Please read this manual carefully before operating your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the back cover and quote this
information to your dealer when you require service.
This washing machine is designed and manufactured for
household use only.
P/No.: MFL33753005
CONTENTS
IMPORTANT INSTRUCTIONS---------------------------------------------2
1.Before operating machine read the instruction manual
carefully.
2.Always keep the machine on the floor level.
3.During operation machine should be kept perpendicular to
the slope of the floor to avoid motion.
4.Before operating properly earth the machine, to avoid
electric shock.
5.When not in use take the power cord out from the socket.
6.During spinning and drain check that drain hose is lowered.
7.Before putting clothes in the Wash Tub check the pockets
thoroughly for Coins, Keys and other objects.
8.Transfer the clothes from Wash Tub to Spin Dryer Basket
one by one.
9.In case you notice excessive vibration or abnormal noise
during spinning, immediately open the Spin Dryer Cover
and rearrange the laundry evenly.
10. In case of any doubt contact the nearest service center or
Dealer.
2
SAFETY MEASURE
Manufacturer is not responsible for accidents caused by the user as a result of not
following the user’s guide.
WARNING
In Operation
l Do not insert the
hand inside the spin
dryer basket while
the machine is in
operation.
(Do not let children
climb on the machine
or climb into the tub.
Injury may occur)
Installation Area
l Avoid area exposed
to snow, rain, or
where humidity is
high. It may cause
electric shock.
Switch Area
l Avoid watering on the
switch area. It may
cause electric shock
or fire.
Volatile Material
l Do not use volatile material
s uc h a s B e n ze n e ,
Gasoline, bug killer. Do not
le ave s tro ng al k al i ne
substance such as bleach
inside the tub. Damage on
plastic surface and rubber
parts may occur.
Electric Outlet
l Avo id c on necting
s everal e l ec t r ic
devices to single
outlet. It may cause
fire.
Heat
l Avoid ele ctric heat er,
candle light, cigarette
light, bug smoker, etc.
near the machine. It may
ignite or deform plastic
part
Power Cord
l If the power supply cord is damaged, it must only be replaced by a repair shop
appointed by the manufacturer, because special purpose tools are required.
Hot Water
l Avoid using hot water
over 50°C. It may deform
plastic parts or cause
malfunction.
Power Cord
l Do not treat the power
supply cord with your
wet hand
Installation
l Install the washing machine
on a horizontal support.
Otherwise, it may cause
vibration and noise
l Plug out the power supply
cord, when cleaning or not
using the washing machine
for a long time.
3
PARTS IDENTIFICATION
Control Panel
P10051R1F
WP-9005
WP-820
WP-952
WP-9003
WP-930
WP-953
WP-954S
WP-9004S
WP-951S
WP-1020
WP-1021S
WP-1220
WP-1221S
WP-9005N
WP-10005N
2
4
3
2
4
Off
3
15
6
12
9
Wash Timer
Water Selector
3
4
40
Wash Timer
5
Off
5
10
15
2
3
4
Off
5
40
7
5
10
15
451 2
Off
5
40
10
15
5
4
Wash - Rinse
Drain Selector
6
6
1 2
3
3
2
Drain
6
7
Off
5
4
3
Spin Timer
7
6
67
7
P10051R1F
1
2
7
6
WP-25145SD
3
1.
Hot water inlet
Select this inlet when opting for hot water wash.
2.
Cold Water inlet
Select this inlet when opting cold water wash.
3.
Water Selector
Select "WASH" to supply water for washing and rinsing and
"SPIN" for spin shower rinse.
4.
Wash Timer
Select the desired time for soaking, washing or rinsing.
(Soaking facility is not available in P10051R1F/WP-820/930/
952/953/9003/9005/1020/1220/9005N/10005N)
5.
Wash Selector
Set the Selector to "GENTLE", "NORMAL", "STRONG"
according to kinds and quantity of the laundry.
(Not available in P10051R1F)
6.
Drain Selector
Select "WASH RINSE" for washing and rinsing, and
"DRAIN" to drain the water from the tub.
7.
Spin Timer
Select the desired time for spinning.
Don't rotate the knob more than prescribed limit.
(Please do not match this figure with model as it may be different from your model. These are schematic diagrams only.)
4
PARTS IDENTIFICATION
Accessories
Inlet Hose
WASHING
COVER
OVER FLOW
FILTER
ROTATION
FILTER-C
COLLAR
SCRUBBER
TUB
PULSATOR*
SPIN DRYER
COVER
SAFETY
COVER-2
Safety Cover
PANEL
SPIN DRYER
BASKET
EARTH WIRE
(For models with
two prong plug)
SAFETY
COVER-1
POWER CORD
( Please do not match this figure with model as it may be different from your model. These are schematic diagrams only.)
Wash Timer (Only for WP-9004S/954S/951S/1021S/1221S/25145SD exists with soak option )
The wash timer can be used for SOAK, WASH and RINSE operations.
