|
|
|
|
|
|
|
|
Weight |
31.5 kg. |
SAFETY MEASURE
WARNING
|
Do not treat the power |
|
supply cord with your |
|
wet hand. It may cause |
It may cause electric shock. |
electric shock. |
Be sure to earth the washer to prevent electric shock. To reduce the risk of electric shock, do not install the washer in humid space.
Please read this manual carefully before operating
your set. Retain it for future reference.
MODEL : P1460RWPL
P1460RWP
WP-1695RP
TT11300 |
MFL68505507 |
P/No. : MFL68505507
*For Pump Model Only*
DRAIN HOSE
(TUB)
(Please do not match this figure with model as it may be different from your model. These are schematic diagrams only.)
Water Supply Inlet
soaking
rinsing
Select the desired time for spinning. The maximum limit is 10min, but shall not be continued over 3 cycle. Don't rotate the knob more than prescribed limit.
** After 3 times continuous spinning, please stop spinning more than 1 hour, otherwise the spin motor may be damaged or fire or stop operation.
Wash after separating oiled or dyed clothing.
right
Connecting the earth wire (only for models with two prong plug)
If grounding methods as described are not possible, a seperate circuit-breaker should be employed
and installed by a qualified electrician.
L <= 1 m.
L
Interim spin rinse
150g (5.3oz)
Set the desired |
|
|
|
Woolen |
|
|
water flow and |
|
|
|
|
|
|
|
|
|
|
|
|
|
spin time |
|
|
|
|
|
|
appropriately. |
|
|
|
|
|
|
TABLE 2. GUIDE FOR WASHING |
Amount of |
Amount of |
Amount of |
|||
Type of |
Wash |
Wash |
Water |
|||
Fabric |
Selector Time |
Level |
Laundry (kg) |
Water (Ltr) |
Detergent (gms) |
|
|
GENTLE |
~5 min. |
|
2 |
|
|
|
GENTLE |
~5 min. |
|
|
|
|
NORMAL 5 ~ 10 min.
STRONG 10 ~ 15 min.
If the spinning fail to stop when the spin dryer cover is opened, the brake is out
of order. Immediately stop using the machine and request repair service.
Notes :
• Amount of laundry is a weight of dry laundry. • Detergent is a general synthetic detergent.
CAUTION : Fill in wash to height 20mm above the level you desire. When washing starts water level will automatically come to level you desire.
Water does not enter washer Is the water faucet hooked up?
Is the water faucet frozen?
Is there lint stuck in the plunger valve?
Is the drain pump operated?
Is the drain hose twisted?