Room Air Conditioner
OWNER'S MANUAL
•Please read carefully and thoroughly this manual before operating this unit.
•Contact the authorized SVC man for repair or maintenance of this unit.
•Contact the installer for installation of this unit.
•The appliance is not intended for use by young children or infirm persons without supervision.
•Young children should be supervised to ensure that they do not play with the appliance.
MODELS: LS-C076_Series LS-H076_Series
LS-C096_Series LS-H096_Series
LS-C126_Series LS-H126_Series
LS-C186_Series LS-H186_Series
LS-C246_Series LS-H246_Series
AS-C076_Series AS-H076_Series
AS-C096_Series AS-H096_Series
AS-C126_Series AS-H126_Series
AS-C186_Series AS-H186_Series
AS-C246_Series AS-H246_Series
LS-Q076_Series LS-J076_Series
LS-Q096_Series LS-J096_Series
LS-R126_Series LS-L126_Series
LS-T186_Series LS-K186_Series
LS-T246_Series LS-K246_Series
S07_Series S09_Series
S12_Series S18_Series
S24_Series
Prior to installation, this air-conditioning
unit must be submitted for approval by the utility service which provides electricity (EN 61000-3 Norm).
<![endif]>GREEK DEUTSCH FRANÇAIS ESPAÑOL ITALIANO ENGLISH
<![if ! IE]> <![endif]>Precautions |
Safety Precautions |
|
|
|
|
||
|
Warning ................................ |
2 |
|
|
Caution ................................. |
3 |
|
<![if ! IE]> <![endif]>Safety |
Operating Instructions |
||
Preparation before operation |
..4 |
||
Remote Control Features ..... |
5 |
||
|
Operation Mode Selection ...... |
6 |
|
<![if ! IE]> <![endif]>Instructions |
Additional features.............. |
13 |
|
Care and Maintenance |
|||
|
|||
|
Care and Maintenance ....... |
17 |
|
<![if ! IE]> <![endif]>Operating |
Operation Tips .................... |
19 |
|
Troubleshooting tips |
|||
|
|||
|
Before You |
|
|
<![if ! IE]> <![endif]>Maintenance |
Call For Service ............... |
20 |
|
Plug in the power plug |
|
||
|
properly. |
|
|
|
• Otherwise, it will cause electric shock |
||
|
or fire due to heat generation or |
||
|
electric shock. |
|
|
<![if ! IE]> <![endif]>and |
Do not modify power cord length or |
||
|
|||
<![if ! IE]> <![endif]>Care |
share the outlet with other appliances. |
||
• It will cause electric shock or fire due |
|||
|
|||
|
to heat generation. |
|
|
<![if ! IE]> <![endif]>Tips |
Always perform grounding work. |
||
• No grounding may cause electric |
|||
|
|||
<![if ! IE]> <![endif]>Troubleshooting |
shock. |
|
|
• It may cause fire. |
|
||
|
Unplug the unit if strange |
||
|
sounds, smell, or smoke |
||
|
comes from it. |
|
|
|
• It may cause fire and electric |
||
|
shock accident. |
|
|
|
Keep firearms away. |
|
|
2 |
|
|
Safety precautions
To prevent injury and property damage, follow these instructions.
Incorrect operation due to ignoring instructions will cause harm or damage, the seriousness of which is indicated by the following symbols.
WARNING
This symbol shows the possibility of death or serious injury.
CAUTION
This symbol indicates the possibility of injury or damage to property.
■ The following items are classified by these symblos.
WARNINGI
Do not operate or stop the unit by inserting or pulling out the power plug.
•It will cause electric shock or fire due to heat generation.
Do not operate with wet hands or in damp environment.
• It may cause electric shock.
Do not allow water to run into electric parts.
•It may cause failure of machine or electric shock.
Do not use the socket if it is loose or damaged.
•It may cause fire and electric shock.
Do not use the power cord close to the heating tools.
• It may cause fire and electric shock.
Never Do This
Always Do This
Do not damage or use an unspecified power cord.
•It will cause electric shock or fire.
