LG SH5B USER'S GUIDE
SIMPLE MANUAL
Wireless
Sound Bar
ENGLISH
To view the instructions of advanced features,
visit http://www.lg.com and then download Owner’s Manual.
Some of the content in this manual may differ from your unit.
MODEL
SH5B
*MFL69586948*
www.lg.com
WARNING: This product contains chemicals known to the
State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
FCC Compliance Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
yReorient or relocate the receiving antenna.
yIncrease the separation between the equipment and the
receiver.
yConnect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
yConsult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2)
this device must accept any interference received, including
interference that may cause undesired operation of the
device. Any changes or modications in construction of
this device which are not expressly approved by the party
responsible for compliance could void the user’s authority
to operate the equipment.
FCC RF Radiation Exposure Statement : This equipment
complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other
antenna or transmitter.
This equipment should be installed and operated with
minimum distance 20 cm (7.8 inches) between the
antenna and your body. Users must follow the specic
operating instructions for satisfying RF exposure
compliance.
FCC Radio Frequency Interference Requirements :
High power radars are allocated as primary users of the
5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These
radar stations can cause interference with and/or damage
this device. This device cannot be co-located with any other
transmitter.
Responsible Party :
LG Electronics USA, Inc.
1000 Sylvan Ave
Englewood Cliffs, NJ 07632
Tel: 1-800-243-0000
Front Panel
The buttons are located on the rear panel.
··································Standby / On
·······························Selects Function
·························Adjusts Volume
Rear Panel
OPTICAL IN · · · · · · · · · · · Connect to an Optical device
PORTABLE IN ········ Connect to a Portable device
USB port ················· Connect to a USB device
HDMI IN ········· Connect to HDMI out on a device
HDMI OUT (TV ARC) ·············· Connect to a TV
Subwoofer Connection1
Place the wireless subwoofer near the speaker and
follow steps below.
a Connect the power cord of wireless subwoofer
to the outlet.
b Turn on the main unit. :
The sound bar and wireless subwoofer will be
automatically connected. The subwoofer's
green LED turns on.
Subwoofer Connection Manually
a Reset the Subwoofer
If the green LED on the subwoofer blinks rapidly,
skip this step and go to b
• Press and hold Pairing button for 5 seconds.
• The LED lights up alternately in red and green.
• Unplug the power cord. After the LED turns
off completely, plug in the power cord again.
When the reset is completed, the subwoofer's green
LED blinks rapidly.
b Reset the sound bar
• Adjust volume to minimum. "MIN" appears on
display window.
• Press and hold
remote control for 3 seconds.
"SUB - WF RESET" appears on display
window.
• Turn the sound bar’s power off and on while
the subwoofer’s green LED blinks.
When the connection is completed, you can see the
green LED on the subwoofer.
(Mute) button on the
Keep the sound bar and the subwoofer
away from the following (ex. wireless router,
microwave oven, etc.) over 1m (3.3 ft) to
prevent wireless interference.
>1m
Loading...