30.0 kg.
SAFETY MEASURE
WARNING
|
Do not treat the power |
|
supply cord with your |
|
wet hand. It may cause |
It may cause electric shock. |
electric shock. |
Be sure to earth the washer to prevent electric shock. To reduce the risk of electric shock, do not install the washer in humid space.
Please read this manual carefully before operating
your set. Retain it for future reference.
MODEL : P1400RON
P1400RONL
P700RON
MFL68505521
P/No. : MFL68505521
(TUB)
(Please do not match this figure with model as it may be different from your model. These are schematic diagrams only.)
Water Supply Inlet
Select the desired time for spinning. The maximum limit is 5 min, but shall not be continued over 3 cycle. Don't rotate the knob more than prescribed limit.
** After 3 times continuous spinning, please stop spinning more than 1 hour, otherwise the spin motor may be damaged or fire or stop operation.
Wash after separating oiled or dyed clothing.
right
Connecting the earth wire (only for models with two prong plug)
If grounding methods as described are not possible, a seperate circuit-breaker should be employed
and installed by a qualified electrician.
Interim spin rinse
Set the desired |
|
water flow and |
1 |
5 |
|
spin time |
|
appropriately. |
2 |
4 |
|
|
3 |
|
spin |
If the spinning fail to stop when the spin dryer cover is opened, the brake is out of order. Immediately stop using the machine and request repair service.
|
’t |
on te |
|
D |
ta |
Ro |
|
15 |
3 |
12 |
6 |
|
9 |
|
150g (5.3oz) |
Woolen
TABLE 2. GUIDE FOR WASHING
Type of |
Wash |
Wash |
Water |
Amount of |
Amount of |
Amount of |
||||
Fabric |
Selector Time |
Level |
Laundry (kg) |
Water (Ltr) |
Detergent (gms) |
|||||
|
|
|
|
GENTLE |
~5 min. |
|
2 |
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|||
|
|
|
|
GENTLE |
~5 min. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NORMAL 5 ~ 10 min.
STRONG 10 ~ 15 min.
Notes :
•Amount of laundry is a weight of dry laundry.
•Detergent is a general synthetic detergent.
CAUTION : Fill in wash to height 20mm above the level you desire. When washing starts water level will automatically come to level you desire.
Water does not enter washer Is the water faucet hooked up?
Is the water faucet frozen?
Is there lint stuck in the plunger valve?
Is the end of the drain hose guide located at an exceed height?
Is the drain hose laid down?
Is the drain hose twisted?