•In the supply cord is damaged, it mut be replaced by the manufacturer or its service agent or a similarly quallfied person in order to avoid a hazard. (Y Attachment)
Do not direct airflow at room occupants only.
• This could damage your health.
Always install air leakage breaker and a dedicated switching board.
•No installation may cause fire and electric shock accident.
Do not open the entrance during operation.
• It may cause electric shock.
Do not use the power cord near flammable gas or combustibles, such as gasoline, benzene, thinner, etc.
• It may cause an explosion or fire.
WARNINGI
Ventilate before operating air conditioner |
Do not disassemble or modify products |
when gas goes out. |
randomly. |
• It may cause explosion, fire and, burn. |
• It may cause failure and electric shock. |
CAUTIONI
Never touch the metal parts of the unit when removing the filter.
•They are sharp and may cause injury.
When cleaning the unit, first make sure the power and breaker are turned off.
Do not clean the air |
Ventilate well when used |
conditioner with water. |
together with a stove, etc. |
•Water may enter the unit and degrade the insulation. It may cause an electric shock.
Do not put a pet or house plant where it will be exposed to direct air flow.
• An oxygen shortage may occur.
Do not use appliance for special purpose such as animals or vegetables, precision machine, or conservation of art articles.
•Since the fan rotates at high speed during operation, it may cause injury.
Stop operation and close the window in storm or hurricane.
•This could injure the pet or plant.
Hold the plug by the head of the power plug when taking it out.
•It may cause damage of animals or vegetables or loss of property.
Turn off the main power switch when not using it for a long time.
•Operation with windows opened may cause wetting of indoor and soaking of household furniture.
Do not place obstacles around the absorption inlet or instead of blowing-out inlet.
•It may cause electric shock and damage.
Ensure that an installation console of the outdoor appliance is not damaged due to the use for a long time.
•It may cause failure of product or fire.
Always insert the filters securely. Clean it once every two weeks.
• It may cause failure of appliance |
• If leaving appliance damaged, |
• Operation without filters may |
|
or accident. |
there is concern of damage due |
cause failure. |
|
|
to the falling of product. |
|
|
Do not use strong detergent |
Do not place heavy object on the |
Do not drink water drained |
|
such as wax or thinner but |
power cord and take care so that |
from air conditioner. |
|
use a soft cloth. |
the cord should not be pressed. |
|
|
• Appearance may be deteriorated |
• There is danger of fire or electric |
• It contains contaminants and will |
|
due to change of product color or |
shock. |
|
make you sick. |
scratching of its surface. |
|
|
|
Use caution when unpacking and installing. |
If water enters the product, turn the power |
||
Sharp edges could cause injury. |
switch of the main body of appliance off. After |
||
|
|
taking the power-plug out from the socket, |
|
|
|
contact with the service center. |
<![endif]>Tips Troubleshooting Maintenance and Care Instructions Operating PrecautionsENGLISHSafety
3
<![endif]>Safety Precautions
Preparation before operation
How to Insert the Batteries
Remove the battery cover by pulling it according to the arrow direction.
Insert new batteries making sure that the (+) and (-) of battery are installed correctly.
Reattach the cover by sliding it back into position.
<![if ! IE]> <![endif]>Operating Instructions |
<![endif]>Maintenanceand
<![if ! IE]><![endif]>Care
<![if ! IE]><![endif]>TipsTroubleshooting
4
NOTES:
• Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries.
Storage and Tips For Using the Remote Control
• The remote control may be stored by mounting it |
• To operate the room air conditioner, aim the |
||||
on a wall. |
remote control at the signal receptor. |
||||
|
|
|
|
|
|
Signal Receptor
Receives the signals from the remote control.(Signal receiving sound: two short beeps or one long beep.)
Operation Indication Lamps
On/Off
Sleep Mode
Timer
Defrost Mode
OUT OUTDOOR UNIT DOOR OPERATION
Power Display (Inverter only)
:Lights up during the system operation.
:Lights up during Sleep Mode Auto operation.
:Lights up during Timer operation.
