LG LSW100BG User Manual

OWNER’S MANUAL

Wall Mounting Bracket

Please read this manual carefully before operating
your set and retain it for future reference.

LSW100B
LSW100BG

P/NO : MFL63640503 (1112-REV07)

www.lg.com

* 1 Year Warranty (Europe : 2 Year)
If material or workmanship proves defective under normal use, during the warranty period, please
contact the retailer where you purchased it. This warranty is good only to the original purchaser of

the product and effective only in the local area.

Component

Wallmount anchor

4 units

* Due to the shallow clearance between the display and the wall, the LSW100B Wall Mounts

may require the use of the included angled adapters.

* Note that the included angle adapters may block other connections on the back of the TV.
* Make sure the connectors on the cables connected to the display do not press against the wall.

Wall mount screw

8 units

<Component cable with angled connectors>

User manual Set protection cushion

PVC Washer

4 units

4 units

<HDMI angle adapter>

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.

Set screw
M4 X 10mm 4 units
M4 X 14mm 4 units

Warning

This wall mount should be installed by a trained and
experienced installer designated by the retailer.

Having the product installed by a non-specialized installer is
very dangerous and can cause damage or injury.

Use a trained and experienced installer to move or
replace the wall mount, if needed.

Installation requires special techniques and moving or installing
the product on your own can cause serious safety issues.

When installing the wall mount, never hang the
power or signal cable on the rear side the TV.

The cord can be damaged and cause a fire, an electric
shock or damage to the product.

2

Do not install the product where the weight cannot be
supported.

If the strength of the location where the wall mount is installed
is not strong enough, it can fall off and cause an injury.

After installing the wall mount, do not hang on the
product or apply severe impact to the product.

The product can fall off and cause injury.

Install the product according to the directions in the
user manual.

If the product is not installed based on the directions in
the user manual, it can cause a serious injury or damage
to the product.

Caution

ENGLISH

When installing the product or adjusting the height of
the product after installing, always do so with 2 people.

Working alone can cause the product to fall off and result in
injury or damage to the product.

During the installation, check the type of wall
material and use the sealed anchor and screw if the
conditions comply.

If you do not use the designated anchor or screw, the
mount may not be able to withstand the weight of
the product and cause a safety issue.

Do not wipe the product with a wet towel and do not use any
heater or humidifier below where the product is installed.

If water flows into the product or if moisture and heat are applied to the
product, it can cause a fire, an electric shock or problem to the product.

Unplug the power cord from the power outlet before
installing the product.

If you install the product with the power cord plugged, it can
cause an electric shock or a fire.

Do not allow the video connectors connected to the
display to press against the wall. Use the included
right-angle adapters if needed.

Only use attachments/accessories specified by the
manufacturer.

Before installation

When drilling holes in the wall, always use a drill bit
and drill of designated diameter. Also follow the
designated directions for the depth of the hole.

If the product is installed without following the designated
method, the product may be unstable and cause a safety
issue.

Do not install the product near any object that may
cause vibration.

Do not install the product near any high voltage power
cable or power source.

Do not install the product with bare hands. Always
wear proper work gloves.

It can cause an injury.

* Do not use the product for purposes other than mounting a display on the wall.
* When installing/using the wall mount, be cautious of product damage and avoid accidents.
* If you have not fully read and understood the installation manual, do not install the product and contact
the dealer to have a specialized installer install the product for you.
* Even if you are not a specialized installer, it is advantageous to have experience in mechanical or

construction field in completely understanding this manual and installing the product.
* This product is designed to be mounted to walls that use standard intervals between the studs.
* Install the screw to attach the wall mount so that it can be assembled at the center from both ends of
the studs.
Use of stud finder, a separate device, is recommended.
* Install the product only on a vertical wall.
The manufacturer is not responsible for issue from installing the product on severely wall or on the
ceiling.
* Keep the included accessories out of reach of babies or children as it can cause safety issues including
suffocation from swallowing the parts.
* Make sure screws are tight against the wall, but do not overtighten.
* Be careful not to install a TV that exceeds the weight restrictions of the wall mount.
* Be careful with the tools used during installation to prevent accidents or damage.

3