LG P1300ROPS Owner’s Manual
P1300ROPS
P/No.:MFL40158310
P/No.:MFL40158310
*
Remark : Avoid using hot water over 60 (Only for Saudi Arabia Country)
(Only for Saudi Arabia Country)
Install the earth wire to prevent short-circuit due to leaking current and electric shock.
It is attached at the back of the washer. Connect it to the metal water pipe.
If the water pipe is made of plastic, it does not have the earth effect.
Do not connect the earth wire to the gas pipe, lightning arrester, telephone connecter, etc..
*Warning - the appliance with two pronged plug must be grounded.
Insert the power plug into the outlet.
Before connecting the power plug, check if the voltage setting of the washer matches the outlet voltage.
If AC outlet with ground terminal is used, grounding is not needed. if not, never forget earthing.
The appliance must be positioned so that the plug is accessible.
This washer is assembled for 220V, but can be changedfrom 220V to 110V ( or 127V).
Check your electrical source and follow the diagram below to convert voltage.
After connecting the earth wire
to the earth copper plate, bury
it at least 70cm deep under
the wet ground.
Connecting to the When installing it in an area
earthing-only outlet.
where earthing is not possible,
purchase a short-circuit
breaker connect it to the outlet.
D
o
n
’
t
r
o
t
a
t
Wash Rinse
e
Drain
Wash Rinse
Normal
Gentle
Strong
D
o
n
’
t
r
o
t
a
t
e
D
e
t
o
a
n
t
’
o
t
r
Drain
Connecting the drain hose
Connect the drain hose to the outlet of the plunger valve located at the back side.
Push the clamp toward the body of the washing machine as shown in the figure.
For Non-Pump Model
Be sure to reroute the hose so that it is not kinked, kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is drained smoothly by placing a base under the
machine or by applying other appropriate mean.
For Pump Model
L <= 1 m.
Off
e
t
a
t
o
r
t
1
’
n
o
D
5
2
4
3
Off
e
t
a
t
o
r
t
3
’
n
o
D
15
12
6
9
Loading...