:Lights up during Defrost Mode or Hot Start operation (Heat pump model only)
:Lights up during outdoor unit operation. (Cooling model only)
:Indicates the setting temperature and the operating frequency of compressor.(5 steps)
Signal receptor
Operation indication lamps
Plasma |
: The function illustrates its dynamic mode by using a multiple lighting system. |
About the remote control on the system
The remote control transmits the signals to the system.
Features of the Remote ControlDoor Opened
Signal transmitter
5 |
1 |
|
6 |
|
|
|
3 |
|
4 |
|
|
2 |
10 |
|
CANCEL |
||
|
||
7 |
9 |
|
ON |
OFF SET |
|
11 |
12 |
|
8 |
||
|
||
13 |
14 |
|
15 |
16 |
Flip-up door (opened)
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model(), Heat Pump Model()
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps low, medium, high and CHAOS.
JET COOL
Used to start or stop the speed cooling. (Speed cooling operates super high fan speed in cooling mode.)
CHAOS SWING BUTTON
Used to stop or start louver movement and set the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation. (See page 13)
TIME SETTING BUTTONS
Used to adjust the time. (See page 13)
TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to cancel the Timer operation. (See page 13)
SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation. (See page 13)
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating. (See page 14)
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
PLASMA(OPTIONAL)
Used to start or stop the plasma-purification function. (See page 11)
HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON
(NOT ON ALL MODELS)
Used to set the desired horizontal airflow direction. (See page 14)
RESET BUTTON
Used prior to resetting time or after replacing batteries.
2nd F Button
Used prior to using modes printed in blue at the bottom of buttons. (See page 12)
<![endif]>Tips Troubleshooting Maintenance and Care Instructions Operating PrecautionsENGLISHSafety
5
<![endif]>Safety Precautions
How to use the Operation Mode Selection button
Cooling Operation
1 |
Press the Start/Stop button. |
The unit will respond with |
a beep.
<![if ! IE]> <![endif]>Operating Instructions |
<![endif]>Maintenanceand
<![if ! IE]><![endif]>Care
<![if ! IE]><![endif]>TipsTroubleshooting
6
2 |
Open the door on the remote control. To select Cooling |
Operation, press the Operation Mode Selection button. |
Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Cooling |
Auto |
Healthy |
Heating |
|
|
Dehumidification |
(Heat pump model only) |
3 Close the door on the remote control. Set the temperature lower than the room temperature. The temperature can be set within a range of 18°C~30°C in 1°C increments.
ON |
To raise the temperature |
|
|
|
To lower the temperature |
|
Set the fan speed again with the door |
|
4 of the remote control still closed. You |
|
can select the fan speed in four steps- |
|
low, medium, high and CHAOS. |
|
Each time the button is pressed, the |
|
fan speed mode is shifted. |
Natural wind by the CHAOS logic
For more fresh feeling than other fan speed, press the Indoor Fan Speed Selector and set to
CHAOS mode. In this mode, the wind blows like natural breeze by automatically changing fan speed according to the CHAOS logic.
Auto Operation
1 |
Press the Start/Stop button. |
The unit will respond with |
a beep.
<![endif]>PrecautionsENGLISHSafety
2 |
Open the door on the remote control. To select Auto |
Operation, press the Operation Mode Selection button. |
Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Cooling |
Auto |
Healthy |
Heating |
|
|
Dehumidification |
(Heat pump model only) |
ON |
The temperature and fan speed are automatically set by the |
|
3 electronic controls based on the actual room temperature. If |
||
|
||
|
you want to change the set temperature, press the Room |
|
|
Temperature Setting buttons. The cooler or warmer you feel, |
|
|
the more times (up to two times) you should press the button. |
|
|
The set temperature will be changed automatically. |
|
|
To raise the temperature |
|
|
To lower the temperature |
During Auto Operation:
You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
If the system is not operating as desired, manually switch to another mode. The system will not automatically switch from the cooling mode to the heating mode, or from heating mode to cooling mode, it must be done by manually resetting.
During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and down automatically. If you want to stop auto-swing, press the chaos swing button again.
<![endif]>Tips Troubleshooting Maintenance and Care Instructions Operating
7