :

Clogging the ventilation holes, reduces the intake power significantly and harms the motor.

2)Inflammable liquids such as benzene, alcohol or

solvents.

3)Burning objects such as cigarette butts.

4)Bulky objects such as vinyl, paper etc.

5)Sharp objects such as needles, pins, metal or glass particles etc.

5. Attachments

? Nozzle : for cleaning wooden floor, the room floor and

carpet.

?Crevice Tool : for cleaning any crevice, inside corners of window frames.

However, do not use the crevice tool more than 20 minutes because it may cause harm to the motor.

6.Close supervision is necessary when this vacuum cleaner is used by or near children.

Children's carelessness may cause damage to the cleaner or injure persons.

7.Air exhausted from the vacuum cleaner is normally warm. But if extraordinarily hot air is exhausted, check if the telescopic tube, hose or dust bag is clogged or not.

8.Electric shock could occur if used outdoors or on wet surfaces.

-3-

SERVICING PRECAUTIONS

BEFORE ATTEMPTING TO SERVICE OR ADJUST ANY PART OF THE VACUUM CLEANER, DISCONNECT THE ELECTRICAL POWER SUPPLY CORD FROM THE WALL OUTLET.

1. Motor exchange							2. In case of exchanging other parts, refer to the
1) Separate	the	Body	Cover and	Body	Base	by	exploded view.

unfastening the screws.

2)Disconnect the lead wires.

3)Lift the old motor and replace it with a new one.

SPECIFICATIONS

	? MODEL : V-3310/D/L/T, V-3300/D/L/T/DV				? ATTACHMENTS
	? POWER SOURCE : ON RATING PLATE				HOSE	1EA
	? POWER CONSUMPTION : ON RATING PLATE				ALUMINIUM PIPE ASM ..............................................	2EA
	? POWER CONTROL :				(V-3310L/3300L, TURBO 3300)
	MAIN : SLIDE CONTROL				STEEL PIPE ASM	2EA
	(V-3300/D/L/T/DV, V-3314/D/T, TURBO 3300/R)				(V-3300D/3310D/3314D/3340D/3300DV, TURBO3300,
	PUSH ON/OFF
					V-C3043ND)
	(V-3310/D/L/T, V-3340/D/T, TURBO 3100/B)
					TELESCOPIC PIPE ASM	1EA
	-SUB : VACUUM POWER ADJUSTMENT BY
	SLIDE KNOB				(V-3300T/3310T/3314T/3340T, V-C3345ST)
	? CAPACITY : 3.3 L				PLASTIC PIPE	2EA
	?CORDLENGTH:5m				(V-3300/3310/3314/3340, TURBO3100/B, V-C3333SB)
	? HOSE LENGTH : 1.5 m				NOZZLE ASM..............................................................	1EA
	?NETWEIGHT:4kg				CREVICE TOOL	1EA
	? PACKING WEIGHT : 6.2	kg			CLOTH BAG ASM(OPTION).......................................	1EA
	? NET DIMENSION : 284×433×231		(W×D×H)mm		EXTRA PAPER BAG ASM(PAPER, OPTION) ............	1EA
	? PACKING DIMENSION : 331×517×350			(with plastic,	DUSTING BRUSH(OPTION)......................................	1EA
		steel, and aluminium pipe)			UPHOLSTERY NOZZLE(OPTION)	1EA
		331×582×350 (with telescopic
		pipe)(W×D×H)mm

? This specifications are subject to change according to the buyer's request.

FEATURES

THIS VACUUM CLEANER IS THE MOST MODERN STYLE GOODS, SUITABLE FOR HOUSEHOLD USE AND IT RUNS AFTER A NEW VARIATION IN ORDER TO MEET MODERN LIFE SENSE BY IMPROVING THE DESIGN, THE STRUCTURE AND THE POWER.

1. Strong Suction Power

This vacuum cleaner has a strong suction power because it utilizes a highly efficient and powerful motor.

2. Automatic Cord Winding Mechanism

It is very convenient becasue it winds the cord automatically after operating the unit.

3. Vacuum Power Adjustment

It is very convenient becasue vacuum power varies with cleaning work by moving the slide knob.

4. Convenient Push Button Switch

Using the switch located in the main body, this vacuum cleaner can be operated easily.

5. Excellent Running

Running is execllent by adopting large wheel.(ф190)

8. Miscellaneous

1)The dust indicator shows you red color when to exchange the filter bag or to clean the cloth bag.

2)The washable cloth bag can be used for a long time.

-4-

DISASSEMBLY INSTRUCTIONS

NOTE: Before attempting to service or adjust any part of the from the wall outlet.

?Almost all the parts of this vacuum cleaner can be assembled with a screw driver and each connecting component easily fits each other.

Disassemble one by one referring to the exploded view.

?If possible, don't disassemble except for the necessary parts. It is not necessary to disassemble the parts that are not detailed in the exploded view.

vacuum cleaner, disconnect the electrical power supply cord

3. Body Cover Assembly Replacement

1) Open the filter cover in the direction of arrow and remove the two screws fastening the body base.

1. Filter Cover Assembly Replacement

l) Grasp carrying handle and open filter cover by lifting set hook.

Filter Cover

Set Hook

Carrying

Handle

2) Lift body cover in the direction of the arrow.

2)Push the hinge side by inserting flat screw driver in crack between hinge and body cover.

Hinge

2. Indicator Assembly Replacement

1)	Grasp indicator assembly and push it out in the direction	3) Strip off the lead wires from the push switch.
	of the arrow.
2)	Lift the indicator assembly.

Push Switch

-6-