LG TCC-2515, TCC-2510 User Manual
Take time to read this OWNERÕS MANUAL
thoroughly. Familiarity with installation and
operating procedures will help you obtain the
best performance from your CAR Receiver.
Detachable Front
Panel Car Receiver
OWNERÕS MANUAL
MODEL:TCC-2510/2515
P/N:3828SNC064B
Mounting the unit When removing the unit
from the installation sleeve
If you need to remove the unit from
the installation sleeve, proceed as
follows.
Remove the rear supporter from the
unit.
Remove the front panel from the
unit.
Insert the lever into hole on one
side of the unit, and pull the lever
toward you. Do the same
operation on the other side and
pull out the unit from the
installation sleeve.
3
2
1
Installations
Dashboard
Installation
sleeve
Bend the claws
according to the
thickness
of the dashboard.
A
Precautions:
Be careful not to touch the rear side
panel of the unit when removing the
unit from the installation sleeve,
since it may be hot. On this side the
cooling ribs are located.
The unit is designed to operate only
on 12 volt DC negative ground
electrical system.
When you replace the fuse, be sure
to use a fuse of specified amperage
for each wire as mentioned in
chapter ÒConnectionsÓ. Using a fuse
of higher amperage may cause
serious damage to the unit.
Notes:
Use only the parts included with
the unit to ensure proper
installation. The use of
unauthorized arts can cause
malfunctions.
Consult with your nearest car
audio dealer if installation requires
the drilling of holes or other
modifications of the vehicle.
Do not use the front panel as a
way of gripping the unit during
installation and wiring. The front
panel may come away and the unit
may drop on the floor.
2
Installations
A
A
1
2
Main connector
Connect the main connector to the female
connector on the back of the unit.
Antenna Connection
Insert the plug of the car antenna cable
into the jack at the rear of the unit.
Ground Connection(Black)
Connect the ground lead (black) to a
metal part of the vehicle and secure
it using the screw provided on the
vehicle for this purpose.
If this connection is loose, or if the
cord is connected to something
other than a metal part of the car,
noise or malfunction may result.
Power Supply Lead
(Red)
Connect the red power supply
wire to the 12V + terminal
controlled by the car ignition
switch.
Memory Back-up Lead
(Yellow)
Connect the yellow memory power
supply wire to a 12V + terminal that is
always supplied with power regardless
of the vehicleÕs ignition switch position.
If this connection is made incorrectly or
is not made at all, the unit will not
work
.
Line Out Jacks(Optional)
Connect to the Line-in RCA jacks
of the power amplifier.
Power Antenna
Lead/External Amplifier
Remote Turn-on Lead
Your will find a separate lead, blue
with a male terminal suitable to
many automatic antenna. This lead
is not to be used with nonautomatic antenna. If an automatic
car antenna is used, when
connecting the lead, the antenna
will be automatically extened when
the main switch is turned on. This
can also be used as a remote turnon wire connection for amplifiers
that have a remote sensing lead.
Using this connection will allow
simultaneous turning on/off of the
radio and an external amplifier.
Connections
3
Loading...