LG MultiVision SPM42C4-WP, MultiVision SPM42C4-WL Owner's Manual
Owner's Manual
MultiVision Mounting Bracket
Please read the safety information carefully before using the product.
SPM42C4-WL
SPM42C4-WP
P/NO : MFL63640518 (1207-REV00)
MultiVision Mounting Bracket
MultiVision Mounting Bracket-Landscape
SPM42C4-WL
Accessories
4 Guide Spacer 4 Guide Spacer Fixing
Screws
(M6X35mm)
Owner's Manual Wrench
MultiVision Mounting Bracket-Portrait
SPM42C4-WP
4 Bracket Fixing Screws
(M6X80mm)
4 Supporter Connection
Fixing Screws
(M4X8mm)
4 Nuts
Supporter Connection
(SPM42C4-WL Only)
2
Safety Precautions
- If you are a professional installer, please read this manual carefully before installing the product.
- After installing the product according to the manual, ensure that the user also reads the manual carefully.
After reading the manual, please keep it handy for future reference.
The product should be installed by a qualified professional
specified by the retail store.
Installing the product without a qualified professional is dangerous and may
cause injury.
When moving or replacing the product after installation,
contact a qualified installer specified by the retail store.
Installation or movement of the product must be carried out by a skilled
professional. If an unqualified person moves and installs the product, this
may cause safety issues.
Prior to installing the product, arrange the power cable and
signal cable to prevent damage during installation.
Damaged cables may result in a fire, electric shock or damage to the product.
20cm
When sets are built into a wall, the internal temperature may rise to such an extent that it
causes overheating. To prevent the set from overheating, please follow the instructions
below. Overheating may damage the product and in extreme cause smoke of fire.
20cm
Avoid completely sealed installation.
15cm
To ensure adequate ventilation, keep the top, the bottom and the sides of the set a
minimum of 20 cm from the wall. (The back of the set should be a minimum of 15 cm
from the wall.)
If there is not enough space, a separate ventilation device is required.
If you install four or more sets on top of one another, you will need to ensure a ventilator is
used. (for example, a forced draft fan.)
ENGLISH
Warning
The product should be installed where its weight can be
supported.
If the product is installed on a weak surface, the product may fall and cause
injury.
Do not hang on the product or apply shock to the product.
The product may fall and cause injury.
Follow the instructions in the manual to install the product.
If you do not follow the instructions, the product may not be installed properly,
causing serious injury or damage to the product.
Before installing the product, check whether the wall is strong enough to
hold the product.
Installing the product on a wall that cannot hold its weight may cause safety issues.
Do not clean the product with wet towels, and do not use a heater or
humidifier underneath the product.
Moisture permeating into the product, including through steam and heat, may
result in a fire, electric shock or damage to the product.
Make sure that the power cord is removed from the outlet before installing
the product.
Otherwise, it may cause an electric shock or a fire.
Caution
To install or adjust the height of the product, two or more people are
needed.
If you try to install or move the product alone, it may fall and cause injury or damage to
the product.
Keep the product away from sprinklers, sprinkler sensors, high-tension
wires and power sources. Do not install the product in a location where
vibrations or shock impacts are likely to occur.
Wear working gloves when installing the product. Do not use bare hands.
Otherwise, it may cause injury.
3
Transportation method for panel protection
When moving or lifting the monitor, read the
following to prevent the monitor from being
scratched or damaged and for safe transportation
regardless of its type and size.
CAUTION
Avoid touching the screen at all times, as this
may result in damage on the screen.
It is recommended to move the monitor in
the box or packing Cover that the monitor
originally came in.
Before moving or lifting the monitor,
disconnect the power cord and all cables.
Hold the top and bottom of the monitor frame
firmly. Make sure not to hold the transparent
part, speaker, or speaker grill area.
When transporting the monitor, do not expose
the monitor to jolts or excessive vibration.
When transporting the monitor, keep the
monitor upright, never turn the monitor on its
side or tilt towards the left or right.
When transporting the monitor by hand,
hold the monitor as shown in the following
illustration.
When the product is carried upright, 2 persons
carry by holding the bottom and top of the
front, and when it is being put down, put down
carefully for the panel not to be touched.
When the product is carried laid down, 2
persons carry by holding the bottom of the
back, and when it is being put down, put down
carefully for the panel not to be touched.
4
Storage method for panel protection
<Correct method>
ENGLISH
If the product needs to be
set upright, hold both sides
of the product, and tilt backward carefully for the panel
not to touch the floor. (The
setting upright of the set is
possible with the outer frame)
<Incorrect method>
Panel
Panel
When laying down the product, lay a cushion on a flat
floor, and put the product on
it with the panel of the product facing down.
Panel
Cushion
If the product is tilted to the
side of the panel, the bottom
of the panel may be damaged.
NOTE
Handle the product with care. The product may be damaged by shocks.
If the product is tilted to the
edge of the panel, the edge
of the panel may be damaged.
5
Loading...