Following combinations can be selected.
a) Soak + Wash : Select the desired soak time by setting the timer between
Off
5
40
Wash Timer
15~40 min. Then total wash time will be selected soak time + 15 min. of wash
time.
10
b) Wash/Rinse : Any Wash/Rinse time 1~15 min. can be selected by setting the
15
timer between 1~15 min.
Washing will take place for the set period, then machine stops automatically.
Soak Function
a) Soaking is provided for better cleaning of clothes as detergent water
goes to inner pores of clothes resulting dirt removal in better way.
b) Soak time by default will be 25 min. so total time of cycle will be
Soak + Wash time (25 min. + wash time)
c) In soak option, machine operates for 1.5 min. & remains off for 5 min. This
cycle continues for selected soak time.
5
INSTALLATION
Installation area
l Select flat and firm floor.
l Maintain more than 10 cm gap
between the side of drain hose
l Incorrect installation may cause severe noise and
and the wall.
break down.
l The base openings must not be obstructed by
carpeting when the washing machine is installed
on a carpeted floor.
Drain Hose Installation
l Drain Hose is installed at
back side of the washing
machine.
Notes
l Be sure to re-route the hose so that it is not kinked or has sharp bends which will
prevent proper drainage.
l The level of the drain should be slightly lower than the lowest part of the washing
machine in order to ensure proper and complete drainage.
l Use only new hose set provided with the machine.
l Don’t remove Drain Hose.
6
INSTALLATION
Connecting the earth wire
l Install the earth wire to prevent short-circuit due to leaking current and electric shock.
l It is attached at the back of the washer. Connect it to the metal water pipe. If the water
pipe is made of plastic, it does not have the earth effect.
Earth
wire
Gas pipe
1
2
4
3
5
7
6
8
9
0
l Never connect the earth wire to the gas
pipe, lightning arrester, telephone
connector etc.
¬ WARNING : This appliance must be earthed .
Other earthing method
l After connecting the
earth wire to the earth
l Connect to the ear thing-
only outlet.
copper plate, bury it at
least 75 cm deep under
the wet ground.
Earth
wire
Earth
wire
Earth copper plate
75cm
Connecting the power plug
l Insert the power plug into the outlet.
l Before connecting the power plug, check if the
voltage setting of the machine matches the outlet
voltage.
l If AC outlet with ground terminal is used,
grounding is not needed. If not, never forget
earthing (earthing method above).
7
l When installing it in an
area where earthing is
not possible, purchase a
shor t- ci rc ui t breaker
(15mA at operation ,
7.5mA at idle) and
connect it to the outlet.
Short-circuit breaker
Ground terminal
PREPARATION BEFORE WASHING
Preparation
n Connect the water supply hose
to the water supply inlet.
n Set the supply selector lever
to “WASH” for washing and
rinsing to “SPIN” for interim
spin rinse.
l Note : The water Selector
lever should not be placed
near the center (as shown in
Fig. (A) otherwise water
flows to the wash and spin tub
simultaneously).
Before washing
Check the washing
1
instruc-tions labels
on the clothing to be
washed.
Remove any objects from the
2
pockets of the clothing. Object left in
the pockets may damage the
clothin g or wash in g machine
(especially cause clogging of the
drain hose).
(Fig. A)
n Inlet hose
n C on n e c t t he
power cord to the
electrical outlet.
n Drain Hose
l Lay down the drain hose.
Keep the drain hose
fli pp ed d own w h i l e
washing is in process
After separat-
3
ing an oiled or
dyed laundry,
wash.
HOW TO WASH
Set the drain selector to
1
“ WAS H l RIN S E ”
position.
DRAIN SELECTOR
Set the water
2
s e l e ct or t o
“WASH”.
WASH
WATER SELECTOR
Open the water tap and fill water
3
in the wash tub about halfway to
the desired water level.
8
HOW TO WASH
Put the appropr iate amount of
4
detergent and the laundry into the
wash tub. And add water to the
desired water level.
l Refer to TABLES for REFERENCE on
page 12.
Set the desired wash time.
6
Off
40
WASH TIMER
(For WP-954S/WP-9004S/
WP-951S/ WP-1021S/
WP-1221S/WP-25145SD)
l Refer to TABLE for REFERENCE on
5
10
15
WASH TIMER
(For P10051R1F
WP-820/930/9005/9003/
WP-952/10005N/953/
WP-1020/1220/9005N)
page 14 for information on how to
select the appropriate washing time.
Sel e ct the wa s h s ele c tor to
5
"GENTLE", "NORMAL" "STRONG"
according to kinds and quantity of the
laundry.
(Not available in P10051R1F/
WP-9005/952/820)
WASH SELECTOR
l Refer to TABLES for REFERENCE
on page 12.
When washing is finished, select the
7
drain selector to “DRAIN” position and
drain the water out.
DRAIN SELECTOR
8
Spinning in the spin dryer basket :
l Put the laundry into the spin dryer
basket.
l Put the laundry down lightly.
l Place the safety cover horizontally
on the laundry.
l Set the desired spin time with the
spin timer.
9
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.